SearcharxivSearch

arXiv subjects

A. P. Bolshakov

Publications and source records attributed to A. P. Bolshakov.

3 recordsLinked to original sources

Near surface donor-acceptor pairs in hydrogenated homoepitaxial diamond nanolayers

Hydrogen-terminated diamond is known for its p-type surface conductivity, which arises from a near-surface hole accumulation layer induced by adsorbed acceptor species. Here, we demonstrate that these surface acceptors also form optically active donor-acceptor pairs (DAP) with substitutional nitrogen donors in diamond. The insertion of a nominally undoped CVD interlayer between a nitrogen-rich HPHT substrate and a hydrogen-terminated surface enables the precise tuning of the donor-acceptor separation with nanometer precision. Radiative DAP recombination appears as bright, spectrally narrow lines whose intensity, energy, and decay dynamics depend systematically on interlayer thickness. Individual lines show single-photon statistics, while ensembles exhibit strong polarization anisotropy reflecting the planar donor-acceptor geometry. These findings reveal an optical counterpart of hydrogen-induced surface transfer doping in diamond and establish a surface-defined, nanometer-tunable platform for engineering DAP-based quantum emitters.

quant-ph

Uniform diamond coatings on WC-Co hard alloy cutting inserts deposited by a microwave plasma CVD

Polycrystalline diamond coatings have been grown on cemented carbide substrates with different aspect ratios by a microwave plasma CVD in methane-hydrogen gas mixtures. To protect the edges of the substrates from non-uniform heating due to the plasma edge effect, a special plateholder with pockets for group growth has been used. The difference in heights of the substrates and plateholder, and its influence on the diamond film mean grain size, growth rate, phase composition and stress was investigated. The substrate temperature range, within which uniform diamond films are produced with good adhesion, is determined. The diamond-coated cutting inserts produced at optimized process exhibited a reduction of cutting force and wear resistance by a factor of two, and cutting efficiency increase by 4.3 times upon turning A390 Al-Si alloy as compared to performance of uncoated tools.

cond-mat.mtrl-sci

Channeling Effect in Polycrystalline Deuterium-Saturated CVD Diamond Target Bombarded by Deuterium Ion Beam

At the ion accelerator HELIS at the LPI, the neutron yield is investigated in DD reactions within a polycrystalline deuterium-saturated CVD diamond, during an irradiation of its surface by a deuterium ion beam with the energy less than 30 keV. The measurements of the neutron flux in the beam direction are performed in dependence on the target angle, \b{eta}, with respect to the beam axis. These measurements are performed using a multichannel detector based on He3 counters. A significant anisotropy in neutron yield is observed, it was higher by a factor of 3 at \b{eta}=0 compared to that at \b{eta} = +-45°. The possible reasons for the anisotropy, including ion channeling, are discussed.

physics.ins-det