Searcharxiv⌕ Search
Home/Archive/arXiv

arXiv · 2207.07358

Parallel measurements of vibrational modes in a few-layer graphene nanomechanical resonator using software-defined radio dongles

Heng Lu·Chen Yang·Ye Tian·Jue Wang·Ce Zhang·Yubin Zhang·FengNan Chen·Ying Yan·Joel Moser
View original source ↗Read source document ↗Export metadata ↓

Abstract

Software-defined radio dongles are small and inexpensive receivers well known to amateur radio enthusiasts. When connected to an antenna, they enable monitoring of a wide range of the radio spectrum by conditioning the input signal and transferring a downconverted version of it to a personal computer for software processing. Here, we employ a composite of two such dongles, interfaced with codes written in MATLAB and GNU Radio, as a measuring instrument to study the flexural vibrations of a few-layer graphene nanomechanical resonator. Instead of an antenna, we connect the dongles to the split output of a photodetector used to detect vibrations optically. We first perform a quantitative analysis of the dynamics of the first vibrational mode. We then measure the response of the first two vibrational modes in parallel. To illustrate our technique, we detect changes in the vibrational amplitude of both modes induced by periodic strain modulation with a delay of $\approx1$ ms between measurements. Last, we show that our software-based instrument can be employed to demodulate human voice encoded in the vibrations of our resonator. For parallel measurements of several frequency channels, and provided that the input signal is not too weak, our composite system may offer an alternative to the use of multiple lock-in amplifiers or multiple spectrum analyzers, with the distinct advantage of being cost-effective per frequency channel.

Explore related subjects

cond-mat.mes-hall

Keep this discovery

BibTeXRIS

Heng Lu, Chen Yang, Ye Tian, Jue Wang, Ce Zhang, Yubin Zhang, FengNan Chen, Ying Yan, Joel Moser. 2022-07-15. Parallel measurements of vibrational modes in a few-layer graphene nanomechanical resonator using software-defined radio dongles. https://doi.org/10.1109/access.2022.3188391

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Emergence of spin-orbit coupling among spin, atomic orbital, and Bloch dynamics in Janus double-transition-metal MXenes

We found a spin-orbit coupling to cause a simultaneous correlation among three degrees of freedom, the electronic spin, orbital, and Bloch dynamics in an investigation into the electronic structure of Janus double-transition-metal MXenes, Mo$_2$HfC$_2$OS and W$_2$HfC$_2$OS. In this paper, it is also revealed that the spin-orbit coupling causes a staggered spin configuration with a trigonal pattern around the $\Gamma$ point near the insulating gap. We developed a reduced Hamiltonian describing the electronic states and show that the spin-orbit coupling cannot be equated with conventional forms for a single electron in solids, LS, Rashba, and Dresselhaus couplings, even in the approximation under the low-energy and small wave number condition. Because of the intrinsic shape of the conduction band, a trigonally alternating spin-momentum locking emerges with the spin axis perpendicular to the layer plane. The theoretical analysis shows that these Janus materials can provide a platform for exploring the spin-related phenomena due to the trigonal spin-momentum locking other than Rashba and Dresselhaus types.

cond-mat.mes-hall↗
arXiv2026

A substrate booster for P-type 2D ferromagnetic semiconductor

Spin transistors with its both charge and spin properties tuned via electrostatic gating are believed capable for widespread use, which however have proven challenging due to the extreme rareness of their physical base -- magnetic semiconductors. The latter are limited within very few systems including diluted magnetic semiconductors (DMS) and two-dimensional ferromagnetic semiconductors (2D-FMS), and known to suffer from inadequate gate-tunability of their electric and/or magnetic properties. Here, we show a substrate engineering paradigm by interfacing few-layered Cr$_{2}$Ge$_{2}$Te$_{6}$ (FL-CGT) with an antiferromagnetic insulator CrOCl. Owing to the subtle interfacial charge transfer couplings, CGT can be drastically turned from an ambipolar semiconductor into a high performance P-type semiconductor. When cooled below the Curie temperature, the ON-OFF ratio in such substrate-boosted FMS field-effect transistor (FET) reaches 10$^{5}$ with its coercive field $H_{c}$ of magnetic hysteresis loop tunable by a factor of more than 200$\%$, enabling {gate-assisted magnetic switching in the prototype semiconducting spin transistor architecture}. A crossover from critical power-law scaling to a dual power-law behaviour under heavy hole doping was further observed. Our findings {signify} an efficient interfacial charge transfer and electrically modulated magnetic anisotropy energy supported by calculations. This high performance P-type FMS-FET system suggests that active substrate-boosting paradigm might be a powerful path for the investigation of future gate-tunable spintronic devices.

cond-mat.mes-hall↗
arXiv2026

In-plane magnetic field control of anomalous Hall response enabled by magnetic anisotropy engineering

Engineering magnetic anisotropy provides a powerful route to control magnetization orientation and unlock emerging functionalities in opto-spintronic and current-driven devices. Beyond its role in magnetization reversal, the effective anisotropy can strongly influence the magnetotransport response, offering an additional degree of freedom to tune new device functionalities. In this work, we report a magnetotransport study of a ferrimagnetic [Tb/Co]$_{\times 5}$ multilayer grown with a Tb thickness gradient, whose wedge-shaped tilts the uniaxial anisotropy axis slightly away from the film normal. Anomalous Hall resistivity measurements from 80 K to 300 K reveal a spin reorientation transition, while the angular dependence of the magnetotransport responses exposes the crucial role of the tilted anisotropy. A simplified macrospin model reproduces the full angular response across the transition and shows that the observed anomalous Hall effect when the in-plane magnetic field is applied originates from the tilt of the uniaxial anisotropy axis, which supplies a built-in symmetry-breaking mechanism, enabling in-plane field control over the out-of-plane anomalous Hall response, sign included. These findings establish tilted magnetic anisotropy as a promising route toward Hall effect-based sensor applications and highlight Tb/Co multilayers as a versatile platform for anisotropy-engineered spintronic devices.

cond-mat.mes-hall↗