arXiv subjects

A. Winkler

Publications and source records attributed to A. Winkler.

13 recordsLinked to original sources

arXiv2025

Evaluation of CZT Detector Performance in Alpha and Gamma Spectrometry

Presented is a work on the performance studies of Cadmium Zinc Telluride (CZT) planar detector structures. Current-voltage (IV), capacitance-voltage (CV), and gamma- and alpha-spectroscopy measurements were carried out to provide the essential baseline required for forthcoming defect configuration impact studies on the detector spectroscopy performance. For each tested sensor, spectroscopic responses were recorded with several bias voltages applied. The described suite of measurements provides the parameters needed to evaluate, bulk resistivity, signal efficiency, and energy resolution for characteristic peaks at different energies. Readout configurations and data processing are discussed in related sections.

physics.ins-det↗

arXiv2024

A photon-interfaced ten qubit quantum network node

We entangle each individual matter-qubit in a register of ten to a separate travelling photon. The qubits are encoded in a string of cotrapped atomic ions. By switching the trap confinement, ions are brought one at a time into the waist of an optical cavity and emit a photon via a laser-driven cavity-mediated Raman transition. The result is a train of photonic-qubits, each near-maximally entangled by their polarisation with a different ion-qubit in the string. An average ion-photon Bell state fidelity of 92(1)% is achieved, for an average probability for detecting each single photon of 9.1(8)%. The technique is directly scalable to larger ion-qubit registers and opens up the near-term possibility of entangling distributed networks of trapped-ion quantum processors, sensing arrays and clocks.

quant-ph↗

arXiv2022

Quality assessment of Cadmium Telluride as a detector material for multispectral medical imaging

Cadmium Telluride (CdTe) is a high-Z material with excellent photon radiation absorption properties, making it a promising material to include in radiation detection technologies. However, the brittleness of CdTe crystals as well as their varying concentration of defects necessitate a thorough quality assessment before the complex detector processing procedure. We present our quality assessment of CdTe as a detector material for multispectral medical imaging, a research which is conducted as part of the Consortium Project Multispectral Photon-counting for Medical Imaging and Beam characterization (MPMIB). The aim of the project is to develop novel CdTe detectors and obtain spectrum-per-pixel information that make the distinction between different radiation types and tissues possible. To evaluate the defect density inside the crystals -- which can deteriorate the detector performance -- we employ infrared microscopy (IRM). Posterior data analysis allows us to visualise the defect distributions as 3D defect maps. Additionally, we investigate front and backside differences of the material with current-voltage (IV) measurements to determine the preferred surface for the pixelisation of the crystal, and perform test measurements with the prototypes to provide feedback for further processing. We present the different parts of our quality assessment chain and will close with first experimental results obtained with one of our prototype PC detectors in a small tomographic setup.

physics.ins-det↗

arXiv2021

Employing infrared microscopy (IRM) in combination with a pre-trained neural network to visualise and analyse the defect distribution in Cadmium Telluride crystals

While Cadmium Telluride (CdTe) excels in terms of photon radiation absorption properties and outperforms silicon (Si) in this respect, the crystal growth, characterization and processing into a radiation detector is much more complicated. Additionally, large concentrations of extended crystallographic defects, such as grain boundaries, twins, and tellurium (Te) inclusions, vary from crystal to crystal and can reduce the spectroscopic performance of the processed detector. A quality assessment of the material prior to the complex fabrication process is therefore crucial. To locate the Te-defects, we scan the crystals with infrared microscopy (IRM) in different layers, obtaining a 3D view of the defect distribution. This provides us with important information on the defect density and locations of Te inclusions, and thus a handle to assess the quality of the material. For the classification of defects in the large amount of IRM image data, a convolutional neural network is employed. From the post-processed and analysed IRM data, 3D defect maps of the CdTe crystals are created, which make different patterns of defect agglomerations inside the crystals visible. In total, more than 100 crystals were scanned with the current IRM setup. In this paper, we compare two crystal batches, each consisting of 12 samples. We find significant differences in the defect distributions of the crystals.

physics.ins-det↗

arXiv2020

Multispectral Photon-Counting for Medical Imaging and Beam Characterization

We present the current status of our project of developing a photon counting detector for medical imaging. An example motivation lays in producing a monitoring and dosimetry device for boron neutron capture therapy, currently not commercially available. Our approach combines in-house developed detectors based on cadmium telluride or thick silicon with readout chip technology developed for particle physics experiments at CERN. Here we describe the manufacturing process of our sensors as well as the processing steps for the assembly of first prototypes. The prototypes use currently the PSI46digV2.1-r readout chip. The accompanying readout electronics chain that was used for first measurements will also be discussed. Finally we present an advanced algorithm developed by us for image reconstruction using such photon counting detectors with focus on boron neutron capture therapy. This work is conducted within a consortium of Finnish research groups from Helsinki Institute of Physics, Aalto University, Lappeenranta-Lahti University of Technology LUT and Radiation and Nuclear Safety Authority (STUK) under the RADDESS program of Academy of Finland. Keywords: Solid state detectors, X-ray detectors, Gamma detectors, Neutron detectors, Instrumentation for hadron therapy, Medical-image reconstruction methods and algorithms.

physics.ins-det↗

arXiv2017

Test Beam Performance Measurements for the Phase I Upgrade of the CMS Pixel Detector

A new pixel detector for the CMS experiment was built in order to cope with the instantaneous luminosities anticipated for the Phase~I Upgrade of the LHC. The new CMS pixel detector provides four-hit tracking with a reduced material budget as well as new cooling and powering schemes. A new front-end readout chip mitigates buffering and bandwidth limitations, and allows operation at low comparator thresholds. In this paper, comprehensive test beam studies are presented, which have been conducted to verify the design and to quantify the performance of the new detector assemblies in terms of tracking efficiency and spatial resolution. Under optimal conditions, the tracking efficiency is $99.95\pm0.05\,\%$, while the intrinsic spatial resolutions are $4.80\pm0.25\,μ\mathrm{m}$ and $7.99\pm0.21\,μ\mathrm{m}$ along the $100\,μ\mathrm{m}$ and $150\,μ\mathrm{m}$ pixel pitch, respectively. The findings are compared to a detailed Monte Carlo simulation of the pixel detector and good agreement is found.

physics.ins-det↗

arXiv2015

Processing and characterization of epitaxial GaAs radiation detectors

GaAs devices have relatively high atomic numbers (Z=31, 33) and thus extend the X-ray absorption edge beyond that of Si (Z=14) devices. In this study, radiation detectors were processed on GaAs substrates with 110 $μ\textrm{m}$ - 130 $μ\textrm{m}$ thick epitaxial absorption volume. Thick undoped and heavily doped p$^+$ epitaxial layers were grown using a custom-made horizontal Chloride Vapor Phase Epitaxy (CVPE) reactor, the growth rate of which was about 10 $μ\textrm{m}$/h. The GaAs p$^+$/i/n$^+$ detectors were characterized by Capacitance Voltage ($CV$), Current Voltage ($IV$), Transient Current Technique (TCT) and Deep Level Transient Spectroscopy (DLTS) measurements. The full depletion voltage ($V_{\textrm{fd}}$) of the detectors with 110 $μ\textrm{m}$ epi-layer thickness is in the range of 8 V - 15 V and the leakage current density is about 10 nA/cm$^2$. The signal transit time determined by TCT is about 5 ns when the bias voltage is well above the value that produces the peak saturation drift velocity of electrons in GaAs at a given thickness. Numerical simulations with an appropriate defect model agree with the experimental results.

physics.ins-det↗

arXiv2009

Reversible switching of surface texture by hydrogen intercalation

The interaction of atomic hydrogen with a single layer of hexagonal boron nitride on rhodium leads to a removal of the h-BN surface corrugation. The process is reversible as the hydrogen may be expelled by annealing to about 500 K whereupon the texture on the nanometer scale is restored. This effect is traced back to hydrogen intercalation. It is expected to have implications for applications, like the storage of hydrogen, the peeling of sp2-hybridized layers from solid substrates or the control of the wetting angle, to name a few.

cond-mat.mes-hall↗

arXiv2009

Magnetism in Re-based ferrimagnetic double perovskites

We have investigated spin and orbital magnetic moments of the Re 5d ion in the double perovskites A2FeReO6 (A = Ba, Sr, Ca) by X-ray magnetic circular dichroism (XMCD) at the Re L(2,3) edges. In these ferrimagnetic compounds an unusually large negative spin and positive orbital magnetic moment at the Re atoms was detected. The presence of a finite spin magnetic moment in a 'non-magnetic' double perovskite as observed in the double perovskite Sr2ScReO6 proves that Re has also a small, but finite intrinsic magnetic moment. We further show for the examples of Ba and Ca that the usually neglected alkaline earth ions undoubtedly also contribute to the magnetism in the ferrimagnetic double perovskites.

cond-mat.mtrl-sci↗

arXiv2008

Superconductivity phase diagrams of electron doped cuprates R(2-x)CexCuO4 (R = La, Pr, Nd, Sm, and Eu)

The superconductivity phase diagrams of electron doped cuprates of the form R(2-x)CexCuO4 (with R= La, Pr, Nd, Sm, and Eu) have been determined for cerium compositions 0 < x < 0.36 in a consistent series of epitaxial thin films grown by reactive molecular beam epitaxy (MBE). The use of epitaxial thin films allows the growth of materials away from thermodynamical equilibrium expanding the accessible phase space beyond the availability of bulk material. The superconducting phase space systematically increases with the rare earth ionic size. The doping concentration where the maximal transition temperature occurs in La(2-x)CexCuO4 is considerably shifted to lower doping (x ~ 0.09) compared to La(2-x)SrxCuO4 (x ~ 0.15). At the same time, the width of the superconducting region is broadened.

cond-mat.supr-con↗

arXiv2007

Sr2CrOsO6: Endpoint of a spin polarized metal-insulator transition by 5d band filling

In the search for new spintronic materials with high spin-polarization at room-temperature, we have synthesized an osmium based double perovskite with a Curie-temperature of 725 K. Our combined experimental results confirm the existence of a sizable induced magnetic moment at the Os site, supported by band-structure calculations in agreement with a proposed kinetic energy driven mechanism of ferrimagnetism in these compounds. The intriguing property of Sr2CrOsO6 is that it is at the endpoint of a metal-insulator transition due to 5d band filling, and at the same time ferrimagnetism and high-spin polarization is preserved.

cond-mat.str-el↗

arXiv2002

The importance of intermediate range order in silicates: molecular dynamics simulation studies

We present the results of large scale computer simulations in which we investigate the structural and dynamic properties of silicate melts with the compositions (Na_2O)2(SiO_2) and (Al_2O_3)2(SiO_2). In order to treat such systems on a time scale of several nanoseconds and for system sizes of several thousand atoms it is necessary to use parallel supercomputers like the CRAY T3E. We show that the silicates under consideration exhibit additional intermediate range order as compared to silica (SiO_2) where the characteristic intermediate length scales stem from the tetrahedral network structure. For the sodium silicate system it is demonstrated that the latter structural features are intimately connected with a surprising dynamics in which the one--particle motion of the sodium ions appears on a much smaller time scale than the correlations between different sodium ions.

cond-mat.stat-mech↗

arXiv2000

Molecular mode-coupling theory applied to a liquid of diatomic molecules

We study the molecular mode coupling theory for a liquid of diatomic molecules. The equations for the critical tensorial nonergodicity parameters ${\bf F}_{ll'}^m(q)$ and the critical amplitudes of the $β$ - relaxation ${\bf H}_{ll'}^m(q)$ are solved up to a cut off $l_{co}$ = 2 without any further approximations. Here $l,m$ are indices of spherical harmonics. Contrary to previous studies, where additional approximations were applied, we find in agreement with simulations, that all molecular degrees of freedom vitrify at a single temperature $T_c$. The theoretical results for the non ergodicity parameters and the critical amplitudes are compared with those from simulations. The qualitative agreement is good for all molecular degrees of freedom. To study the influence of the cut off on the non ergodicity parameter, we also calculate the non ergodicity parameters for an upper cut off $l_{co}=4$. In addition we also propose a new method for the calculation of the critical nonergodicity parameter

cond-mat.dis-nn↗