arXiv subjects
Publications and source records attributed to A. Werner.
We extend our previous theory of etale parallel transport to a larger class of slope zero vector bundles on p-adic curves. The new class is stable under pullback by ramified coverings. We also construct p-adic representations of a central extension of the fundamental group for certain bundles of non-zero slope.
We prove that a category of degree zero vector bundles with "potentially strongly semistable reduction" on a p-adic curve is a neutral Tannakian category. We also make a first study of the corresponding affine group scheme. In particular, we determine its group of connected components using a theorem of Weil.
We define and study a certain category of vector bundles on a p-adic curve to which we can associate in a functorial way finite dimensional p-adic representations of the geometric fundamental group. Among other things we investigate two different relations of these constructions with the Hodge-Tate decomposition.
By means of extensive Monte Carlo simulations of the bond fluctuation model, we study the effect of adding AB diblock copolymers on the properties of an interface between demixed homopolymer phases. The parameters are chosen such that the homopolymers are strongly segregated, and the whole range of copolymer concentrations in the two phase coexistence region is scanned. We compare the ``mushroom'' regime, in which copolymers are diluted and do not interact with each other, with the ``wet brush'' regime, where copolymers overlap and stretch, but are still swollen by the homopolymers. A ``dry brush'' regime is never entered for our choice of chain lengths. ``Intrinsic'' profiles are calculated using a block analysis method introduced by us in earlier work. We discuss density profiles, orientational profiles and contact number profiles. In general, the features of the profiles are similar at all copolymer concentrations, however, the profiles in the concentrated regime are much broader than in the dilute regime. The results compare well with self-consistent field calculations.
We consider an interface between two demixed A and B phases, confined in a thin film between two antisymmetric walls, one of which prefers A and the other B. Above the wetting transition, the interface is stabilized in the center of the film. Based on a suitable extension of the Cahn-Hilliard gradient-square theory in combination with the capillary wave theory, we argue that the confinement influences the interfacial structure in two ways: It squeezes the intrinsic structure and cuts off the capillary wave spectrum. As a result, the interfacial width is proportional to the film thickness D in very thin films, and proportional to the square root of D in thicker films. These effects are then discussed in detail for the special case of an interface between demixed homopolymer phases. The width of the intrinsic profile is calculated analytically as a function of film thickness in the Cahn-Hilliard approximation (weak segregation limit) and in the Helfand theory (strong segregation limit), and numerically in the self-consistent field approximation. The results are confirmed by Monte Carlo simulations of a lattice model for a polymer mixture.
A popular concept which describes the structure of polymer interfaces by ``intrinsic profiles'' centered around a two dimensional surface, the ``local interface position'', is tested by extensive Monte Carlo simulations of interfaces between demixed homopolymer phases in symmetric binary (AB) homopolymer blends, using the bond fluctuation model. The simulations are done in an LxLxD geometry. The interface is forced to run parallel to the LxL planes by imposing periodic boundary conditions in these directions and fixed boundary conditions in the D direction, with one side favoring A and the other side favoring B. Intrinsic profiles are calculated as a function of the ``coarse graining length'' B by splitting the system into columns of size BxBxD and averaging in each column over profiles relative to the local interface position. The results are compared to predictions of the self-consistent field theory. It is shown that the coarse graining length can be chosen such that the interfacial width matches that of the self-consistent field profiles, and that for this choice of B the ``intrinsic'' profiles compare well with the theoretical predictions.
The structure of polymer coils near interfaces between coexisting phases of symmetrical polymer mixtures (AB) is discussed, as well as the structure of symmetric diblock copolymers of the same chain length N adsorbed at the interface. The problem is studied by Monte Carlo simulations of the bond fluctuation model on the simple cubic lattice, using massively parallel computers (CRAY T3D). While homopolymer coils in the strong segregation limit are oriented parallel to the interface, the diblocks form ``dumbbells'' oriented perpendicular to the interface. However, in the dilute case (``mushroom regime'' rather than ``brush regime''), the diblocks are only weakly stretched. Distribution functions for monomers at the chain ends and in the center of the polymer are obtained, and a comparison to the self consistent field theory is made.
The properties of diluted symmetric A-B diblock copolymers at the interface between A and B homopolymer phases are studied by means of Monte Carlo (MC) simulations of the bond fluctuation model. We calculate segment density profiles as well as orientational properties of segments, of A and B blocks, and of the whole chain. Our data support the picture of oriented ``dumbbells'', which consist of mildly perturbed A and B Gaussian coils. The results are compared to a self consistent field theory (SCFT) for single copolymer chains at a homopolymer interface. We also discuss the number of interaction contacts between monomers, which provide a measure for the ``active surface'' of copolymers or homopolymers close to the interface.