arXiv subjects

Anna V. Guglielmi

Publications and source records attributed to Anna V. Guglielmi.

6 recordsLinked to original sources

arXiv2026

Security Analysis of RIS-Assisted Physical-Layer Authentication Over Multipath Channels

In physical layer authentication, verification of a user's identity is based on the characteristics of the transmission channel through which signals are delivered to the authenticator (Bob). In this paper, we assume that the signals received by Bob pass through a \ac{RIS} (controlled by Bob) and that the legitimate transmitter (Alice) is equipped with one antenna. Conversely, the attacker (Trudy) has multiple antennas and uses precoding to deceive Bob's verification. Assuming that Trudy knows all the channel matrices, we first derive her optimal attack strategy. Then, we analyse the conditions under which the channel estimated by Bob is indistinguishable when either Alice or Trudy is transmitting. When Trudy has a single antenna, we show that the indistinguishability condition cannot be met when the channels to the RIS are the result of propagation over multiple paths. For single-path line-of-sight (LOS) conditions, instead, Trudy can impersonate Alice although transmitting from a different position. We verify these results numerically and assess the security of the considered scenario, even when the indistinguishability conditions cannot be met.

cs.IT↗

arXiv2026

Digital Twin-Based Beamforming for Interference Mitigation in AF Relay MIMO Systems

Beamforming in multiple-input multiple-output (MIMO) systems should take interference mitigation into account. However, for beamform design, accurate channel state information (CSI) is needed, which is often difficult to obtain due to channel variability, feedback overhead, or hardware constraints. For example, amplify-and-forward (AF) relays passively forward signals without measurement, precluding full CSI acquisition to and from the relay. To address these issues, this paper introduces a novel prediction-assisted optimization (PAO) framework for beamform design in AF relay-assisted multiuser MIMO systems. The proposed solution in the AF relay aims at maximizing the signal-plus-interference-to-noise ratio (SINR). Unlike other methods, PAO relies solely on received power measurements, making it suitable for scenarios where CSI is unreliable or unavailable. PAO consists of two stages: a supervised-learning-based neural network (NN) that predicts the positions of transmitters using signal observations, and an optimization algorithm, guided by a digital twin (DT), that iteratively refines the beam direction of the relay in a simulated radio environment. As a key contribution, we validate the proposed framework using realistic measurements collected on a custom-built experimental millimeter wave (mmWave) platform, which enables training of the NN model under practical wireless conditions. The estimated information is then used to update the digital twin with knowledge of the surrounding environment, enabling online optimization. Numerical results show the trade-off between localization accuracy and beamforming performance and confirm that PAO maintains robustness even in the presence of localization errors while reducing the need for real-world measurements.

eess.SP↗

arXiv2024

Fast Iterative Configuration of Reconfigurable Intelligent Surfaces in mmWave Systems

Reconfigurable intelligent surfaces (RISs) are a promising solution to improve the coverage of cellular networks, thanks to their ability to steer impinging signals in desired directions. However, they introduce an overhead in the communication process since the optimal configuration of a RIS depends on the channels to and from the RIS, which must be estimated. In this paper, we propose a novel fast iterative configuration (FIC) protocol to determine the optimal RIS configuration that exploits the small number of paths of millimetre-wave (mmWave) channels and an adaptive choice of the explored RIS configurations. In particular, we split the elements of the RIS into a number of subsets equal to the number of channel taps. For each subset, then an iterative procedure finds at each iteration the optimal RIS configuration in a codebook exploring a two-dimensional grid of possible angles of arrival and departure of the path at the RIS. Over the iterations, the grid is made finer around the point identified in previous iterations. Numerical results obtained using an urban channel model confirm that the proposed solution is fast and provides a configuration close to the optimal in a shorter time than other existing approaches.

eess.SP↗

arXiv2021

Information Theoretic Key Agreement Protocol based on ECG signals

Wireless body area networks (WBANs) are becoming increasingly popular as they allow individuals to continuously monitor their vitals and physiological parameters remotely from the hospital. With the spread of the SARS-CoV-2 pandemic, the availability of portable pulse-oximeters and wearable heart rate detectors has boomed in the market. At the same time, in 2020 we assisted to an unprecedented increase of healthcare breaches, revealing the extreme vulnerability of the current generation of WBANs. Therefore, the development of new security protocols to ensure data protection, authentication, integrity and privacy within WBANs are highly needed. Here, we targeted a WBAN collecting ECG signals from different sensor nodes on the individual's body, we extracted the inter-pulse interval (i.e., R-R interval) sequence from each of them, and we developed a new information theoretic key agreement protocol that exploits the inherent randomness of ECG to ensure authentication between sensor pairs within the WBAN. After proper pre-processing, we provide an analytical solution that ensures robust authentication; we provide a unique information reconciliation matrix, which gives good performance for all ECG sensor pairs; and we can show that a relationship between information reconciliation and privacy amplification matrices can be found. Finally, we show the trade-off between the level of security, in terms of key generation rate, and the complexity of the error correction scheme implemented in the system.

cs.CR↗

arXiv2020

Feature selection for gesture recognition in Internet-of-Things for healthcare

Internet of Things is rapidly spreading across several fields, including healthcare, posing relevant questions related to communication capabilities, energy efficiency and sensors unobtrusiveness. Particularly, in the context of recognition of gestures, e.g., grasping of different objects, brain and muscular activity could be simultaneously recorded via EEG and EMG, respectively, and analyzed to identify the gesture that is being accomplished, and the quality of its performance. This paper proposes a new algorithm that aims (i) to robustly extract the most relevant features to classify different grasping tasks, and (ii) to retain the natural meaning of the selected features. This, in turn, gives the opportunity to simplify the recording setup to minimize the data traffic over the communication network, including Internet, and provide physiologically significant features for medical interpretation. The algorithm robustness is ensured both by consensus clustering as a feature selection strategy, and by nested cross-validation scheme to evaluate its classification performance.

cs.CV↗

arXiv2018

Classification of grasping tasks based on EEG-EMG coherence

This work presents an innovative application of the well-known concept of cortico-muscular coherence for the classification of various motor tasks, i.e., grasps of different kinds of objects. Our approach can classify objects with different weights (motor-related features) and different surface frictions (haptics-related features) with high accuracy (over 0:8). The outcomes presented here provide information about the synchronization existing between the brain and the muscles during specific activities; thus, this may represent a new effective way to perform activity recognition.

eess.SP↗