arXiv subjects

A. J. Bird

Publications and source records attributed to A. J. Bird.

165 records · Page 10Linked to original sources

arXiv2002

A Mass Model for Estimating the Gamma Ray Background of the Burst and Transient Source Experiment

Orbiting x-ray and gamma ray instruments are subject to large background count rates due to local particle fluxes in the space environment. The ability of an instrument to make calibrated measurements of the flux from a source of interest is highly dependent on accurately determining the background level. We present here a method of calculating the energy dependent background flux for any point in the complete data set recorded by the Burst and Transient Source Experiment (BATSE) in its nine year mission. The BATSE Mass Model (BAMM) uses a Monte Carlo mass modelling approach to produce a data base of the gamma ray background which is then filtered to simulate the background count rate with a 2.048 second time resolution. This method is able to reduce the variations in the background flux by a factor of 8 - 10, effectively `flat-fielding' the detector response. With flat-fielded BATSE data it should be possible to use the Earth occultation technique to produce a hard x-ray all sky survey to the 1-2 mCrab sensitivity limit. BAMM is also capable of estimating the contribution to the spectra measured from gamma ray sources due to the reprocessing of source photons in inactive material surrounding a gamma ray detector. Possible applications of this aspect of the model in the area of Gamma Ray Burst spectral analysis are discussed.

astro-ph↗

arXiv2001

The INTEGRAL/IBIS telescope modelling

The main objective of the IBIS modeling activities is the generation of the IBIS spectral response matrix. This generation will be done step by step by firstly constructing "calibrated model" of each IBIS sub-systems. A "calibrated model" is defined as a GEANT Monte-Carlo model, further checked by intensive corresponding calibration. These calibrated models will be in a second step integrated in the whole IBIS Mass Model. This Mass Model will be checked and refined using the data obtained during the IBIS Telescope calibration, the PLGC during the ETET period, and the In-flight calibration data acquired during the whole INTEGRAL mission. The IBIS Mass Model will be used also for computations of efficiencies and transparencies. Some imaging studies (such as the study of the diffuse emission) may be also done with the help of the IBIS Mass Model. The IBIS Mass Model may be used for the simulation of IBIS data in order to check the different IBIS software.

astro-ph↗

arXiv2001

Flat-Fielding BATSE Occultation Data for use in a Hard X-Ray All Sky Survey

The BATSE mission aboard CGRO can be used to observe hard X-ray sources by using the Earth occultation method. This method relies on measuring a step in the count rate profile in each BATSE detector as a source rises above or sets below the Earth's limb. A major problem in determining the step sizes (and hence the flux) is in extracting the steps from the varying background. A technique for flat-fielding the response of gamma ray detectors has been developed at Southampton. The technique uses a dynamic Monte-Carlo model to simulate the dominant components of the gamma-ray background encountered by the experiment at any point in its orbit. A maximum likelihood imaging method is also being developed that will be used to make a sky survey with all 9 years of the BATSE Continuous data set in the 20 - 500 keV range. An all sky map of 25 - 35 keV emission has been made using 60 days of data and has a 3 sigma flux sensitivity of 14 mCrab.

astro-ph↗