arXiv subjects

Alexander J. C. Kuehne

Publications and source records attributed to Alexander J. C. Kuehne.

2 recordsLinked to original sources

arXiv2026

Poly(1,4-anthraquinone) as an Organic Cathode Material: Simulation of Observable Bonding Properties to Li, Na, Mg, and Ca

Poly(1,4-anthraquinone) (P14AQ) has emerged as a promising cathode material, offering high capacity and good cycling stability, yet the atomic-scale mechanisms governing metal-ion binding and electrochemical behavior remain poorly understood. To address this, we investigate the binding mechanisms of Li, Na, Mg, and Ca to P14AQ using quantum mechanical methods, particularly DFT and DFTB. A key challenge lies in the material's structural complexity: multiple conformers of P14AQ are energetically similar but kinetically isolated due to significant energy barriers. To account for this, we develop an automated method to generate all unique P14AQ conformers for a periodic polymer chain without rotational duplicates through an orientation labeling scheme. For each conformer, we systematically place a metal atom adjacent to every oxygen site, enabling a complete exploration of binding configurations. We observe two structural motifs: a single metal-oxygen bond and coordination to two opposite oxygen atoms. While Li and Na exhibit continuous energy distributions, Mg and Ca show an energy gap between the two motifs, with a strong preference for the two-oxygen binding configuration. Galvanostatic measurements support these findings by showing lower gravimetric capacities for Ca and Mg than for Li and Na. For Na, the different numbers of metal-oxygen bonds are reflected in the two voltage plateaus observed experimentally. Overall, the combined computational and experimental results explain the higher capacity of monovalent ions in P14AQ: divalent ions cannot bind efficiently to a single oxygen site due to unfavorable energetics, and the conformational distribution of the polymer chain prevents optimal coordination.

physics.chem-ph↗

arXiv2018

3D Nanofabrication inside rapid prototyped microfluidic channels showcased by wet-spinning of single micrometre fibres

Microfluidics is an established multidisciplinary research domain with widespread applications in the fields of medicine, biotechnology and engineering. Conventional production methods of microfluidic chips have been limited to planar structures, preventing the exploitation of truly three-dimensional architectures for applications such as multi-phase droplet preparation or wet-phase fibre spinning. Here the challenge of nanofabrication inside a microfluidic chip is tackled for the showcase of a spider-inspired spinneret. Multiphoton lithography, an additive manufacturing method, was used to produce free-form microfluidic masters, subsequently replicated by soft lithography. Into the resulting microfluidic device, a threedimensional spider-inspired spinneret was directly fabricated in-chip via multiphoton lithography. Applying this unprecedented fabrication strategy, the to date smallest printed spinneret nozzle is produced. This spinneret resides tightly sealed, connecting it to the macroscopic world. Its functionality is demonstrated by wet-spinning of single-digit micron fibres through a polyacrylonitrile coagulation process induced by a water sheath layer. The methodology developed here demonstrates fabrication strategies to interface complex architectures into classical microfluidic platforms. Using multiphoton lithography for in-chip fabrication adopts a high spatial resolution technology for improving geometry and thus flow control inside microfluidic chips. The showcased fabrication methodology is generic and will be applicable to multiple challenges in fluid control and beyond.

physics.app-ph↗