Amit Bansod | Searcharxiv

arXiv2026

The EDD Radio Astronomy Backend Framework

Modern digital radio astronomy receivers produce increasingly wide-bandwidth, high bit-rate data streams that necessitate the development of flexible, scalable, and maintainable backend processing and recording systems. Historically, such backend instrumentation has been tightly coupled to telescope observing modes, limiting reuse between observatories and science cases. We present the Effelsberg Direct Digitisation (EDD) backend framework, a software-defined architecture for constructing real-time radio astronomy backends on commodity off-the-shelf computing infrastructure. We describe its design, implementation, supported observing modes, and operational deployments. EDD separates a common core framework from plugin-provided observing capabilities. The core provides orchestration, telescope interfaces, pipeline lifecycle management, monitoring, and deployment tooling, while plugins implement processing pipelines for specific observing modes. The framework is designed to support both single-dish and interferometric instruments through site-specific configuration and plugin selection. EDD currently supports spectroscopy and spectropolarimetry, pulsar timing and searching, baseband recording, very long baseline interferometry, correlation, and beamforming. Operational deployments include the Effelsberg 100-m telescope, the SKA-MPI prototype dish, the Thai National Radio Telescope, and the ARGOS interferometric prototype array. By separating common services, observing-mode plugins, and site-specific configuration, it allows backend capabilities to be deployed across heterogeneous telescope environments and provides a community resource for broadband radio astronomy instrumentation.

astro-ph.IM↗

arXiv2025

An RFSoC-based F-engine for ARGOS

Radio interferometers provide the means to perform the wide-field-of-view (FoV), high-sensitivity observations required for modern radio surveys. As computing power per cost has decreased, there has been a move towards larger arrays of smaller dishes, such as DSA-2000, the upcoming HIRAX, CHORD and SKA radio telescopes. Such arrays can have simpler receiver designs with room-temperature low-noise amplifiers and direct sampling to achieve, greatly reducing the cost per antenna. The ARGOS project is currently developing an array of five 6-meter antennas that will be used to demonstrate the technology required for a next generation "small-D, big-N" radio interferometer in Europe. In this work, our objective was to implement a first-stage digital signal processing system for the ARGOS demonstrator array, providing digitization, channelization, delay correction and frequency-dependent complex gain correction. The system is intended to produce delay and phase corrected dual-polarization channelized voltages in the frequency range 1-3 GHz with a nominal channel bandwidth of 1 MHz. We use an RFSoC 4x2 evaluation board with four analog-to-digital converters (ADCs) that can simultaneously sample two 1 GHz, dual-polarization bands. We use Xilinx Vitis HLS C++ to develop the required firmware as a set of customizable modules suitable for rapid prototyping. We performed hardware verification of the channel response of the critically sampled PFB and of the delay correction, showing both to be consistent with theoretical expectations. Furthermore, the board was installed at the Effelsberg 100-meter radio telescope where we performed commensal pulsar observations with the Effelsberg Direct Digitization backend, showing comparable performance. This work demonstrates the utility of high-level synthesis (HLS) languages in the development of high performance radio astronomy processing backends.

astro-ph.IM↗