arXiv subjects

Aniko Szalai

Publications and source records attributed to Aniko Szalai.

3 recordsLinked to original sources

arXiv2017

Detection of biomolecules and bioconjugates by monitoring rotated grating-coupled surface plasmon resonance

Plasmonic biosensing chips were prepared by fabricating wavelength-scaled dielectric-metal interfacial gratings on polymer film covered bimetal layers. Lysozyme biomolecules (LYZ) and gold nanoparticle bioconjugates (AuNP-LYZ) with 1:5 mass ratio were seeded onto the biochip surfaces. Comparison of the reflectance curves measured in a modified Kretschmann arrangement and computed numerically proved that monitoring the narrower secondary peaks under optimal rotated-grating coupling condition makes it possible to achieve enhanced sensitivity in biodetection. The enlarged resonance peak shift is due to the horizontally and vertically antisymmetric long-range plamonic modes propagating at the edge of the valleys and hills, which originate from Bragg scattered surface plasmon polaritons. The sensitivity is further increased in case of bioconjugates due to the coupled localized resonances on Au NPs.

physics.optics↗

arXiv2014

Plasmonic structure integrated single-photon detector configurations to improve absorptance and polarization contrast

Configurations capable of maximizing both absorptance and polarization contrast were determined for 1550 nm polarized light illumination of different plasmonic structure integrated superconducting nanowire single-photon detectors (SNSPDs) consisting of p=264 nm and P=792 nm periodic niobium-nitride (NbN) patterns on silica substrate. Global NbN absorptance maxima appear in case of p/s-polarized light illumination in S/P-orientation (gamma=90 azimuthal angle) and the highest polarization contrast is attained in S-orientation of all devices. Common nanophotonical origin of absorptance enhancement is collective resonance on nano-cavity-gratings with different profiles, which is promoted by coupling between localized modes in quarter wavelength MIM nano-cavities and laterally synchronized Brewster-Zenneck-type surface waves in integrated SNSPDs possessing a three-quarter-wavelength-scaled periodicity. The spectral sensitivity and dispersion characteristics reveal that device design specific optimal configurations exist.

physics.optics↗

arXiv2012

Integrated lithography to produce complex structures for spectral engineering

An integrated interference and colloid sphere lithography (IICL) is presented to produce complex plasmonic structures consisting of wavelength-scaled periodic arrays of nano-objects with arbitrary array symmetry and controllable nano-scaled sub-structure. The IICL method is based on illumination of colloid sphere monolayers by interference patterns synchronized with sphere arrays along arbitrary crystallographic directions. This nano-kaleidoscope method enables to tune four structure parameters independently: the symmetry and characteristic periodicity of the interference pattern might be varied by the wavelength, number and angle of incidence of the interfering beams; the colloid-spheres' diameter-scaled distance between the nano-objects is controllable by the relative orientation of the interference pattern with respect to the hexagonal lattice of colloid spheres; the size of individual nano-objects is determined by the colloid-spheres diameter and by the light wavelength and is influenced by power density; the sub-structure size-parameter sensitively depends on the polarization state and can be tuned with the nano-object size simultaneously. Finite element method is applied to demonstrate the capabilities of IICL, and the impact of the resulted complex plasmonic patterns on spectral properties of thin gold films. The possibility to realize spectral engineering with predesigned rectangular arrays of hole-doublets that may be produced uniquely by IICL is shown.

physics.optics↗