arXiv subjects
Publications and source records attributed to A. Sytin.
A thick gas electron multiplier is considered for radiation-hard detectors (hadron calorimeter). There was carried out technological and design study to optimize the element structure. The measurements results and the next plans are presented.
The paper describes the SPHINX facility which includes a wide-aperture magnetic spectrometer with scintillation counters and hodoscopes, proportional chambers and drift tubes, multichannel electromagnetic and hadron calorimeters, a guard system, a RICH velocity spectrometer and a hodoscopical threshold Cherenkov detector for the identification of charged secondary particles. The SPHINX spectrometer, in its last modification, had the possibility to record 3000-4000 trigger events per an accelerator burst. The spectrometer was used during the last decade in experiments with the 70GeV proton beam of the IHEP accelerator U-70.
This article includes the description of the geometric parameter gage device prototype for synchrotron radiation of HERA collider (DESY). The system construction which capable to measure photo current, caused by such a radiation in a refractory metal, described here. The system component parts are: measuring heads and photo current measuring electronics designed by IHEP, stepper motor by Vacuum Generators with HEDS-550X encoder by Hewlett Packard, PCI-STEP-4CX 4-Axis Closed Loop Step controller by National Instruments. The device is controlled by means of Microsoft Visual Basic program using Value Motion Windows Libraries. The device prototype was tested in the beam of the DORIS storage ring.
The beam diagnostic system of U-70 beam transfer lines (beam profiles, intensity and beam losses measurements) was designed in the beginning of 80-th on the base of 8-bit microprocessor, SUMMA hardware and home made serial communication link. Because of the maintenance problems the decision was taken to upgrade the hardware and software parts of the system.
A 70 GeV Proton Synchrotron Extracted Beam Lines Control System is described. About 130 Magnet Dipoles and Quadrupoles, 20 Correction Magnets, 50 Beam Collimators, BPM equipment spread over 1 Km have to be controlled. The old System was based on the PDP-11/40 and LSI-11 compatible computers and the MIL 1553 STD as a Field Bus. It successfully operated about 15 years. A new system includes home made Equipment Controllers based on I 8051 Processors, CAN Field Bus, FECs, Servers, Consoles connected by Ethernet. On the first stage of modernization PDPs and LSIs are replaced with PCs connected by Ethernet. Equipment controllers are being successfully tested in the Collimators and Corrector Magnets Controls during a run.