Modeling of high-pressure transient gas-liquid flow in M-shaped jumpers of subsea gas production systems

Abstract

Two-phase flow with low liquid loads is common in high-pressure natural gas offshore gathering and transmission pipelines. During gas production slowdowns or shutdowns, an accumulation of liquid in the lower sections of subsea pipelines may occur. This phenomenon is observed in jumpers that connect different units in deep-water subsea gas production facilities. The displacement of the accumulated liquid during production ramp-up induces temporal variations in pressure drop across the jumper and forces on its elbows, resulting in flow-induced vibrations (FIV) that pose potential risks to the structural integrity of the jumper. To bridge the gap between laboratory experiments and field conditions, transient 3D numerical simulations were conducted using the OpenFOAM software. These simulations facilitated the development of a mechanistic model to elucidate the factors contributing to increased pressure and forces during the liquid purging process. The study examined the influence of gas pressure level, pipe diameter, initially accumulated liquid amount, liquid properties, and gas mass flow rate on the transient pressure drop and the forces acting on the jumper's elbows. The critical gas production rate required for complete liquid removal of the accumulated liquid was determined, and scaling rules were proposed to predict the effects of gas pressure and pipe diameter on this critical value. The dominant frequencies of pressure and force fluctuations were identified, with low-pressure systems exhibiting frequencies associated with two-phase flow phenomena and high-pressure systems showing frequencies attributed to acoustic waves.