SearcharxivSearch

arXiv subjects

A. Vega

Publications and source records attributed to A. Vega.

9 recordsLinked to original sources

Li-decorated BC3 nanopores: Promising materials for hydrogen storage

In the quest of new absorbent for hydrogen storage, we investigate the capacities of slit pores formed by two BC3 sheets decorated with Li atoms. Their hydrogen storage capacities are determined using density-functional theory in conjunction with a quantum-thermodynamic model that allows to simulate real operating conditions, i.e., finite temperatures and different loading and depletion pressures applied to the adsorbent in the charge-delivery cycles. We show that the capacities of the adsorbed hydrogen phase of Li-decorated BC3 slit pores are larger than those reported recently for graphene and Li-decorated borophene slit pores. On the other hand, the usable volumetric and gravimetric capacities of Li-decorated BC3 slit pores can meet the targets stipulated by the U.S. Department of Energy (DOE) for onboard hydrogen storage at moderate temperatures and loading pressures well below those used in the tanks employed in current technology. In particular, the usable volumetric capacity for pore widths of about 10 Å meets the DOE target at a loading pressure of 6.6 MPa when depleting at ambient pressure. Our results highlight the important role played by the rotational degree of freedom of the H2 molecule in determining the confining potential within the slip pores and their hydrogen storage capacities.

cond-mat.mtrl-sci

Contributions of the LAGO Collaboration to the 36th ICRC

The LAGO (Latin American Giant Observatory) observatory is an experiment that spans over Latin America in a wide range of latitudes that gives different rigidity cut offs for the enter of cosmic rays in the atmosphere. The motivation of the Observatory is to study atmospheric radiation and space weather through the measurement of the secondary emission of low energy cosmic rays at ground level using Water Cherenkov Detectors (WCD). This work presents the contributions of the LAGO collaboration to the 2019 36th ICRC.

hep-ex

Structure and electronic properties of molybdenum monoatomic wires encapsulated in carbon nanotubes

Monoatomic chains of molybdenum encapsulated in single walled carbon nanotubes of different chiralities are investigated using density functional theory. We determine the optimal size of the carbon nanotube for encapsulating a single atomic wire, as well as the most stable atomic arrangement adopted by the wire. We also study the transport properties in the ballistic regime by computing the transmission coefficients and tracing them back to electronic conduction channels of the wire and the host. We predict that carbon nanotubes of appropriate radii encapsulating a Mo wire have metallic behavior, even if both the nanotube and the wire are insulators. Therefore, encapsulating Mo wires in CNT is a way to create conductive quasi one-dimensional hybrid nanostructures.

cond-mat.mes-hall

Impact of dimerization and stretching on the transport properties of molybdenum atomic wires

We study the electrical and transport properties of monoatomic Mo wires with different structural characteristics. We consider first periodic wires with inter-atomic distances ranging between the dimerized wire to that formed by equidistant atoms. We find that the dimerized case has a gap in the electronic structure which makes it insulating, as opposed to the equidistant or near-equidistant cases which are metallic. We also simulate two conducting one-dimensional Mo electrodes separated by a scattering region which contains a number of dimers between 1 and 6. The $I-V$ characteristics strongly depend on the number of dimers and vary from ohmic to tunneling, with the presence of different gaps. We also find that stretched chains are ferromagnetic.

cond-mat.mes-hall

Spin configuration in a frustrated ferromagnetic/antiferromagnetic thin film system

We have studied the magnetic configuration in ultrathin antiferromagnetic Mn films grown around monoatomic steps on an Fe(001) surface by spin-polarized scanning tunneling microscopy/spectroscopy and ab-initio-parametrized self-consistent real-space tight binding calculations in which the spin quantization axis is independent for each site thus allowing noncollinear magnetism. Mn grown on Fe(001) presents a layered antiferromagnetic structure. In the regions where the Mn films overgrows Fe steps the magnetization of the surface layer is reversed across the steps. Around these defects a frustration of the antiferromagnetic order occurs. Due to the weakened magnetic coupling at the central Mn layers, the amount of frustration is smaller than in Cr and the width of the wall induced by the step does not change with the thickness, at least for coverages up to seven monolayers.

cond-mat.mtrl-sci

Collinear versus non-collinear magnetic order in Pd atomic clusters: ab-initio calculations

We present a thorough theoretical assessment of the stability of non-collinear spin arrangements in small palladium clusters. We generally find that ferromagnetic order is always preferred, but that antiferromagnetic and non-collinear configurations of different sorts exist and compete for the first excited isomers. We also show that the ground state is insensitive to the choice of atomic configuration for the pseudopotential used and to the approximation taken for the exchange and correlation potential. Moreover, the existence and relative stability of the different excited configurations also depends weakly on the approximations employed. These results provide strong evidence on the transferability of pseudopotential and exchange and correlation functionals for palladium clusters as opposed to the situation found for the bulk phases of palladium.

cond-mat.mtrl-sci

Collinear versus non-collinear magnetic order in Pd atomic clusters

We present a thorough theoretical assessment of the stability of non-collinear spin arrangements in small palladium clusters. We generally find that ferromagnetic order is always preferred, but that antiferromagnetic and non-collinear configurations of different sorts exist and compete for the first excited isomers. We also show that the relative stability of all these states is rather insensitive to the choice of atomic configuration for the pseudopotential used and to the approximation taken for the exchange and correlation potential. This result stands in stark contrast with the situation found for the bulk phases of palladium.

cond-mat.mtrl-sci

Antiferromagnetic interlayer coupling in Fe/c-SiFe/Fe sandwiches and multilayers

We report the first ab-initio study of the interlayer exchange coupling in Fe/c-FeSi/Fe sandwiches and Fe/c-FeSi multilayers. We perform several structural studies, which show the stability of the CsCl arrangement seen experimentally for the spacer. We find antiferromagnetic coupling between the Fe slabs for spacer thicknesses smaller than about 15 $Å$, for both sandwiches and multilayers structures. We also study the effect of pinholes, interface roughness or structural misconfigurations of the spacer on the sign and magnitude of the exchange constant J. We finally show that the asymptotic behavior of J is determined by a flat band of the c-FeSi spacer, located at the M point in the Brillouin zone.

cond-mat.mtrl-sci

All electron and pseudopotential study of the spin polarization of the V (001) surface: LDA versus GGA

The spin-polarization at the V(001) surface has been studied by using different local (LSDA) and semilocal (GGA) approximations to the exchange-correlation potential of DFT within two ab initio methods: the all-electron TB-LMTO-ASA and the pseudopotential LCAO code SIESTA (Spanish Initiative for Electronic Simulations with Thousands of Atoms). A comparative analysis is performed first for the bulk and then for a N-layer V(001) film (7 < N < 15). The LSDA approximation leads to a non magnetic V(001) surface with both theoretical models in agreement (disagreement) with magneto-optical Kerr (electron-capture spectroscopy) experiments. The GGA within the pseudopotential method needs thicker slabs than the LSDA to yield zero moment at the central layer, giving a high surface magnetization (1.70 Bohr magnetons), in contrast with the non magnetic solution obtained by means of the all-electron code.

cond-mat.str-el