SearcharxivSearch

arXiv subjects

Aaron Hardy

Publications and source records attributed to Aaron Hardy.

3 recordsLinked to original sources

Band alignment of grafted diamond/GaN p-n heterojunctions interfaced with ALD Al2O3 and SiNx/Al2O3

Diamond and gallium nitride are complementary semiconductors for forming p-n junctions because of their respective doping limitations. Understanding the band alignment of grafted diamond/GaN heterojunctions is therefore essential for optimizing diode performance. In this study, the band alignment of diamond/Al2O3/GaN and diamond/Al2O3/SiNx/GaN heterostructures was determined by X-ray photoelectron spectroscopy. Both structures exhibit type-II band alignment, but with different band offsets. The band offsets of the diamond/Al2O3/SiNx/GaN heterojunction are larger by 0.42 eV than those of diamond/Al2O3/GaN. This difference is attributed to a modification of the interfacial electrostatic potential, which may arise from a reduced density of positive fixed charges in the interfacial dielectric near the diamond/Al2O3 interface after insertion of the SiNx layer. These results demonstrate that interfacial-layer engineering provides an effective strategy for tailoring the band alignment of grafted diamond/GaN heterojunctions, offering guidance for the design of p-n diodes with tunable rectifying characteristics.

cond-mat.mtrl-sci

Preliminary Demonstration of Diamond-GaN pn Diodes via Grafting

Ultrawide bandgap (UWBG) semiconductors exhibit exceptional electrical and thermal properties, offering strong potential for high power and high frequency electronics. However, efficient doping in UWBG materials is typically limited to either n type or p type, constraining their application to unipolar devices. The realization of pn junctions through heterogeneous integration of complementary UWBG or WBG semiconductors is hindered by lattice mismatch and thermal expansion differences. Here, we report the preliminary demonstration of diamond GaN heterojunction pn diodes fabricated via grafting. A single crystalline p plus diamond nanomembrane was integrated onto an epitaxially grown c plane n plus GaN substrate with an ultrathin ALD Al2O3 interlayer. The resulting diodes exhibit an ideality factor of 1.55 and a rectification ratio of over 1e4. Structural and interfacial properties were examined by AFM, XRD, Raman, and STEM, providing critical insights to guide further optimization of diamond GaN pn heterojunction devices.

cond-mat.mtrl-sci

The Effects of Boron Doping on the Bulk and Surface Acoustic Phonons in Single-Crystal Diamond

We report the results of the investigation of bulk and surface acoustic phonons in the undoped and boron-doped single-crystal diamond films using the Brillouin-Mandelstam light scattering spectroscopy. The evolution of the optical phonons in the same set of samples was monitored with Raman spectroscopy. It was found that the frequency and the group velocity of acoustic phonons decrease non-monotonically with the increasing boron doping concentration, revealing pronounced phonon softening. The change in the velocity of the shear horizontal and the high-frequency pseudo-longitudinal acoustic phonons in the degenerately doped diamond, as compared to the undoped diamond, was as large as ~15% and ~12%, respectively. As a result of boron doping, the velocity of the bulk longitudinal and transverse acoustic phonons decreased correspondingly. The frequency of the optical phonons was unaffected at low boron concentration but experienced a strong decrease at the high doping level. The density-functional-theory calculations of the phonon band structure for the pristine and highly-doped sample confirm the phonon softening as a result of boron doping in diamond. The obtained results have important implications for thermal transport in heavily doped diamond, which is a promising material for ultra-wide-band-gap electronics.

cond-mat.mtrl-sci