arXiv subjects

Aleksey D. Drozdov

Publications and source records attributed to Aleksey D. Drozdov.

14 recordsLinked to original sources

arXiv2021

Thermal Transport in Graphene Composites: The Effect of Lateral Dimensions of Graphene Fillers

We report on the investigation of thermal transport in non-cured silicone composites with graphene fillers of different lateral dimensions. Graphene fillers are comprised of few-layer graphene flakes with lateral sizes in the range from 400 nm to 1200 nm and number of atomic planes from one to ~100. The distribution of the lateral dimensions and thicknesses of graphene fillers has been determined via atomic force microscopy statistics. It was found that in the examined range of the lateral dimensions the thermal conductivity of the composites increases with the increasing size of the graphene fillers. The observed difference in thermal properties can be related to the average gray phonon mean free path in graphene, which has been estimated to be around ~800 nm at room temperature. The thermal contact resistance of composites with graphene fillers of 1200-nm lateral dimensions was also smaller than that of composites with graphene fillers of 400-nm lateral dimensions. The effects of the filler loading fraction and the filler size on the thermal conductivity of the composites were rationalized within the Kanari model. The obtained results are important for optimization of graphene fillers for applications in thermal interface materials for heat removal from high-power-density electronics.

physics.app-ph↗

arXiv2001

A concept of polymeric networks with sliding junctions for the time-dependent response of filled elastomers

Constitutive equations are derived for the time-dependent behavior of particle-reinforced elastomers at isothermal loading with finite strains. A rubbery polymer is modelled as a network of macromolecules bridged by junctions which can slip with respect to the bulk material under straining. A filled elastomer is thought of as an ensemble of meso-regions where sliding occurs with different rates. Stress-strain relations for a particle-reinforced rubber are developed by using the laws of thermodynamics. For tensile relaxation tests, these equations are characterized by three adjustable parameters. To determine the experimental constants, three series of relaxation tests are performed for longitudinal strains in the range from 100 to 250 %. By fitting observations, the influence of pre-loading and thermal recovery is analyzed on the nonlinear viscoelastic response of natural rubber reinforced with carbon black.

cond-mat.mtrl-sci↗

arXiv2001

Finite viscoelasticity of filled rubbers: the effects of pre-loading and thermal recovery

Constitutive equations are derived for the viscoelastic behavior of filled elastomers at isothermal loading with finite strains. A particle-reinforced rubber is thought of as a composite where regions with low concentrations of junctions between chains are randomly distributed in the bulk material. The onset of these inclusions is associated with the inhomogeneity in spatial distribution of a cross-linker during the mixing process. With reference to the theory of transient networks, the time-dependent response of an elastomer is modelled as thermally activated processes of breakage and reformation of chains in domains with low concentrations of junctions, whereas junctions in the bulk medium are treated as permanent. Stress-strain relations are developed by using the laws of thermodynamics. Adjustable parameters in the constitutive equations are found by fitting experimental data in tensile relaxation tests for several grades of unfilled and carbon black filled natural rubber. It is demonstrated that (i) the average relaxation time noticeably grows with the elongation ratio, which is explained by mechanically-induced crystallization of strands, and (ii) the relaxation spectrum of a filled elastomer is not affected by mechanical pre-loading and thermal recovery at elevated temperatures.

cond-mat.mtrl-sci↗

arXiv2001

Finite viscoelasticity of filled rubbers: experiments and numerical simulation

Constitutive equations are derived for the viscoelastic behavior of particle-reinforced rubbers at isothermal loading with finite strains. A filled rubber is thought of as a composite medium where inclusions with high and low concentrations of junctions between chains are randomly distributed in a host matrix. The inclusions with high concentration of junctions are associated with regions of suppressed mobility of chains that surround isolated clusters of filler and its secondary network. The regions with low concentration of junctions arise during the mixing process due to the inhomogeneity in spatial distribution of a cross-linker. The viscoelastic response of elastomers is ascribed to the thermally activated processes of breakage and reformation of strands in the domains with low concentration of junctions. Stress-strain relations for particle-reinforced rubbers are developed by using the laws of thermodynamics. Adjustable parameters in the constitutive equations are found by fitting experimental data in tensile relaxation tests for several grades of unfilled and carbon black (CB) filled rubber. It is demonstrated that the relaxation rate is noticeably affected by strains. Unlike glassy polymers, where the growth of longitudinal strain results in an increase in the rate of relaxation, the growth of the elongation ratio for natural rubber (unfilled or CB reinforced) implies a decrease in the relaxation rate, which may be explained by partial crystallization of chains in the regions with low concentration of junctions.

cond-mat.mtrl-sci↗

arXiv2001

A tube concept in rubber viscoelasticity

A constitutive model is derived for the time-dependent response of particle-reinforced elastomers at finite strains. An amorphous rubbery polymer is treated as a network of long chains linked by permanent junctions (chemical crosslinks, entanglements and filler particles). A strand between two neighboring junctions is thought of as a sequence of mers whose motion is restricted to some tube by surrounding macromolecules. Unlike the conventional approach that presumes the cross-section of the tube to be constant, we postulate that its radius strongly depends on the longitudinal coordinate. This implies that a strand may be modeled as a sequence of segments whose thermal motion is totally frozen by the environment (bottle-neck points of the tube) bridged by threads of mers which go through all possible configurations during the characteristic time of a test. Thermal fluctuations affect the tube's radius, which results in freezing and activation of regions with high molecular mobility (RHMs). The viscoelastic response of an elastomer is associated with thermally activated changes in the number of RHMs in strands. Stress-strain relations for a rubbery polymer at finite strains and kinetic equations for the concentrations of RHMs are developed by using the laws of thermodynamics. At small strains these relations are reduced to the conventional integral constitutive equation in linear viscoelasticity with a novel scaling law for relaxation times. The governing equation is determined by 5 adjustable parameters which are found by fitting experimental data in tensile dynamic tests on a carbon black filled natural rubber vulcanizate.

cond-mat.soft↗

arXiv2001

The viscoelastic and anelastic responses of amorphous polymers in the vicinity of the glass transition temperature

The time-dependent response of polystyrene and poly(methyl methacrylate) is studied in isothermal long-term shear creep tests at small strains and various temperatures in the vicinity of the glass transition point. A micromechanical model is derived to describe the experimental results. Constitutive equations are developed under the assumption that the behavior of amorphous polymers is governed by two micro-mechanisms: rearrangement of cooperatively relaxing regions (CRR) reflects the viscoelastic response, whereas displacement of CRRs with respect to each other is responsible for the anelastic response. It is demonstrated that some critical temperature exists slightly above the glass transition temperature, where the dependences of adjustable parameters on temperature are dramatically changed. The critical temperature is associated with transition from dynamic heterogeneity in amorphous polymers to static inhomogeneity.

cond-mat.soft↗

arXiv2001

Stress-softening and recovery of elastomers

A constitutive model is developed for the mechanical response of elastomers at finite strains. A polymer is treated as a network of linear chains linked by permanent (chemical crosslinks) and temporary (entanglements and van der Waals forces) junctions. Temporary junctions are assumed to be in two states: loose (passive) when they impose only topological constrains on available configurations of chains, and tight (active) when their effect is tantamount to that for crosslinks. Stretching of a specimen implies that some loose junctions become active, which decreases the average length of a chain. A long chain is treated as an ensemble of inextensible strands connected in sequel. Two neighboring strands are bridged by a bond which may be in two conformations: flexed (trans) and extended (cis). A bond in the flexed conformation is modeled as a linear elastic solid, whereas the mechanical energy of a bond in the extended conformation (two rigid rods directed along a straight line) is disregarded. For a virgin specimen, all bonds are in the flexed conformation. Under loading some bonds are transformed from flexed to extended conformation. Stress-strain relations for a rubbery polymer and kinetic equations for the trans-cis transition are derived using the laws of thermodynamics. Governing equations are determined by 5 adjustable parameters which are found by fitting experimental data in uniaxial tensile tests on natural rubber vulcanizates with various amounts of crosslinks. Fair agreement is demonstrated between results of numerical simulation and observations with the elongation ratio up to $k=8$. We analyze the effects of cyclic loading, thermal annealing and recovery by swelling on the material constants.

cond-mat.mtrl-sci↗

arXiv2000

The Payne effect for particle-reinforced elastomers

The study deals with the Payne effect (a substantial decrease in the storage modulus of a particle-reinforced elastomer with an increase in the amplitude of mechanical oscillations). The influence of temperature, concentration of filler and amplitude and frequency of strains is analyzed on the mechanical response of filled rubbery polymers. Constitutive equations are derived using the concept of two interpenetrating networks: one comprises semiflexible polymeric chains connected to temporary junctions, whereas the other is formed by aggregated filler clusters. Adjustable parameters are found by fitting experimental data for natural rubber, bromobutyl rubber and styrene-butadiene rubber reinforced by carbon black and polymeric particles. The critical concentration of particles is determined that characterizes transition from an ensemble of disjoint clusters to the network of filler. The volume fraction of filler corresponding to this transition is found to be close to theoretical predictions based on the percolation theory, as well as to experimental data for isolator-conductor transition.

cond-mat.mtrl-sci↗

arXiv2000

The effect of temperature on the viscoelastic response of rubbery polymers at finite strains

Constitutive equations are derived for the viscoelastic response of rubbery polymers at finite strains. A polymer is thought of as a network of long chains connected to temporary junctions. At a random time, a chain detaches from a junction, which is treated at transition from its active state to the dangling state. A dangling chain randomly captures a new junction in the vicinity of its free end and returns to its active state. Breakage and reformation of long chains are modeled as thermo-mechanically activated processes. Stress-strain relations for a rubbery polymer are developed using the laws of thermodynamics. Adjustable parameters in the model are found by fitting observations in uniaxial tensile tests for a carbon black filled rubber at various temperatures. Fair agreement is demonstrated between experimental data and results of numerical simulation.

cond-mat.soft↗

arXiv2000

Modeling the viscoelastoplastic response of amorphous glassy polymers

Constitutive equations are derived for the viscoelastoplastic response of amorphous glassy polymers at isothermal loading with small strains. A polymer is treated as an ensemble of cooperatively relaxing regions (CRR) which rearrange at random times as they are thermally agitated. Rearrangement of CRRs reflects the viscoelastic response of the bulk medium. At low stresses, CRRs are connected with each other, which implies that the macro-strain in a specimen coincides with micro-strains in individual relaxing regions. When the average stress exceeds some threshold level, links between CRRs break and relaxing domains begin to slide one with respect to another. Sliding of micro-domains is associated with the viscoplastic behavior of polymers. Kinetic equations are proposed for viscoplastic strains and for the evolution of the threshold stress. These equations are validated by comparison with experimental data in tensile relaxation tests and in tests with constant strain rates. Fair agreement is demonstrated between results of numerical simulation and observations for a polyurethane resin and poly(methyl methacrylate).

cond-mat.mtrl-sci↗

arXiv2000

Modelling structural relaxation in polymeric glasses using the aggregation-fragmentation concept

Governing equations are derived for the kinetics of physical aging in polymeric glasses. An amorphous polymer is treated as an ensemble of cooperatively rearranged regions (CRR). Any CRR is thought of as a string of elementary clusters (EC). Fragmentation of the string may occur at random time at any border between ECs. Two string can aggregate at random time to produce a new string. The processes of aggregation and fragmentation are treated as thermally activated, and the rate of fragmentation is assumed to grow with temperature more rapidly than that for coalescence. This implies that only elementary clusters are stable at the glass transition temperature, whereas below this temperature, CRRs containing several ECs remain stable as well. A nonlinear differential equation is developed for the distribution of CRRs with various numbers of ECs. Adjustable parameters of the model are found by fitting experimental data in calorimetric tests for polycarbonate, poly(methyl methacrylate), polystyrene and poly(vinyl acetate). For all materials, fair agreement is established between observations and results of numerical simulation. For PVAc, the relaxation spectrum found by matching data in a calorimetric test is successfully employed to predict experimental data in a shear relaxation test.

cond-mat.soft↗

arXiv2000

Buckling of rods with spontaneous twist and curvature

We analyze stability of a thin inextensible elastic rod which has non-vanishing spontaneous generalized torsions in its stress-free state. Two classical problems are studied, both involving spontaneously twisted rods: a rectilinear beam compressed by axial forces, and a circular ring subjected to uniform radial pressure on its outer perimeter. It is demonstrated that while spontaneous twist stabilizes a rectilinear rod against buckling, its presence has an opposite effect on a closed ring.

cond-mat.soft↗

arXiv2000

Enthalpy recovery in semicrystalline polymers

Constitutive equations are derived for enthalpy recovery in polymeric glasses after thermal jumps. The model is based on the theory of cooperative relaxation in a version of the trapping concept. It is demonstrated that some critical temperature and some critical degree of crystallinity exist above which the energy landscape becomes homogeneous and structural relaxation ceases.

cond-mat.soft↗

arXiv2000

Elasticity of thin rods with spontaneous curvature and torsion - beyond geometrical lines

We study three-dimensional deformations of thin inextensible elastic rods with non-vanishing spontaneous curvature and torsion. In addition to the usual description in terms of curvature and torsion which considers only the configuration of the centerline of the rod, we allow deformations that involve the rotation of the rod's cross-section around its centerline. We derive new expressions for the mechanical energy and for the force and moment balance conditions for the equilibrium of a rod under the action of arbitrary external loads. Several illustrative examples are studied and the connection between our results and recent experiments on stretching of supercoiled DNA molecules is discussed.

cond-mat.soft↗