SearcharxivSearch

arXiv subjects

Andrew C. M. Austin

Publications and source records attributed to Andrew C. M. Austin.

4 recordsLinked to original sources

OTA Characterization of Dual-User IEEE 802.11be EHT-MU Under Transmit-Chain Imbalance

This paper presents a controlled over-the-air (OTA) characterization of dual-user IEEE 802.11be Extremely High Throughput Multi-User (EHT-MU) transmission under transmit-chain imbalance. The objective is to determine whether attenuation applied to one access-point transmit chain produces packet-global degradation or appears primarily as stream-dependent payload degradation after receiver processing. Measurements are performed in a shielded RF enclosure using two NI USRP-2953R and NI USRP-2942R software-defined radios, with one USRP generating a dual-user non-OFDMA EHT-MU waveform and the other implementing synchronized dual-branch packet recovery. A calibrated attenuation sweep is applied to the second AP transmit chain (TX2), and performance is evaluated using bit error rate (BER), EHT-Data error vector magnitude (EVM), control-field success probability, payload-success probability, and subcarrier-level EVM distributions. The results show that the stream decoded as User~1 remains at the BER floor over the tested range, while the stream decoded as User~2 exhibits progressive EVM degradation followed by threshold-like BER and payload-success collapse. Common signaling fields remain recoverable, indicating that the dominant observed failure mode is stream-local at the receiver output than the packet-global. Replacing User~2 binary convolutional coding (BCC) with low density parity check (LDPC) coding delays the BER and payload-success collapse by approximately \(5\)~dB of TX2 attenuation, demonstrating a measurable coding-dependent robustness margin for the more sensitive stream.

eess.SP

Over-the-Air Successive Interference Cancellation for Efficient 5G NR and Wi-Fi Spectrum Reuse

An over-the-air (OTA) experimental evaluation of concurrent 5G New Radio (5G NR) and Wi-Fi transmission using successive interference cancellation (SIC) in a shielded-box environment is presented. A USRP is used as the receiver, which captures the composite waveform containing both air-interface signals and applies sample-domain SIC to suppress the dominant 5G-NR signal and recover Wi-Fi signal from the residual waveform. The framework reports error vector magnitude (EVM), bit error rate (BER), sample-domain cancellation depth, and channel-estimate suppression, and, at the representative \(18\) dB attenuation point, measures \(11.88\) dB cancellation depth and \(26.96\) dB 5G channel suppression. The proposed methodology provides a practical basis for assessing cross-technology coexistence and receiver-side interference suppression under controlled OTA conditions.

eess.SP

Sliding Window Spectrum Sensing for Full-Duplex Cognitive Radios with Low Access-Latency

In a cognitive radio system the failure of secondary user (SU) transceivers to promptly vacate the channel can introduce significant access-latency for primary or high-priority users (PU). In conventional cognitive radio systems, the backoff latency is exacerbated by frame structures that only allow sensing at periodic intervals. Concurrent transmission and sensing using self-interference suppression has been suggested to improve the performance of cognitive radio systems, allowing decisions to be taken at multiple points within the frame. In this paper, we extend this approach by proposing a sliding-window full-duplex model allowing decisions to be taken on a sample-by-sample basis. We also derive the access-latency for both the existing and the proposed schemes. Our results show that the access-latency of the sliding scheme is decreased by a factor of 2.6 compared to the existing slotted full-duplex scheme and by a factor of approximately 16 compared to a half-duplex cognitive radio system. Moreover, the proposed scheme is significantly more resilient to the destructive effects of residual self-interference compared to previous approaches.

cs.IT

Spatial Multiplexing of QPSK Signals with a Single Radio: Antenna Design and Over-the-Air Experiments

The paper describes the implementation and performance analysis of the first fully-operational beam-space MIMO antenna for the spatial multiplexing of two QPSK streams. The antenna is composed of a planar three-port radiator with two varactor diodes terminating the passive ports. Pattern reconfiguration is used to encode the MIMO information onto orthogonal virtual basis patterns in the far-field. A measurement campaign was conducted to compare the performance of the beam-space MIMO system with a conventional 2-by-?2 MIMO system under realistic propagation conditions. Propagation measurements were conducted for both systems and the mutual information and symbol error rates were estimated from Monte-Carlo simulations over the measured channel matrices. The results show the beam-space MIMO system and the conventional MIMO system exhibit similar finite-constellation capacity and error performance in NLOS scenarios when there is sufficient scattering in the channel. In comparison, in LOS channels, the capacity performance is observed to depend on the relative polarization of the receiving antennas.

cs.IT