arXiv subjects

Adam Nepomuk Otte

Publications and source records attributed to Adam Nepomuk Otte.

4 recordsLinked to original sources

arXiv2019

Studies of an air-shower imaging system for the detection of ultrahigh-energy neutrinos

We discuss the acceptance and sensitivity of a small air-shower imaging system to detect earth-skimming ultrahigh-energy tau neutrinos. The instrument we study is located on top of a mountain and has an azimuthal field of view of $360^\circ$. We find that the acceptance and sensitivity of such a system is close to maximal if it is located about 2 km above ground, has a vertical field of view of $5^\circ$, allows the reconstruction of an at least $0.3^\circ$ long air-shower image, and features an effective light-collection area of $10$ m$^2$ in any direction. After three years of operation, an imaging system with these features achieves an all-flavor neutrino flux sensitivity of $5\times10^{-9}$ GeV cm$^{-2}$ s$^{-1}$ sr$^{-1}$ at $2\times10^8$ GeV.

astro-ph.IM↗

arXiv2018

Locating the avalanche structure and the origin of breakdown generating charge carriers in silicon photomultipliers by using the bias dependent breakdown probability

We present characterization results of two silicon photomultipliers; the Hamamatsu LVR-6050-CN and the Ketek PM3325 WB. With our measurements of the bias dependence of the breakdown probability we are able to draw conclusions about the location and spatial extension of the avalanche region. For the KETEK SiPM we find that the avalanche region is located close to the surface. In the Hamamatsu SiPM the high-field region is located $0.5\,μ$m below the surface, while the volume above is depleted almost until the surface. Furthermore, for the Hamamatsu SiPM we find that charge carriers produced by optical-crosstalk photons enter a cell below the avalanche region as opposed to an earlier device where most of the photons enter a cell from above. In the here tested Hamamatsu device the crosstalk photons probably absorb in the bulk and the generated holes diffuse into the active volume of the cell within 2\,ns and initiate a breakdown. The present paper is an attempt to spur further interest in the use of the bias dependence of the breakdown probability and establish it as a standard tool not only to determine the location of the high-field region but also to determine the origin of charge carriers relative to the high-field region. With the knowledge of where the charges come from it should be possible to further improve the optical crosstalk, dark count, and afterpulsing characteristics of SiPM.

physics.ins-det↗

arXiv2017

Characterization of Three High Efficiency and Blue Sensitive Silicon Photomultipliers

We report about the optical and electrical characterization of three high efficiency and blue sensitive Silicon photomultipliers from FBK, Hamamatsu, and SensL. Key features of the tested devices when operated at 90% breakdown probability are peak photon detection efficiencies between 40% and 55%, temperature dependencies of gain and PDE that are less than 1%/$^{\circ}$C, dark rates of $\sim$50\,kHz/mm$^{2}$ at room temperature, afterpulsing of about 2%, and direct optical crosstalk between 6% and 20%. The characteristics of all three devices impressively demonstrate how the Silicon-photomultiplier technology has improved over the past ten years. It is further demonstrated how the voltage and temperature characteristics of a number of quantities can be parameterized on the basis of physical models. The models provide a deeper understanding of the device characteristics over a wide bias and temperature range. They also serve as examples how producers could provide the characteristics of their SiPMs to users. A standardized parameterization of SiPMs would enable users to find the optimal SiPM for their application and the operating point of SiPMs without having to perform measurements thus significantly reducing design and development cycles.

physics.ins-det↗

arXiv2016

FIPSER: Performance Study of a Readout Concept With Few Digitization Levels for Fast Signals

We discuss the performance of a readout system, Fixed Pulse Shape Efficient Readout (FIPSER), to digitize signals from detectors with a fixed pulse shape. In this study we are mainly interested in the readout of fast photon detectors like photomultipliers or Silicon photomultipliers. But the concept can be equally applied to the digitization of other detector signals. FIPSER is based on the flash analog to digital converter (FADC) concept, but has the potential to lower costs and power consumption by using an order of magnitude fewer discrete voltage levels. Performance is bolstered by combining the discretized signal with the knowledge of the underlying pulse shape. Simulated FIPSER data was reconstructed with two independent methods. One using a maximum likelihood method and the other using a modified chisquared test. Both methods show that utilizing 12 discrete voltage levels with a sampling rate of 4 samples per full width half maximum (FWHM) of the pulse achieves an amplitude resolution that is better than the Poisson limit for photon-counting experiments. The time resolution achieved in this configuration ranges between 0.02 - 0.16 FWHM and depends on the pulse amplitude. In a situation where the waveform is composed of two consecutive pulses the pulses can be separated if they are at least 0.05 - 0.30 FWHM apart with an amplitude resolution that is better than 20%.

physics.ins-det↗