SearcharxivSearch

arXiv · 1611.07364

Stellar laboratories. VIII. New Zr IV - VII, Xe IV - V, and Xe VII oscillator strengths and the Al, Zr, and Xe abundances in the hot white dwarfs G191-B2B and RE0503-289

Abstract

For the spectral analysis of high-resolution and high-signal-to-noise spectra of hot stars, state-of-the-art non-local thermodynamic equilibrium (NLTE) model atmospheres are mandatory. These are strongly dependent on the reliability of the atomic data that is used for their calculation. To search for Zr and Xe lines in the ultraviolet (UV) spectra of G191-B2B and RE0503-289, new Zr IV-VII, Xe IV-V, and Xe VIII oscillator strengths were calculated. This allows for the first time, determination of the Zr abundance in white dwarf (WD) stars and improvement of the Xe abundance determinations. We calculated Zr IV-VII, Xe IV-V, and Xe VIII oscillator strengths to consider radiative and collisional bound-bound transitions of Zr and Xe in our NLTE stellar-atmosphere models for the analysis of their lines exhibited in UV observations of the hot WDs G191-B2B and RE0503-289. We identified one new Zr IV, 14 new Zr V, and ten new Zr VI lines in the spectrum of RE0503-289. Zr was detected for the first time in a WD. We measured a Zr abundance of -3.5 +/- 0.2 (logarithmic mass fraction, approx. 11 500 times solar). We dentified five new Xe VI lines and determined a Xe abundance of -3.9 +/- 0.2 (approx. 7500 times solar). We determined a preliminary photospheric Al abundance of -4.3 +/- 0.2 (solar) in RE0503-289. In the spectra of G191-B2B, no Zr line was identified. The strongest Zr IV line (1598.948 A) in our model gave an upper limit of -5.6 +/- 0.3 which is about 100 times solar. No Xe line was identified in the UV spectrum of G191-B2B and we confirmed the previously determined upper limit of -6.8 +/- 0.3 (ten times solar). Precise measurements and calculations of atomic data are a prerequisite for advanced NLTE stellar-atmosphere modeling. Observed Zr IV - VI and Xe VI - VII line profiles in the UV spectrum of RE0503-289 were simultaneously well reproduced.

Explore related subjects

Keep this discovery

BibTeXRIS

T. Rauch, S. Gamrath, P. Quinet, L. Loebling, D. Hoyer, K. Werner, J. W. Kruk, M. Demleitner. 2016-11-21. Stellar laboratories. VIII. New Zr IV - VII, Xe IV - V, and Xe VII oscillator strengths and the Al, Zr, and Xe abundances in the hot white dwarfs G191-B2B and RE0503-289. https://doi.org/10.1051/0004-6361%2F201629794

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Delay-engineered dynamical phases in a programmable non-Markovian spin oscillator

Non-Markovian dynamics offer a new route towards engineering non-equilibrium matter, where memory and feedback act as programmable resources for controlling order in time. Here we report the realization of a non-Markovian spin oscillator in a hot vapour $^{129}$Xe-Cs co-magnetometer with programmable feedback delay and gain. By tuning these parameters, we observe a hierarchy of dynamical phases, including time-crystalline response, nonlinear bifurcations, and frequency-comb formation. The measured spectra and phase boundaries are captured by linear stability analysis of delayed Bloch equations, revealing these phenomena as different manifestations of the same memory-induced instability structure. These results establish time-delayed feedback as a powerful strategy for controlling non-equilibrium phases, enabling quantum sensing, frequency referencing, and synchronization within a single spin-based platform.

physics.atom-ph

Non-stick vacuum wall collisions with a laser-coolable molecule

Molecular species that are suitable for direct laser cooling are typically considered lost or destroyed if they collide with an ambient temperature vacuum wall. Here, we study surface collisions with aluminum monofluoride (AlF), a laser-coolable molecule that survives this process with unusually high probability. We detect the outgoing AlF molecules from a single wall collision via Doppler-sensitive laser-induced fluorescence spectroscopy, using incoming supersonic (pulsed) and thermochemical (continuous) molecular beams. The angular, velocity and rovibrational level distributions of the outgoing molecules show near-complete thermalisation to the wall in a single collision event. We determine an upper limit to the surface residence time of about 5$~\mu$s, and by monitoring the decay in density of pulses of molecules loaded into a small storage volume, we deduce the surface sticking probability for different materials. For a siloxane-coated metallic surface, the sticking probability of AlF is about 0.015, allowing us to accumulate molecules from the thermochemical source into an ambient temperature storage vessel at densities near $10^{8}~$cm$^{-3}$. This provides a route to compact, portable traps for neutral molecules.

physics.atom-ph

Kinetic modeling of molecular beam formation in a cryogenic buffer-gas cell

Cryogenic buffer-gas cells are widely used to produce cold molecular beams, but the microscopic dynamics governing beam formation remain challenging to model. Here we present fully kinetic simulations of a cryogenic buffer-gas cell using the Direct Simulation Monte Carlo method implemented in the PICLas framework, treating the buffer gas and ablated molecules within a single unified model. We capture characteristic features of cryogenic buffer-gas sources, including plume cooling, directed transport toward the aperture, and the formation of a slow molecular beam, while also resolving energy transfer from the hot ablation plume to the helium buffer gas that is inaccessible to existing approaches relying on the background-gas approximation. Our results demonstrate that fully kinetic simulations can provide detailed insights into buffer-gas cell dynamics and open a route toward a systematic optimization of such sources.

physics.atom-ph