SearcharxivSearch

arXiv subjects

Ali Kourani

Publications and source records attributed to Ali Kourani.

2 recordsLinked to original sources

mmWave Sensing for Detecting Movement Through Thermoplastic Masks During Radiation Therapy Treatment

Precision in radiation therapy relies on immobilization systems that limit patient motion. Thermoplastic masks are commonly used for this purpose, but subtle voluntary and involuntary movements such as jaw shifts, deep breathing, or eye squinting may still compromise treatment accuracy. Existing motion tracking methods are limited: optical systems require a clear line of sight and only detect surface motion, while X-ray-based tracking introduces additional ionizing radiation. This study explores the use of low-power, non-ionizing millimeter-wave (mmWave) sensing for through-mask motion detection. We characterize the RF properties of thermoplastic mask material in the 28-38 GHz range and perform motion detection using a 1 GHz bandwidth centered at 28 GHz. We use a frequency-domain system with horn antennas in a custom-built anechoic chamber to capture changes in the amplitude and phase of transmitted RF waves in response to subtle head and facial movements. These findings lay groundwork for future real-time through-mask motion tracking and future integration with multi-antenna systems and machine learning for error correction during radiotherapy.

eess.SP

A 300-500 MHz Tunable Oscillator Exploiting Ten Overtones in Single Lithium Niobate Resonator

This paper presents the first voltage-controlled MEMS oscillator (VCMO) based on a Lithium Niobate (LiNbO3) lateral overtone bulk acoustic resonator (LOBAR). The VCMO consists of a LOBAR in a closed loop with 2 amplification stages and a varactor-embedded tunable LC tank. By adjusting the bias voltage applied to the varactor, the tank can be tuned to change the closed-loop gain and phase responses of the oscillator so that Barkhausen conditions are satisfied for a particular resonance mode. The tank is designed to allow the proposed VCMO to lock to any of the ten overtones ranging from 300 to 500 MHz. Owing to the high-quality factors of the LiNbO3 LOBAR, the measured VCMO shows a low close-in phase noise of -100 dBc/Hz at 1 kHz offset from a 300 MHz carrier and a noise floor of -153 dBc/Hz while consuming 9 mW. With further optimization, this VCMO can lead to direct radio frequency (RF) synthesis for ultra-low-power transceivers in multi-mode Internet-of-Things (IoT) nodes.

eess.SP