Fracture and failure of shear-jammed dense suspensions under impact

Abstract

Impacted with sufficiently large stress, a dense, initially liquid-like suspension can be forced into a solid-like state through the process of shear jamming. While the onset of shear jamming has been investigated extensively, less is known about the resulting solid-like state in the high stress limit and its failure. We experimentally produce such high-stress failure by impacting dense suspensions at a controlled speed. Using cornstarch suspensions we vary impact speed over several orders of magnitude and change fluid viscosity and surface tension in order to identify the conditions for failure. The results are compared with dense suspensions of potato starch or silica particles. In the case of fracture, we observe two types of cracks: a primary circular crack around the impactor followed by secondary radial cracks. Mapping out the onset of radial fracturing for different volume fractions and impact speeds, we identify the requirements for failure via crack formation to occur with at least 50% likelihood. We find that this likelihood is not sensitive to changes in particle diameter, but increases when the solvent's viscosity or surface tension are reduced. In the state diagram for dense suspensions we delineate the upper limit of shear-jammed rigidity and the crossover into a fracture regime at large volume fraction and normal stress, several orders of magnitude above the onset stress for shear-jamming. We find that the onset of fracturing in many cases is correlated with internal ductile deformation of the shear-jammed material underneath the impactor, observable in normal stress as a function of axial strain. For small suspension volumes and large impact speeds, we find strain-hardening up until fracturing. This more brittle behavior results in a modulus that, just before crack formation, is an order of magnitude larger than in shear-jammed suspensions undergoing ductile deformation.