Impacts of Blade Camber on Cross-Flow Turbine Performance and Loading

Abstract

Cross-flow turbines show promise for renewable energy generation from wind and tidal sources. The rotating reference frame of cross-flow turbine blades results in virtual camber and incidence due to streamline curvature, altering the lift, drag and pitching moment of the blades. Adding geometric camber is therefore likely to alter performance and loading, however there is little consensus regarding the direction of camber that might be most favorable. This study compares 2% concave-in and concave-out cambered blades (NACA 2418) with symmetrical NACA 0018 foils for a turbine with a 0.49 chord-to-radius ratio. Experimental performance measurements are compared across a range of tip-speeds, and particle image velocimetry is used to explore the in-rotor flow evolution through the cycle. Concave-out blades, which enhance virtual camber and lift in the power stroke are found to exhibit sub-optimal performance. In contrast, concave-in cambered blades slightly improved symmetrical blade performance by enhancing downstream flow reattachment, more than compensating for reduced peak power generation. The difference between each cambered foil is seen to grow with increasing tip-speed ratio. Moreover, these concave-in blades reduce peak loading by 13%, which may prove critical in future designs, especially at high tip-speed ratios. Exploration of the near-blade flow fields suggest that the influence of geometric camber is non-linear, and that use of a simplistic summation of both geometric and virtual camber to account for camber effects may be overly simplistic. Despite this, corresponding validated simulations suggest that a small but positive total camber (geometric plus virtual) is optimal for this turbine.