Searcharxiv⌕ Search
Home/Archive/arXiv

arXiv · 2405.04704

System Identification of the Upgraded LHPOST6 Reaction Mass at the University of California San Diego

Andres Rodriguez-Burneo·Jose I. Restrepo·Joel P. Conte
View original source ↗Read source document ↗Export metadata ↓

Abstract

Upon completing the upgrade from one to six degrees of freedom of the Outdoor Shake Table at UCSD in 2019, forced vibration tests were carried out to identify the dynamic characteristics of the reaction mass and soil system. This report describes the motivation, execution, and results from such tests, which independently excited the reaction mass in four degrees of freedom: longitudinal, transverse, yaw, and vertical. The report discusses the frequency response curves and deformation patterns from which the natural frequencies, damping ratio, mode shapes, and rigid body motion were determined. The first objective of the study was to investigate if the dynamic properties of the system had dramatically changed after the upgrade by comparing the results to those from forced vibration tests performed 20 years ago, during the construction of the facility. In addition, most recent tests also contributed with results from the vertical degree of freedom, which had never been tested. The second objective was to obtain high-quality response data of the system that will be used to develop a high-fidelity computational model of the reaction mass in future research. A comparison of results showed a slight difference of 0.5Hz in the natural frequency of 2 degrees of freedom. Moreover, maximum displacements in the recent tests were overall larger than the previous ones with few exceptions. The report thoroughly discusses the several sources of discrepancy between the past and most recent results. Finally, test results allowed us to estimate the system's response if the shake table actuators were to be used at their maximum nominal capacity. Small displacement and high damping results were consistent with those of previous tests and further validated the design of the reaction mass.

Explore related subjects

eess.SP

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Andres Rodriguez-Burneo, Jose I. Restrepo, Joel P. Conte. 2024-05-07. System Identification of the Upgraded LHPOST6 Reaction Mass at the University of California San Diego. https://arxiv.org/abs/2405.04704

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Load Balancing in Multi-Shell LEO Satellite Networks with Successive Interference Cancellation

Multi-shell low Earth orbit (LEO) networks can increase service opportunities, but altitude-dependent propagation can concentrate traffic on lower shells and create strong inter-shell interference under full frequency reuse. This paper develops a mathematical framework for load balancing in multi-shell LEO satellite networks. Satellites on each shell form an independent spherical Poisson point process (SPPP), and the typical user associates with one of the per-shell serving satellites through a shell-dependent biased received-power rule, with receiver-side successive interference cancellation (SIC) under full frequency reuse. Shell-wise association probabilities, conditioned serving-distance distributions, and the rate coverage probability under shell-dependent traffic loads are derived and validated by simulation. The results show that shell-dependent biasing alleviates lower-shell traffic concentration and improves rate coverage, while receiver-side SIC mitigates the dominant lower-shell interference experienced by users associated with upper shells. Load balancing provides its largest rate-coverage gain in traffic hotspots, while SIC becomes more valuable as receive-side isolation weakens. With a fixed satellite budget, distributing satellites across multiple shells can further improve hotspot rate coverage by adding shell-wise serving opportunities.

eess.SP↗
arXiv2026

Tensor Decomposition Based Mixed-Field Sensing for XL-MIMO AFDM Systems

Integrated sensing and communications enabled by extremely large-scale MIMO (XL-MIMO) and affine frequency division multiplexing (AFDM) is a highly promising paradigm for vehicular networks. However, the near-field spherical wavefront distortions induce severe non-linear parameter coupling, while the highly dynamic scattering environments exacerbate mismatch errors. To address these critical challenges, this paper proposes a novel tensor-based sensing scheme for XL-MIMO AFDM systems. First, the received signals are reformulated into a tensor, followed by an efficient decomposition approach that exploits the inherent Vandermonde structure of the factor matrices. This allows parameters to be directly estimated from the decomposed matrices, effectively avoiding inter-parameter coupling. Subsequently, a symmetric decoupling and real-domain manifold optimization algorithm is proposed for angle of arrival estimation, circumventing the high-dimensional searches typically induced by near-field effects. Furthermore, a baseband reconstruction and analytical gradient-based algorithm is developed to perform delay-Doppler estimation in the continuous parameter domain, fundamentally eradicating the grid-mismatch errors inherent in high-mobility scenarios. With these decoupled factors, the remaining unknown angle of departure can be readily extracted. Extensive simulation results demonstrate that the proposed scheme achieves orders-of-magnitude improvements in delay-Doppler accuracy and eliminates the error floors in angular estimation that severely bottleneck state-of-the-art baselines.

eess.SP↗
arXiv2026

Radio Map Construction with Post-Hoc Location Calibration under Quasi-Static Positioning Errors: Joint Estimation, Performance Bounds, and GNSS-Based Evaluation

Radio maps enable environment-aware wireless and Internet-of-Things applications and can be constructed from location-tagged received signal strength (RSS) measurements collected by mobile devices. In urban environments, temporally correlated GNSS errors can shift an entire sensing trajectory, causing systematic spatial misregistration that is not mitigated by collecting more measurements. This paper presents a radio-map construction framework that uses the radio measurements themselves to calibrate erroneous location tags after data collection. The dominant positioning error is modeled as a sensor-specific quasi-static offset, which is jointly estimated with radio-propagation parameters in a Gaussian process regression (GPR) framework by exploiting complementary spatial information from distance-dependent path loss and spatially correlated shadowing. We establish lower and upper bounds on the conditional Bayes risk and show that, under a translation-invariant trajectory model, trajectory information alone cannot identify the quasi-static offset, thereby motivating the use of RSS-derived spatial information for calibration. Numerical evaluations across propagation conditions show that the proposed method reduces the mean squared error (MSE) gap from ideal GPR to approximately $3.26\mathrm{dB}^2$, compared with about $10\mathrm{dB}^2$ for position-error-agnostic and noisy-input GPR baselines. Evaluation using positioning-error models derived from smartphone GNSS measurements shows that the proposed method outperforms a KF--RTS trajectory-smoothing baseline despite unmodeled time-varying positioning errors, remaining within approximately $5\mathrm{dB}^2$ of ideal GPR at the median MSE. These results demonstrate that RSS measurements can serve not only as observations for radio-map reconstruction but also as spatial cues for post-hoc calibration of imperfectly geotagged sensing data.

eess.SP↗