arXiv subjects

A. Mendez

Publications and source records attributed to A. Mendez.

5 recordsLinked to original sources

arXiv2021

Effect of Al content on the hardness and thermal stability study of AlTiN and AlTiBN coatings deposited by HiPIMS

The microstructure, mechanical properties and thermal stability of AlTiN and AlTiBN coatings grown by reactive high-power impulse magnetron sputtering (HiPIMS) have been analyzed as a function of Al/(Al+Ti) ratio, x, between 0.5 and 0.8. The coatings were predominantly formed by a face-centered cubic Ti(Al)N crystalline phase, both with and without B, even for x ratios as high as 0.6, which is higher than the ratio typically encountered for AlTiN coatings deposited by reactive magnetron sputtering. B doping, in combination with the highly energetic deposition conditions offered by HiPIMS, results in the suppression of the columnar grain morphology typically encountered in AlTiN coatings. On the contrary, the AlTiBN coatings grown by HiPIMS present a dense nanocomposite type microstructure, formed by nanocrystalline Ti(Al)N domains and amorphous regions composed of Ti(Al)B2 and BN. As a result, high-Al content (x>0.6) AlTiBN coatings grown by HiPIMS offer higher hardness, elasticity and fracture toughness than AlTiN coatings. Moreover, the thermal stability and the hot hardness are substantially enhanced, delaying the onset of formation of the detrimental hexagonal AlN phase from 850 C in the case of AlTiN, to 1000 C in the case of AlTiBN.

physics.app-ph↗

arXiv2021

The Future Of The Arecibo Observatory: The Next Generation Arecibo Telescope

The Arecibo Observatory (AO) is a multidisciplinary research and education facility that is recognized worldwide as a leading facility in astronomy, planetary, and atmospheric and space sciences. AO's cornerstone research instrument was the 305-m William E. Gordon telescope. On December 1, 2020, the 305-m telescope collapsed and was irreparably damaged. In the three weeks following the collapse, AO's scientific and engineering staff and the AO users community initiated extensive discussions on the future of the observatory. The community is in overwhelming agreement that there is a need to build an enhanced, next-generation radar-radio telescope at the AO site. From these discussions, we established the set of science requirements the new facility should enable. These requirements can be summarized briefly as: 5 MW of continuous wave transmitter power at 2 - 6 GHz, 10 MW of peak transmitter power at 430 MHz (also at 220MHz under consideration), zenith angle coverage 0 to 48 deg, frequency coverage 0.2 to 30 GHz and increased Field-of-View. These requirements determine the unique specifications of the proposed new instrument. The telescope design concept we suggest consists of a compact array of fixed dishes on a tiltable, plate-like structure with a collecting area equivalent to a 300m dish. This concept, referred to as the Next Generation Arecibo Telescope (NGAT), meets all of the desired specifications and provides significant new science capabilities to all three research groups at AO. This whitepaper presents a sample of the wide variety of the science that can be achieved with the NGAT, the details of the telescope design concept and the need for the new telescope to be located at the AO site. We also discuss other AO science activities that interlock with the NGAT in the white paper.

astro-ph.IM↗

arXiv2008

A new determination of the orbit and masses of the Be binary system delta Scorpii

The binary star delta Sco (HD143275) underwent remarkable brightening in the visible in 2000, and continues to be irregularly variable. The system was observed with the Sydney University Stellar Interferometer (SUSI) in 1999, 2000, 2001, 2006 and 2007. The 1999 observations were consistent with predictions based on the previously published orbital elements. The subsequent observations can only be explained by assuming that an optically bright emission region with an angular size of > 2 +/- 1 mas formed around the primary in 2000. By 2006/2007 the size of this region grew to an estimated > 4 mas. We have determined a consistent set of orbital elements by simultaneously fitting all the published interferometric and spectroscopic data as well as the SUSI data reported here. The resulting elements and the brightness ratio for the system measured prior to the outburst in 2000 have been used to estimate the masses of the components. We find Ma = 15 +/- 7 Msun and Mb = 8.0 +/- 3.6 Msun. The dynamical parallax is estimated to be 7.03 +/- 0.15 mas, which is in good agreement with the revised HIPPARCOS parallax.

astro-ph↗

arXiv2006

Orbital elements, masses and distance of lambda Scorpii A and B determined with the Sydney University Stellar Interferometer and high resolution spectroscopy

The triple system HD158926 (lambda Sco) has been observed interferometrically with the Sydney University Stellar Interferometer and the elements of the wide orbit have been determined. These are significantly more accurate than the previous elements found spectroscopically. The inclination of the wide orbit is consistent with the inclination previously found for the orbit of the close companion. The wide orbit also has low eccentricity, suggesting that the three stars were formed at the same time. The brightness ratio between the two B stars was also measured at lambda = 442nm and 700nm. The brightness ratio and colour index are consistent with the previous classification of lambda Sco A as B1.5 and lambda Sco B as B2. Evolutionary models show that the two stars lie on the main sequence. Since they have have the same age and luminosity class (IV) the mass-luminosity relation can be used to determine the mass ratio of the two stars: M_B/M_A = 0.76+/-0.04. The spectroscopic data have been reanalyzed using the interferometric values for P, T, e and omega, leading to revised values for a_1sin i and the mass function. The individual masses can be found from the mass ratio, the mass function, spectrum synthesis and the requirement that the age of both components must be the same: M_A = 10.4+/-1.3 Msun and M_B = 8.1+/-1.0 Msun. The masses, angular semimajor axis and the period of the system can be used to determine the dynamical parallax. We find the distance to lambda Sco to be 112+/-5 pc, which is approximately a factor of two closer than the HIPPARCOS value of 216+/-42 pc.

astro-ph↗

arXiv2004

Orbital parameters, masses and distance to Beta Centauri determined with the Sydney University Stellar Interferometer and high resolution spectroscopy

The bright southern binary star beta Centauri (HR 5267) has been observed with the Sydney University Stellar Interferometer (SUSI) and spectroscopically with the ESO CAT and Swiss Euler telescopes at La Silla. The interferometric observations have confirmed the binary nature of the primary component and have enabled the determination of the orbital parameters of the system. At the observing wavelength of 442 nm the two components of the binary system have a magnitude difference of 0.15. The combination of interferometric and spectroscopic data gives the following results: orbital period 357 days, semi-major axis 25.30 mas, inclination 67.4 degrees, eccentricity 0.821, distance 102.3 pc, primary and secondary masses M1 = M2 = 9.1 solar masses and absolute visual magnitudes of the primary and secondary M1V = -3.85 and M2V = -3.70. The high accuracy of the results offers a fruitful starting point for future asteroseismic modelling of the pulsating binary components.

astro-ph↗