SearcharxivSearch

arXiv subjects

Annika Dochhan

Publications and source records attributed to Annika Dochhan.

At least 19 recordsLinked to original sources

Experimental Investigation of Machine Learning based Soft-Failure Management using the Optical Spectrum

The demand for high-speed data is exponentially growing. To conquer this, optical networks underwent significant changes getting more complex and versatile. The increasing complexity necessitates the fault management to be more adaptive to enhance network assurance. In this paper, we experimentally compare the performance of soft-failure management of different machine learning algorithms. We further introduce a machine-learning based soft-failure management framework. It utilizes a variational autoencoder based generative adversarial network (VAE-GAN) running on optical spectral data obtained by optical spectrum analyzers. The framework is able to reliably run on a fraction of available training data as well as identifying unknown failure types. The investigations show, that the VAE-GAN outperforms the other machine learning algorithms when up to 10\% of the total training data is available in identification tasks. Furthermore, the advanced training mechanism for the GAN shows a high F1-score for unknown spectrum identification. The failure localization comparison shows the advantage of a low complexity neural network in combination with a VAE over established machine learning algorithms.

cs.NI

Accurate Single-Ended Measurement of Propagation Delay in Fiber Using Correlation Optical Time Domain Reflectometry

A correlation optical time-domain reflectometry (COTDR) method is presented, which measures the propagation delay with an accuracy of a few picoseconds. This accuracy is achieved using a test signal data rate of 10 Gbit/s and employing cross-correlation and pulse fitting techniques. In this paper we introduce and evaluate the basic signal processing steps, investigate the measurement accuracy, and discuss applications for monitoring link delay and chromatic dispersion of long fiber spans as well as temperature sensing applications.

physics.optics

Temperature dependent latency of jumper cables

The temperature dependence of the latency of an optical signal transmitted over an optical fiber was investigated by means of a correlation OTDR. While the bare fiber showed a linear latency increase over temperature, the jumper cable inside a jacket with tight buffer as inner jacket showed an increased elongation effect, especially in the range of lower tempera-tures. This could be attributed to the tight buffer. For future latency sensitive applications in the area of 5G networks these effects have to be taken into account.

physics.gen-ph

Fiber as a temperature sensor with portable Correlation-OTDR as interrogator

In this paper, we report on the integration of a Correlation-OTDR into a portable unit (30 cm x 30 cm), based on a multi-processor system on chip (MPSoC) and a small formfactor pluggable (SFP) 2.5G transceiver. Going beyond telecommunication applications, this system is demonstrated for temperature measurements, based on the change of propagation delay with temperature in a short section of optical fiber. The temperature measurement accuracy is investigated as a function of the fiber length from 4 to 25 meters.

eess.SP

Latency Measurement of 100 km Fiber Using Correlation-OTDR

By means of C-OTDR (Correlation - Optical Time Domain Reflectometry), we measured the latency of100 km fiber with an accuracy of a few picoseconds. Based on iterating 49 measurements, we calculated a standard deviation of 12 ps between the round-trip latency values. To verify the reflection measurements, we used a single pass setup without reflector, which showed a maximum difference of only 11 ps.

eess.SP

Solutions for 80 km DWDM Systems

We review currently discussed solutions for 80 km DWDM transmission targeting inter data-center connections at 100G and 400G line rates. PDM-64QAM, PAM4 and DMT are investigated, while the focus lies on directly detected solutions.

eess.SP

Optimizing Discrete Multi-tone Transmission for 400G Data Center Interconnects

Discrete multi-tone transmission (DMT) is a promising candidate for future 400G data center interconnects. Eight channels, each carrying 56 Gb/s of data can be combined in a 50-GHz channel grid to form a 400 Gb/s superchannel. For a fully loaded 96 channel DWDM system this leads to a total capacity of 4.8 Tb/s. To meet the requirements of the targeted application in terms of cost efficiency and low power consumption, it is important to keep the complexity for the digital signal processing as low as possible. For DMT, the complexity is mainly determined by the length of the fast Fourier transformation (FFT). Since data center interconnects only have to bridge a distance of typically 80 km, we here investigate among other parameters the influence of the FFT length among other parameters on the achievable performance for 56 Gb/s DMT only for this distance. Transmission is performed in C-band to enable DWDM and no optical dispersion compensation is applied. We consider double sideband (DSB) as well as vestigial sideband (VSB) DMT. It can be seen that an FFT length of 128 is sufficient to reach the required performance in terms of bit error ratio, however, a higher length can significantly improve the performance.

eess.SP

Practical Solutions for 400 Gbit/s Data Center Transmission

We review three solutions for low-cost data center interconnects with a target reach of up to 80 km. Directly detected DMT, PAM-4 and multi-band CAP are promising modulation schemes, enabling 400 Gbit/s by combining eight channels of 56 Gbit/s.

eess.SP

A 3-Dimensional Simplex Modulation Format with Improved OSNR Performance Compared to DP-BPSK

The novel 3-dimensional modulation format 3D-Simplex offers potentially 1.2 dB higher OSNR tolerance than DP-DPSK while exhibiting the same spectral occupancy, modulating two bits per symbol. We verify this benefit experimen-tally and evaluate the transmission performance in a non-linear environment. All experimental results are confirmed by simulations. The benefit of 3D-Simplex is not maintained in the highly non-linear regime, but the performance is still comparable to that of DP-DPSK.

eess.SP