arXiv subjects

A. Verna

Publications and source records attributed to A. Verna.

8 recordsLinked to original sources

arXiv2024

The CRILIN calorimeter: gamma radiation resistance of crystals and SiPMs

The Crilin calorimeter is a semi-homogeneous calorimetric system based on Lead Fluoride (PbF$_2$) crystals with UV-extended Silicon Photomultipliers (SiPMs) proposed for the Muon Collider. This study investigates the radiation resistance of crystals and SiPMs, subjected to 10 kGy gamma irradiation, equivalent to a 10-year service life in the Muon Collider. Our findings indicate that while PbF$_2$ crystals exhibit a decrease in transmittance post-irradiation with partial recovery over time, the alternative PbWO$_4$-Ultra Fast (PWO-UF) demonstrates exceptional radiation hardness, maintaining stable transmittance. SiPMs showed an increase in dark current and breakdown voltage post-irradiation, with less degradation observed in the SiPM biased during the exposure to radiation compared to the unbiased component. These results underscore the viability of PbF$_2$ for radiation-tolerant calorimeters, though improvements in production homogeneity are needed. The superior performance of PWO-UF crystals suggests they are a promising alternative for high-radiation applications, but their higher cost must be carefully considered.

physics.ins-det↗

arXiv2023

Efficient activation of telecom emitters in silicon upon ns pulsed laser annealing

The recent demonstration of optically active telecom emitters makes silicon a compelling candidate for solid state quantum photonic platforms. Particularly fabrication of the G center has been demonstrated in carbon-rich silicon upon conventional thermal annealing. However, the high-yield controlled fabrication of these emitters at the wafer-scale still requires the identification of a suitable thermodynamic pathway enabling its activation following ion implantation. Here we demonstrate the efficient activation of G centers in high-purity silicon substrates upon ns pulsed laser annealing. The proposed method enables the non-invasive, localized activation of G centers by the supply of short non-stationary pulses, thus overcoming the limitations of conventional rapid thermal annealing related to the structural metastability of the emitters. A finite-element analysis highlights the strong non-stationarity of the technique, offering radically different defect-engineering capabilities with respect to conventional longer thermal treatments, paving the way to the direct and controlled fabrication of emitters embedded in integrated photonic circuits and waveguides.

physics.app-ph↗

arXiv2020

Unexpectedly large electron correlation measured in Auger spectra of ferromagnetic iron thin films: orbital-selected Coulomb and exchange contributions

A set of electron-correlation energies as large as 10 eV have been measured for a magnetic 2ML Fefilm deposited on Ag(001). By exploiting the spin selectivity in angle-resolved Auger-photoelectroncoincidence spectroscopy and the Cini-Sawatzky theory, the core-valence-valence Auger spectrumof a spin-polarized system have been resolved: correlation energies have been determined for eachindividual combination of the two holes created in the four sub-bands involved in the decay: majorityand minority spin, as well asegandt2g. The energy difference between final states with paralleland antiparallel spin of the two emitted electrons is ascribed to the spin-flip energy for the final ionstate, thus disentangling the contributions of Coulomb and exchange interactions.

cond-mat.str-el↗

arXiv2019

Space-Charge effect in electron time-of-flight analyzer for high-energy photoemission spectroscopy

The space-charge effect, due to the instantaneous emission of many electrons after the absorption of a single photons pulse, causes distortion in the photoelectron energy spectrum. Two calculation methods have been applied to simulate the expansion during a free flight of clouds of mono- and bi-energetic electrons generated by a high energy pulse of light and their results have been compared. The accuracy of a widely used tool, such as SIMION(R), in predicting the energy distortion caused by the space-charge has been tested and the reliability of its results is verified. Finally we used SIMION(R) to take into account the space-charge effects in the simulation of simple photoemission experiments with a time-of-flight analyzer.

physics.ins-det↗

arXiv2013

Electron sampling depth and saturation effects in perovskite films investigated by soft x-ray absorption spectroscopy

Knowledge of the electron sampling depth and related saturation effects is important for quantitative analysis of X-ray absorption spectroscopy data, yet for oxides with the perovskite structure no quantitative values are so far available. Here we study absorption saturation in films of two of the most-studied perovskites, LCMO and YBCO, at the L2,3 edge of Mn and Cu, respectively. By measuring the electron-yield intensity as a function of photon incidence angle and film thickness, the sampling depth d, photon attenuation length, lambda, and the ratio lambda/d have been independently determined between 50 and 300 K. The extracted sampling depth dLCMO=3 nm for LCMO at high temperatures in its polaronic insulator state (150-300K) is not much larger than values reported for pure transition metals (d Co or Ni=2-2.5nm) at room temperature, but it is smaller than dYBCO=3.9 nm for metallic YBCO that is in turn smaller than the value reported for Fe3O4 (d=4.5 nm) The measured dLCMO increases to 4.5 nm when LCMO is in the metallic state at low temperatures. These results indicate that a universal rule of thumb for the sampling depth in oxides cannot be assumed, and that it can be measurably influenced by electronic phase transitions that derive from strong correlations.

cond-mat.mtrl-sci↗

arXiv2013

Determination of the magnetization profile of Co/Mg periodic multilayers by magneto-optic Kerr effect and X-ray magnetic resonant reflectivity

The resonant magnetic reflectivity of Co/Mg multilayers around the Co L2,3 absorption edge is simulated then measured on a specifically designed sample. The dichroic signal is obtained when making the difference between the two reflectivities measured with the magnetic field applied in two opposite directions parallel to the sample surface. The simulations show that the existence of magnetic dead layers at the interfaces between the Co and Mg layers leads to an important increase of the dichroic signal measured in the vicinity of the third Bragg peak that otherwise should be negligible. The measurements are in agreement with the model introducing 0.25 nm thick dead layers. This is attributed to the Co atoms in contact with the Mg layers and thus we conclude that the Co-Mg interfaces are abrupt from the magnetic point of view.

cond-mat.mtrl-sci↗

arXiv2009

Measuring magnetic profiles at manganite surfaces with monolayer resolution

The performance of manganite-based magnetic tunnel junctions (MTJs) has suffered from reduced magnetization present at the junction interfaces that is ultimately responsible for the spin polarization of injected currents; this behavior has been attributed to a magnetic "dead layer" that typically extends a few unit cells into the manganite. X-ray magnetic scattering in resonant conditions (XRMS) is one of the most innovative and effective techniques to extract surface or interfacial magnetization profiles with subnanometer resolution, and has only recently been applied to oxide heterostructures. Here we present our approach to characterizing the surface and interfacial magnetization of such heterostructures using the XRMS technique, conducted at the BEAR beamline (Elettra synchrotron, Trieste). Measurements were carried out in specular reflectivity geometry, switching the left/right elliptical polarization of light as well the magnetization direction in the scattering plane. Spectra were collected across the Mn L2,3 edge for at least four different grazing angles in order to better analyse the interference phenomena. The resulting reflectivity spectra have been carefully fit to obtain the magnetization profiles, minimizing the number of free parameters as much as possible. Optical constants of the samples (real and imaginary part of the refractive index) in the interested frequency range are obtained through absorption measurements in two magnetization states and subsequent Kramers-Kronig transformation, allowing quantitative fits of the magnetization profile at different temperatures. We apply this method to the study of air-exposed surfaces of epitaxial La2/3Sr1/3MnO3 (001) films grown on SrTiO3 (001) substrates.

cond-mat.str-el↗

arXiv2006

Magneto-optical characterization of MnxGe1-x alloys obtained by ion implantation

Magneto-optical Kerr effect hysteresis loops at various wavelengths in the visible/near-infrared range have been used to characterize the magnetic properties of alloys obtained by implanting Mn ions at fixed energy in a Ge matrix. The details of the hysteresis loops reveal the presence of multiple magnetic contributions. They may be attributed to the inhomogeneous distribution of the magnetic atoms and, in particular, to the known coexistence of diluted Mn in the Ge matrix and metallic Mn-rich nanoparticles embedded in it [Phys. Rev. B 73, 195207(2006)].

cond-mat.mtrl-sci↗