arXiv subjects

A. Tapper

Publications and source records attributed to A. Tapper.

4 recordsLinked to original sources

arXiv2025

Cosmic Ray Measurements Using Charge and Light Readout in a Pixelated Liquid Argon Time Projection Chamber

Liquid argon time projection chambers have emerged as a competitive technology for detecting solar neutrinos. The SoLAr collaboration was formed to explore argon detectors with pixelated light and charge readout, aiming for high detection efficiency and improved energy resolution. Building on the success of an initial prototype, we present results obtained with a second SoLAr prototype (V2), a $30 \times 30 \times 30$ cm$^{3}$ time projection chamber operated in a cryostat containing several hundred kilograms of liquid argon. We report measurements of cosmic-ray muons using both tracking and calorimetry from light and charge sensors, and we highlight the improved performance achieved through combined charge and light reconstruction. These results demonstrate the promise of dual-readout detectors and motivate future prototyping efforts toward kiloton-scale facilities.

physics.ins-det↗

arXiv2024

First Demonstration of a Combined Light and Charge Pixel Readout on the Anode Plane of a LArTPC

The novel SoLAr concept aims to extend sensitivities of liquid-argon neutrino detectors down to the MeV scale for next-generation detectors. SoLAr plans to accomplish this with a liquid-argon time projection chamber that employs an anode plane with dual charge and light readout, which enables precision matching of light and charge signals for data acquisition and reconstruction purposes. We present the results of a first demonstration of the SoLAr detector concept with a small-scale prototype detector integrating a pixel-based charge readout and silicon photomultipliers on a shared printed circuit board. We discuss the design of the prototype, and its operation and performance, highlighting the capability of such a detector design.

physics.ins-det↗

arXiv2015

Run 2 Upgrades to the CMS Level-1 Calorimeter Trigger

The CMS Level-1 calorimeter trigger is being upgraded in two stages to maintain performance as the LHC increases pile-up and instantaneous luminosity in its second run. In the first stage, improved algorithms including event-by-event pile-up corrections are used. New algorithms for heavy ion running have also been developed. In the second stage, higher granularity inputs and a time-multiplexed approach allow for improved position and energy resolution. Data processing in both stages of the upgrade is performed with new, Xilinx Virtex-7 based AMC cards.

physics.ins-det↗

arXiv2010

The design, construction and performance of the MICE scintillating fibre trackers

Charged-particle tracking in the international Muon Ionisation Cooling Experiment (MICE) will be performed using two solenoidal spectrometers, each instrumented with a tracking detector based on 350 {\mu}m diameter scintillating fibres. The design and construction of the trackers is described along with the quality-assurance procedures, photon-detection system, readout electronics, reconstruction and simulation software and the data-acquisition system. Finally, the performance of the MICE tracker, determined using cosmic rays, is presented.

physics.ins-det↗