arXiv subjects

Alan T. Johnson

Publications and source records attributed to Alan T. Johnson.

3 recordsLinked to original sources

arXiv2007

Dielectrophoretically Assembled Polymer Nanowires for Gas Sensing

We measured the electronic properties and gas sensing response of nanowires containing segments of poly(3,4-ethylenedioxythiophene)/poly(styrenesulfonate) (PEDOT/PSS) that were synthesized using anodic aluminum oxide (AAO) membranes. The nanowires have a "striped" structure of gold-PEDOT/PSS-gold and are typically 8 um long (1 um-6 um-1 um for each section, respectively) and 220 nm in diameter. Dielectrophoretic assembly was used to position single nanowires on pre-fabricated gold electrodes. A polymer conductivity of 11.5 +/- 0.7 S/cm and a contact resistance of 27.6 +/- 4 kOhm were inferred from resistance measurements of nanowires of varying length and diameter. When used as gas sensors, the wires showed a resistance change of 10.5%, 9%, and 4% at the saturation vapor pressure of acetone, methanol and ethanol, respectively. Sensor response and recovery were rapid (seconds) with excellent reproducibility in time and across devices. "Striped" template-grown nanowires are thus intriguing candidates for use in electronic nose vapor sensing systems.

cond-mat.mtrl-sci↗

arXiv2005

Electronic Devices Based on Purified Carbon Nanotubes Grown By High Pressure Decomposition of Carbon Monoxide

The excellent properties of transistors, wires, and sensors made from single-walled carbon nanotubes (SWNTs) make them promising candidates for use in advanced nanoelectronic systems. Gas-phase growth procedures such as the high pressure decomposition of carbon monoxide (HiPCO) method yield large quantities of small diameter semiconducting SWNTs, which are ideal for use in nanoelectronic circuits. As-grown HiPCO material, however, commonly contains a large fraction of carbonaceous impurities that degrade properties of SWNT devices. Here we demonstrate a purification, deposition, and fabrication process that yields devices consisting of metallic and semiconducting nanotubes with electronic characteristics vastly superior to those of circuits made from raw HiPCO. Source-drain current measurements on the circuits as a function of temperature and backgate voltage are used to quantify the energy gap of semiconducting nanotubes in a field effect transistor geometry. This work demonstrates significant progress towards the goal of producing complex integrated circuits from bulk-grown SWNT material.

cond-mat.mes-hall↗

arXiv1998

STM Studies of Synthetic Peptide Monolayers

We have used scanning probe microscopy to investigate self-assembled monolayers of chemically synthesized peptides. We find that the peptides form a dense uniform monolayer, above which is found a sparse additional layer. Using scanning tunneling microscopy, submolecular resolution can be obtained, revealing the alpha helices which constitute the peptide. The nature of the images is not significantly affected by the incorporation of redox cofactors (hemes) in the peptides.

cond-mat.soft↗