arXiv subjects

A. M. Garofalo

Publications and source records attributed to A. M. Garofalo.

4 recordsLinked to original sources

arXiv2026

First Experimental Evidence of Helicon Current Drive

Helicon current drive is an attractive solution for driving current to sustain steady state tokamak operation in reactor conditions. Dedicated DIII-D experiments have been conducted with a MW-level helicon system and successfully demonstrated core power deposition and current drive with helicon waves launched via a traveling wave antenna. The profile of the measured electron temperature response to helicon power injection is in good agreement with time-dependent integrated modeling that incorporates ray tracing and the effects of thermal transport simultaneously. When the helicon power is injected continuously to drive co-$I_p$ current, the reconstructed safety factor profile flattens significantly faster and sawteeth are triggered earlier than in comparison shots where the helicon is replaced by a comparable amount of electron cyclotron heating. Calculation of the helicon-driven current profile yields a peaked profile in the core, consistent with the observed power deposition profile and in good agreement with ray tracing predictions. Taken together, these experimental results represent strong evidence for the first definitive observation of auxiliary current drive due to helicon waves on any device.

physics.plasm-ph↗

arXiv2018

Analysis of Alfven Eigenmode destabilization in DIII-D high poloidal $β$ discharges using a Landau closure model

Alfven Eigenmodes are destabilized at the DIII-D pedestal during transient beta drops in high poloidal beta discharges with internal transport barriers (ITBs), driven by n=1 external kink modes, leading to energetic particle losses. There are two different scenarios in the thermal beta recovery phase: with bifurcation (two instability branches with different frequencies) or without bifurcation (single instability branch). We use the reduced MHD equations in a full 3D system, coupled with equations of density and parallel velocity moments for the energetic particles as well as the geodesic acoustic wave dynamics, to study the properties of the instabilities observed in the DIII-D high poloidal beta discharges and identify the conditions to trigger the bifurcation. The simulations suggest that instabilities with lower frequency in the bifurcation case are ballooning modes driven at the plasma pedestal, while the instability branch with higher frequencies are low n (n<4) Toroidal Alfven Eigenmodes nearby the pedestal. The reverse shear region between the middle and plasma periphery in the non-bifurcated case avoids the excitation of ballooning modes at the pedestal, although Toroidal Alfven Eigenmodes and Reverse Shear Alfven Eigenmodes are unstable in the reverse shear region. The n=1 and n=2 Alfven Eigenmode activity can be suppressed or minimized if the neutral beam injector (NBI) intensity is lower than the experimental value (betaf < 0.03). In addition, if the beam energy or neutral beam injector voltage is lower than in the experiment (Vth,f / VA0 < 0.2), the resonance between beam and thermal plasma is weaker. The n=3,4,5 and 6 AE activity can't be fully suppressed, although the growth rate and frequency is smaller for an optimized neutral beam injector operation regime. In conclusion, AE activity in high poloidal beta discharges can be minimized for optimized NBI operation regimes.

physics.plasm-ph↗

arXiv2017

MHD modeling of a DIII-D low-torque QH-mode discharge and comparison to observations

Extended-MHD modeling of DIII-D tokamak [J. L. Luxon, Nucl. Fusion 42, 614 (2002)] quiescent H-mode (QH-mode) discharges with nonlinear NIMROD [C. R. Sovinec et al., J. Comput. Phys. 195, 355 (2004)] simulations saturates into a turbulent state but does not saturate when the steady-state flow inferred from measurements is not included. This is consistent with the experimental observations of the quiescent regime on DIII-D. The simulation with flow develops into a saturated turbulent state where the n=1 and 2 toroidal modes become dominant through an inverse cascade. Each mode in the range of n=1-5 is dominant at a different time. Consistent with experimental observations during QH-mode, the simulated state leads to large particle transport relative to the thermal transport. Analysis shows that the amplitude and phase of the density and temperature perturbations differ resulting in greater fluctuation-induced convective particle transport relative to the convective thermal transport. Comparison to magnetic-coil measurements shows that rotation frequencies differ between the simulation and experiment, which indicates that more sophisticated extended-MHD two-fluid modeling is required.

physics.plasm-ph↗

arXiv2017

NIMROD Modeling of Quiescent H-mode: Reconstruction Considerations and Saturation Mechanism

The extended-MHD NIMROD code [C.R. Sovinec and J.R. King, J. Comput. Phys. 229, 5803 (2010)] models broadband-MHD activity from a reconstruction of a quiescent H-mode shot on the DIII-D tokamak [J. L. Luxon, Nucl. Fusion 42, 614 (2002)]. Computations with the reconstructed toroidal and poloidal ion flows exhibit low-n perturbations (n=1-5) that grow and saturate into a turbulent-like MHD state. The workflow used to project the reconstructed state onto the NIMROD basis functions re-solves the Grad-Shafranov equation and extrapolates profiles to include scrape-off-layer currents. Evaluation of the transport from the turbulent-like MHD state leads to a relaxation of the density and temperature profiles.

physics.plasm-ph↗