SearcharxivSearch

arXiv · astro-ph/0502071

A detailed study of the rotating toroids in G31.41+0.31 and G24.78+0.08

Abstract

We present the results of high angular resolution millimeter observations of gas and dust toward G31.41+0.31 and G24.78+0.08, two high-mass star forming regions where four rotating massive toroids have been previously detected by Beltran et al. (2004). The CH3CN (12-11) emission of the toroids in G31.41+0.31 and core A1 in G24.78+0.08 has been modeled assuming that it arises from a disk-like structure seen edge-on, with a radial velocity field. For G31.41+0.31 the model properly fits the data for a velocity v_rot~1.7 km/s at the outer radius R_out~13400 AU and an inner radius R_inn~1340 AU, while for core A1 in G24.78+0.08 the best fit is obtained for v_rot~2.0 km/s at R_out~7700 AU and R_inn~2300 AU. Unlike the rotating disks detected around less luminous stars, these toroids are not undergoing Keplerian rotation. From the modeling itself, however, it is not possible to distinguish between constant rotation or constant angular velocity, since both velocity fields suitably fit the data. The best fit models have been computed adopting a temperature gradient of the type T proportional R^{-3/4}, with a temperature at the outer radius T_out~100 K for both cores. The M_dyn needed for equilibrium derived from the models is much smaller than the mass of the cores, suggesting that such toroids are unstable and undergoing gravitational collapse. The collapse is also supported by the CH3^{13}CN or CH3CN line width measured in the cores, which increases toward the center of the toroids. The estimates of v_inf and \dot M_acc are ~2 km/s and 3x10^{-2} M_sun/yr for G31.41+0.31, and ~1.2 km/s and ~9x10^{-3} M_sun/yr for G24.78+0.08 A1. Such large accretion rates could weaken the effect of stellar winds and radiation pressure and allow further accretion on the star.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Maria T. Beltran, Riccardo Cesaroni, Roberto Neri, Claudio Codella, Ray S. Furuya, Leonardo Testi, Luca Olmi. 2005-02-03. A detailed study of the rotating toroids in G31.41+0.31 and G24.78+0.08. https://doi.org/10.1051/0004-6361%3A20042381

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

MOND: A consequence of the geometric Leibniz Clock

Leibniz considered the notion of the 'empty physical space' to be a meaningless abstraction, and he held firmly to the view that the only significant thing was the set of relationships between 'objects', whatever these 'objects' might be. Similarly, he was equally clear in expressing his views about Newton's universal time, which he also considered to be a meaningless abstraction. In effect, for him, time was no more than a synonym for ordered change within a material system. The process of giving quantitative realization to this duality of non-Newtonian ideas forms the core of this work. A primary result arising is that every gravitating particle is no more than a clock - the geometric Leibniz Clock - which provides all the basic things: it conserves energy and angular momentum and satisfies the Weak Equivalence Principle. When the Clock is applied to model the concept of a galactic object within which all motions are circular, the characteristic properties of the MOND galaxy (asymptotic flatness, a critical acceleration scale, the baryonic Tully-Fisher relationship) are quantitatively reproduced in the resulting Leibniz galaxy. In short, the characteristic essence of MOND has its source in the geometric Leibniz Clock.

astro-ph

Cosmic Variance and Its Effect on the Luminosity Function Determination in Deep High z Surveys

We study cosmic variance in deep high redshift surveys and its influence on the determination of the luminosity function for high redshift galaxies. For several survey geometries relevant for HST and JWST instruments, we characterize the distribution of the galaxy number counts. This is obtained by means of analytic estimates via the two point correlation function in extended Press-Schechter theory as well as by using synthetic catalogs extracted from N-body cosmological simulations of structure formation. We adopt a simple luminosity - dark halo mass relation to investigate the environment effects on the fitting of the luminosity function. We show that in addition to variations of the normalization of the luminosity function, a steepening of its slope is also expected in underdense fields, similarly to what is observed within voids in the local universe. Therefore, to avoid introducing artificial biases, caution must be taken when attempting to correct for field underdensity, such as in the case of HST UDF i-dropout sample, which exhibits a deficit of bright counts with respect to the average counts in GOODS. A public version of the cosmic variance calculator based on the two point correlation function integration is made available on the web.

astro-ph

Receiver control for the Submillimeter Array

Efficient operation of a submillimeter interferometer requires remote (preferably automated) control of mechanically tuned local oscillators, phase-lock loops, mixers, optics, calibration vanes and cryostats. The present control system for these aspects of the Submillimeter Array (SMA) will be described. Distributed processing forms the underlying architecture and the software is split between hardware platforms in a leader/follower arrangement. In each antenna cabin, a serial network of up to ten independent 80C196 microcontroller boards attaches to the real-time PowerPC computer (running LynxOS). A multi-threaded, gcc-compiled leader program on the PowerPC accepts top-level requests via remote procedure calls (RPC), subsequently dispatches tuning commands to the relevant follower microcontrollers, and regularly reports the system status to optical-fiber-based reflective memory for common access by the telescope monitor and error reporting system. All serial communication occurs asynchronously via encoded, variable-length packets. The microcontrollers respond to the requested commands and queries by accessing non-volatile, rewriteable lookup-tables (when appropriate) and executing embedded software that operates additional electronic devices (DACs, ADCs, etc.). Since various receiver hardware components require linear or rotary motion, each microcontroller also implements a position servo via a one-millisecond interrupt service routine which drives a DC-motor/encoder combination that remains standard across each subsystem.

astro-ph