arXiv subjects

Alastair G. Basden

Publications and source records attributed to Alastair G. Basden.

4 recordsLinked to original sources

arXiv2021

On-sky results for the novel integrated micro-lens ring tip-tilt sensor

We present the first on-sky results of the micro-lens ring tip-tilt (MLR-TT) sensor. This sensor utilizes a 3D printed micro-lens ring feeding six multi-mode fibers to sense misaligned light, allowing centroid reconstruction. A tip-tilt mirror allows the beam to be corrected, increasing the amount of light coupled into a centrally positioned single-mode (science) fiber. The sensor was tested with the iLocater acquisition camera at the Large Binocular Telescope in November 2019. The limit on the maximum achieved root mean square reconstruction accuracy was found to be 0.19 $λ$/D in both tip and tilt, of which approximately 50% of the power originates at frequencies below 10 Hz. We show the reconstruction accuracy is highly dependent on the estimated Strehl ratio and simulations support the assumption that residual adaptive optics aberrations are the main limit to the reconstruction accuracy. We conclude that this sensor is ideally suited to remove post-adaptive optics non-common path tip tilt residuals. We discuss the next steps for the concept development, including optimizations of the lens and fiber, tuning of the correction algorithm and selection of optimal science cases.

astro-ph.IM↗

arXiv2019

A many-core CPU prototype of an MCAO and LTAO RTC for ELT-scale instruments

We propose a many-core CPU architecture for Extremely Large Telescope (ELT) scale adaptive optics (AO) real-time control (RTC) for the multi-conjugate AO (MCAO) and laser-tomographic AO (LTAO) modes. MCAO and LTAO differ from the more conventional single-conjugate (SCAO) mode by requiring more wavefront sensor (WFS) measurements and more deformable mirrors to achieve a wider field of correction, further increasing the computational requirements of ELT-scale AO. We demonstrate results of our CPU based AO RTC operating firstly in SCAO mode, using either Shack-Hartmann or Pyramid style WFS processing, and then in MCAO mode and in LTAO mode using the specifications of the proposed ELT instruments, MAORY and HARMONI. All results are gathered using a CPU based camera simulator utilising UDP packets to better demonstrate the pixel streaming and pipe-lining of the RTC software. We demonstrate the effects of switching parameters, streaming telemetry and implicit pseudo open-loop control (POLC) computation on the MCAO and LTAO modes. We achieve results of < 600$μ$s latency with an ELT scale SCAO setup using Shack-Hartman processing and < 800$μ$s latency with SCAO Pyramid WFS processing. We show that our MCAO and LTAO many core CPU architecture can achieve full system latencies of < 1000$μ$s with jitters < 40$μ$s RMS. We find that a CPU based AO RTC architecture has a good combination of performance, flexibility and maintainability for ELT-scale AO systems.

astro-ph.IM↗

arXiv2015

Efficient photonic reformatting of celestial light for diffraction-limited spectroscopy

The spectral resolution of a dispersive astronomical spectrograph is limited by the trade-off between throughput and the width of the entrance slit. Photonic guided-wave transitions have been proposed as a route to bypass this trade-off, by enabling the efficient reformatting of incoherent seeing-limited light collected by the telescope into a linear array of single modes: a pseudo-slit which is highly multimode in one axis but diffraction-limited in the dispersion axis of the spectrograph. It is anticipated that the size of a single-object spectrograph fed with light in this manner would be essentially independent of the telescope aperture size. A further anticipated benefit is that such spectrographs would be free of `modal noise', a phenomenon that occurs in high-resolution multimode fibre-fed spectrographs due to the coherent nature of the telescope point-spread-function (PSF). We address these aspects by integrating a multicore fibre photonic lantern with an ultrafast laser inscribed three-dimensional waveguide interconnect to spatially reformat the modes within the PSF into a diffraction-limited pseudo-slit. Using the CANARY adaptive optics (AO) demonstrator on the William Herschel Telescope, and 1530 $\pm$ 80 nm stellar light, the device is found to exhibit a transmission of 47-53 % depending upon the mode of AO correction applied. We also show the advantage of using AO to couple light into such a device by sampling only the core of the CANARY PSF. This result underscores the possibility that a fully-optimised guided-wave device can be used with AO to provide efficient spectroscopy at high spectral resolution.

astro-ph.IM↗

arXiv2015

Photonic spatial reformatting of stellar light for diffraction-limited spectroscopy

The spectral resolution of a dispersive spectrograph is dependent on the width of the entrance slit. This means that astronomical spectrographs trade-off throughput with spectral resolving power. Recently, optical guided-wave transitions known as photonic lanterns have been proposed to circumvent this trade-off, by enabling the efficient reformatting of multimode light into a pseudo-slit which is highly multimode in one axis, but diffraction-limited in the other. Here, we demonstrate the successful reformatting of a telescope point spread function into such a slit using a three-dimensional integrated optical waveguide device, which we name the photonic dicer. Using the CANARY adaptive optics demonstrator on the William Herschel Telescope, and light centred at 1530 nm with a 160 nm FWHM, the device shows a transmission of between 10 and 20\% depending upon the type of AO correction applied. Most of the loss is due to the overfilling of the input aperture in poor and moderate seeing. Taking this into account, the photonic device itself has a transmission of 57 $\pm$ 4\%.We show how a fully-optimised device can be used with AO to provide efficient spectroscopy at high spectral resolution.

astro-ph.IM↗