arXiv subjects

Alec L. Emser

Publications and source records attributed to Alec L. Emser.

4 recordsLinked to original sources

arXiv2025

TLS-induced thermal nonlinearity in a micro-mechanical resonator

We present experimental evidence of a thermally-driven amplitude-frequency nonlinearity in a thin-film quartz phononic crystal resonator at millikelvin temperatures. The nonlinear response arises from the coupling of the mechanical mode to an ensemble of microscopic two-level system defects driven out of equilibrium by a microwave drive. In contrast to the conventional Duffing oscillator, the observed nonlinearity exhibits a mixed reactive-dissipative character. Notably, the reactive effect can manifest as either a softening or hardening of the mechanical resonance, depending on the ratio of thermal to phonon energy. By combining the standard TLS theory with a thermal conductance model, the measured power-dependent response is quantitatively reproduced and readout-enhanced relaxation damping from off-resonant TLSs is identified as the primary mechanism limiting mechanical coherence. Within this framework, we delineate the conditions under which similar systems will realize this nonlinearity.

quant-ph↗

arXiv2024

Thin-film quartz for high-coherence piezoelectric phononic crystal resonators

Piezoelectric phononic crystal resonators (PCRs) are a promising platform for acoustic quantum processing, yet their performance is currently limited by coupling to an ensemble of saturable two-level system (TLS) defects within the resonator material. Motivated by its excellent bulk mechanical properties and high crystallinity, we address this by fabricating PCRs from a new substrate: thin-film quartz. At single-phonon powers and millikelvin temperatures -- requisite conditions for quantum phononic processing -- we demonstrate large internal mechanical quality factors, $Q_i > 160,000$. This represents an order of magnitude improvement in single-phonon lifetimes for piezoelectric PCR. We characterize the loss channels in these devices and find that, although improved, the low-power response is still limited by coupling to a TLS bath and that a significant portion of the TLSs are associated with the aluminum coupling electrodes. To explore the high-power response we perform ringdown measurements and demonstrate high-power quality factor-frequency products $Q_i \cdot f = 1.4 \times 10^{16}$ Hz.

quant-ph↗

arXiv2024

Annealing reduces Si$_3$N$_4$ microwave-frequency dielectric loss in superconducting resonators

The dielectric loss of silicon nitride (Si$_3$N$_4$) limits the performance of microwave-frequency devices that rely on this material for sensing, signal processing, and quantum communication. Using superconducting resonant circuits, we measure the cryogenic loss tangent of either as-deposited or high-temperature annealed stoichiometric Si$_3$N$_4$ as a function of drive strength and temperature. The internal loss behavior of the electrical resonators is largely consistent with the standard tunneling model of two-level systems (TLS), including damping caused by resonant energy exchange with TLS and by the relaxation of non-resonant TLS. We further supplement the TLS model with a self-heating effect to explain an increase in the loss observed in as-deposited films at large drive powers. Critically, we demonstrate that annealing remedies this anomalous power-induced loss, reduces the relaxation-type damping by more than two orders of magnitude, and reduces the resonant-type damping by a factor of three. Employing infrared absorption spectroscopy, we find that annealing reduces the concentration of hydrogen in the Si$_3$N$_4$, suggesting that hydrogen impurities cause substantial dissipation.

quant-ph↗

arXiv2022

Minimally-diffracting quartz for ultra-low temperature surface acoustic wave resonators

We simulate and experimentally demonstrate the existence of an orientation of quartz which minimizes diffraction losses in surface acoustic wave (SAW) resonators at ultra-low temperatures. The orientation is optimized for applications to quantum technologies which benefit from high mechanical quality factors, strong electromechanical coupling, and narrow acoustic apertures. We fabricate narrow aperture SAW resonators on this substrate and measure internal quality factors greater than 100,000 at mK temperatures.

quant-ph↗