arXiv subjects

Alberto Beccari

Publications and source records attributed to Alberto Beccari.

9 recordsLinked to original sources

arXiv2024

Motional sideband asymmetry of a solid-state mechanical resonator at room temperature

The motional sideband asymmetry of a mechanical oscillator interacting with a laser field can be observed when approaching the quantum ground state, where the zero-point energy of the mechanical oscillator becomes a sizable contribution to its motion. In the context of quantum optomechanics, it allows, in principle, calibration-free inference of the thermal equilibrium of a macroscopic mechanical resonator with its optical bath. At room temperature, this phenomenon has been observed in pioneering experiments using levitated nanoparticles. Measuring this effect with solid-state mechanical resonators has been compounded by thermal intermodulation noise, mirror frequency noise and low quantum cooperativity. Here, we sideband-cool a membrane-in-the-middle system close to the quantum ground state from room temperature, and observe motional sideband asymmetry in a dual-homodyne measurement. Sideband thermometry yields a minimum phonon occupancy of $\bar{n}_{eff}=9.5$. Our work provides insights into nonlinear optomechanical dynamics at room temperature and facilitates accessible optomechanical quantum technologies without the need for complex feedback control and cryogenic cooling.

quant-ph↗

arXiv2023

Room-temperature quantum optomechanics using an ultra-low noise cavity

Ponderomotive squeezing of light, where a mechanical oscillator creates quantum correlations between the phase and amplitude of the interacting light field, is a canonical signature of the quantum regime of optomechanics. At room temperature, this has only been reached in pioneering experiments where an optical restoring force controls the oscillator stiffness, akin to the vibrational motion of atoms in an optical lattice. These include both levitated nanoparticles and optically-trapped cantilevers. Recent advances in engineered mechanical resonators, where the restoring force is provided by material rigidity rather than an external optical potential, have realized ultra-high quality factors (Q) by exploiting `soft clamping'. However entering the quantum regime with such resonators, has so far been prevented by optical cavity frequency fluctuations and thermal intermodulation noise. Here, we overcome this challenge and demonstrate optomechanical squeezing at room temperature in a phononic-engineered membrane-in-the-middle system. By using a high finesse cavity whose mirrors are patterned with phononic crystal structures, we reduce cavity frequency noise by more than 700-fold. In this ultra-low noise cavity, we introduce a silicon nitride membrane oscillator whose density is modulated by silicon nano-pillars, yielding both high thermal conductance and a localized mechanical mode with Q of 1.8e8. These advances enable operation within a factor of 2.5 of the Heisenberg limit, leading to squeezing of the probing field by 1.09 dB below the vacuum fluctuations. Moreover, the long thermal decoherence time of the membrane oscillator (more than 30 vibrational periods) allows us to obtain conditional displaced thermal states of motion with an occupation of 0.97 phonon, using a multimode Kalman filter. Our work extends quantum control of engineered macroscopic oscillators to room temperature.

quant-ph↗

arXiv2021

Nanomechanical resonators with ultra-high-$Q$ perimeter modes

Systems with low mechanical dissipation are extensively used in precision measurements such as gravitational wave detection, atomic force microscopy and quantum control of mechanical oscillators via opto- and electromechanics. The mechanical quality factor ($Q$) of these systems determines the thermomechanical force noise and the thermal decoherence rate of mechanical quantum states. While the dissipation rate is typically set by the bulk acoustic properties of the material, by exploiting dissipation dilution, mechanical $Q$ can be engineered through geometry and increased by many orders of magnitude. Recently, soft clamping in combination with strain engineering has enabled room temperature quality factors approaching one billion ($10^9$) in millimeter-scale resonators. Here we demonstrate a new approach to soft clamping which exploits vibrations in the perimeter of polygon-shaped resonators tethered at their vertices. In contrast to previous approaches, which rely on cascaded elements to achieve soft clamping, perimeter modes are soft clamped due to symmetry and the boundary conditions at the polygon vertices. Perimeter modes reach $Q$ of 3.6 billion at room temperature while spanning only two acoustic wavelengths -- a 4-fold improvement over the state-of-the-art mechanical $Q$ with 10-fold smaller devices. The small size of our devices makes them well-suited for near-field integration with microcavities for quantum optomechanical experiments. Moreover, their compactness allows the realization of phononic lattices. We demonstrate a one-dimensional Su-Schrieffer-Heeger chain of high-$Q$ perimeter modes coupled via nearest-neighbour interaction and characterize the localized edge modes.

physics.app-ph↗

arXiv2021

Strained crystalline nanomechanical resonators with ultralow dissipation

In strained mechanical resonators, the concurrence of tensile stress and geometric nonlinearity dramatically reduces dissipation. This phenomenon, dissipation dilution, is employed in mirror suspensions of gravitational wave interferometers and at the nanoscale, where soft-clamping and strain engineering have allowed extremely high quality factors. However, these techniques have so far only been applied in amorphous materials, specifically silicon nitride. Crystalline materials exhibit significantly lower intrinsic damping at cryogenic temperatures, due to the absence of two level systems in the bulk, as exploited in Weber bars and silicon optomechanical cavities. Applying dissipation dilution engineering to strained crystalline materials could therefore enable extremely low loss nanomechanical resonators, due to the combination of reduced internal friction, high intrinsic strain, and high yield strength. Pioneering work has not yet fully exploited this potential. Here, we demonstrate that single crystal strained silicon, a material developed for high mobility transistors, can be used to realize mechanical resonators with ultralow dissipation. We observe that high aspect ratio ($>10^5$) strained silicon nanostrings support MHz mechanical modes with quality factors exceeding $10^{10}$ at 7 K, a tenfold improvement over values reported in silicon nitride. At 7 K, the thermal noise-limited force sensitivity is approximately $45\ \mathrm{{zN}/{\sqrt{Hz}}}$ - approaching that of carbon nanotubes - and the heating rate is only 60 quanta-per-second. Our nanomechanical resonators exhibit lower dissipation than the most pristine macroscopic oscillators and their low mass makes them particularly promising for quantum sensing and transduction.

cond-mat.mes-hall↗

arXiv2021

Microwave-to-optical conversion with a gallium phosphide photonic crystal cavity

Electrically actuated optomechanical resonators provide a route to quantum-coherent, bidirectional conversion of microwave and optical photons. Such devices could enable optical interconnection of quantum computers based on qubits operating at microwave frequencies. Here we present a novel platform for microwave-to-optical conversion comprising a photonic crystal cavity made of single-crystal, piezoelectric gallium phosphide integrated on pre-fabricated niobium circuits on an intrinsic silicon substrate. The devices exploit spatially extended, sideband-resolved mechanical breathing modes at $\sim$ 3.2 GHz, with vacuum optomechanical coupling rates of up to $g_0/2\pi \approx$ 300 kHz. The mechanical modes are driven by integrated microwave electrodes via the inverse piezoelectric effect. We estimate that the system could achieve an electromechanical coupling rate to a superconducting transmon qubit of $\sim$ 200 kHz. Our work represents a decisive step towards integration of piezoelectro-optomechanical interfaces with superconducting quantum processors.

physics.optics↗

arXiv2021

Hierarchical tensile structures with ultralow mechanical dissipation

Structural hierarchy is found in myriad biological systems and has improved man-made structures ranging from the Eiffel tower to optical cavities. Hierarchical metamaterials utilize structure at multiple size scales to realize new and highly desirable properties which can be strikingly different from those of the constituent materials. In mechanical resonators whose rigidity is provided by static tension, structural hierarchy can reduce the dissipation of the fundamental mode to ultralow levels due to an unconventional form of soft clamping. Here, we apply hierarchical design to silicon nitride nanomechanical resonators and realize binary tree-shaped resonators with quality factors as high as $10^9$ at 107 kHz frequency, reaching the parameter regime of levitated particles. The resonators' thermal-noise-limited force sensitivities reach $740\ \mathrm{zN/\sqrt{Hz}}$ at room temperature and $\mathrm{90\ zN/\sqrt{Hz}}$ at 6 K, surpassing state-of-the-art cantilevers currently used for force microscopy. We also find that the self-similar structure of binary tree resonators results in fractional spectral dimensions, which is characteristic of fractal geometries. Moreover, we show that the hierarchical design principles can be extended to 2D trampoline membranes, and we fabricate ultralow dissipation membranes suitable for interferometric position measurements in Fabry-P\'erot cavities. Hierarchical nanomechanical resonators open new avenues in force sensing, signal transduction and quantum optomechanics, where low dissipation is paramount and operation with the fundamental mode is often advantageous.

cond-mat.mes-hall↗

arXiv2020

Thermal intermodulation noise in cavity-based measurements

Thermal frequency fluctuations in optical cavities limit the sensitivity of precision experiments ranging from gravitational wave observatories to optical atomic clocks. Conventional modeling of these noises assumes a linear response of the optical field to the fluctuations of cavity frequency. Fundamentally, however, this response is nonlinear. Here we show that nonlinearly transduced thermal fluctuations of cavity frequency can dominate the broadband noise in photodetection, even when the magnitude of fluctuations is much smaller than the cavity linewidth. We term this noise "thermal intermodulation noise" and show that for a resonant laser probe it manifests as intensity fluctuations. We report and characterize thermal intermodulation noise in an optomechanical cavity, where the frequency fluctuations are caused by mechanical Brownian motion, and find excellent agreement with our developed theoretical model. We demonstrate that the effect is particularly relevant to quantum optomechanics: using a phononic crystal $Si_3N_4$ membrane with a low mass, soft-clamped mechanical mode we are able to operate in the regime where measurement quantum backaction contributes as much force noise as the thermal environment does. However, in the presence of intermodulation noise, quantum signatures of measurement are not revealed in direct photodetectors. The reported noise mechanism, while studied for an optomechanical system, can exist in any optical cavity.

physics.optics↗

arXiv2019

Fractal-like mechanical resonators with soft-clamped fundamental mode

Self-similar structures occur naturally and have been employed to engineer exotic physical properties. Here we show that acoustic modes of a fractal-like system of tensioned strings can display increased mechanical quality factors due to the enhancement of dissipation dilution. We describe a realistic resonator design in which the quality factor of the fundamental mode is enhanced by as much as two orders of magnitude compared to a simple string with the same size and tension. Our findings can open new avenues in force sensing, cavity quantum optomechanics and experiments with suspended test masses.

cond-mat.mes-hall↗

arXiv2018

Clamp-tapering increases the quality factor of stressed nanobeams

Stressed nanomechanical resonators are known to have exceptionally high quality factors ($Q$) due to the dilution of intrinsic dissipation by stress. Typically, the amount of dissipation dilution and thus the resonator $Q$ is limited by the high mode curvature region near the clamps. Here we study the effect of clamp geometry on the $Q$ of nanobeams made of high-stress $\mathrm{Si_3N_4}$. We find that tapering the beam near the clamp - and locally increasing the stress - leads to increased $Q$ of MHz-frequency low order modes due to enhanced dissipation dilution. Contrary to recent studies of tethered-membrane resonators, we find that widening the clamps leads to decreased $Q$ despite increased stress in the beam bulk. The tapered-clamping approach has practical advantages compared to the recently developed "soft-clamping" technique. Tapered-clamping enhances the $Q$ of the fundamental mode and can be implemented without increasing the device size.

physics.app-ph↗