arXiv subjects

Antoine Gaillard

Publications and source records attributed to Antoine Gaillard.

4 recordsLinked to original sources

arXiv2026

Inelastic spreading of viscoelastic drops

When a liquid drop impacts a solid surface, rebound and splashing are known to be suppressed by additives that induce elastic effects; however, the influence of elasticity on the maximum spreading radius remains debated. The difficulty lies in isolating elastic resistance from the enhanced spreading caused by viscous shear thinning. Here, we experimentally decouple these effects by investigating Boger fluid drops (constant-viscosity solutions with high elasticity) of polyethylene oxide (PEO) and polyacrylamide (PAAM). We demonstrate that elastic properties do not alter the maximum spreading ratio, even at high concentrations up to 1000 ppm. We formulate an energy balance that accounts for the inertial, capillary, viscous, and elastic contributions, and yields a dimensionless criterion ($\Gamma$) that estimates the degree of elastic effects. We show that $\Gamma \ll 1$ for all impact conditions tested, demonstrating that elastic effects are energetically negligible during droplet spreading, opposite to what Weissenberg and Deborah numbers would predict.

physics.flu-dyn↗

arXiv2023

Beware of CaBER: Filament thinning rheometry does not always give `the' relaxation time of polymer solutions

The viscoelastic relaxation time of a polymer solution is often measured using Capillary Breakup Extensional Rheometry (CaBER) where a droplet is placed between two plates which are pulled apart to form a thinning filament. For a slow plate retraction protocol, required to avoid inertio-capillary oscillations for low-viscosity liquids, we show experimentally that the CaBER relaxation time $\tau_e$ inferred from the exponential thinning regime is in fact an apparent relaxation time that may increase significantly when increasing the plate diameter and the droplet volume. Similarly, we observe that $\tau_e$ increases with the plate diameter for the classical step-strain plate separation protocol of a commercial (Haake) CaBER device and increases with the nozzle diameter for a Dripping-onto-Substrate (DoS) method. This dependence on the flow history before the formation of the viscoelastic filament is in contradiction with polymer models such as Oldroyd-B that predict a filament thinning rate $1/3\tau$ ($\tau$ being the model's relaxation time) which is a material property independent of geometrical factors. We show that this is not due to artefacts such as solvent evaporation or polymer degradation and that it can only be rationalised by finite extensibility effects (FENE-P model) for a dilute polymer solution in a viscous solvent, but not for semi-dilute solutions in a low-viscosity solvent.

cond-mat.soft↗

arXiv2023

Reconciling airborne disease transmission concerns with energy saving requirements: the potential of UV-C pathogen deactivation and air distribution optimization

The COVID-19 pandemic caused a paradigm shift in our way of using heating, ventilation, and air-conditioning (HVAC) systems in buildings. In the early stages of the pandemic, it was indeed advised to reduce the reuse and thus the recirculation of indoor air to minimize the risk of contamination through inhalation of virus-laden aerosol particles emitted by humans when coughing, sneezing, speaking or breathing. However, such recommendations are not compatible with energy saving requirements stemming from climate change and energy price increase concerns, especially in winter and summer when the fraction of outdoor air supplied to the building needs to be significantly heated or cooled down. In this experimental study, we aim at providing low-cost and low-energy solutions to modify the ventilation strategies currently used in many buildings to reduce the risk of respiratory disease transmission. We find that ultraviolet germicidal irradiation (UVGI) modules added to the HVAC system are very efficient at inactivating pathogens present in aerosols, leading to good indoor air quality even with significant indoor air recirculation. Moreover, we show that an optimal placement of the air exhaust vents relative to air supply vents can improve the ventilation efficiency, with significant consequences in terms of energy savings.

physics.soc-ph↗

arXiv2020

The life and fate of a bubble in a geometrically-perturbed Hele-Shaw channel

Motivated by the desire to understand complex transient behaviour in fluid flows, we study the dynamics of an air bubble driven by the steady motion of a suspending viscous fluid within a Hele-Shaw channel with a centred depth perturbation. Using both experiments and numerical simulations of a depth-averaged model, we investigate the evolution of an initially centred bubble of prescribed volume as a function of flow rate and initial shape. The experiments exhibit a rich variety of organised transient dynamics, involving bubble break up as well as aggregation and coalescence of interacting neighbouring bubbles. The long-term outcome is either a single bubble or multiple separating bubbles, positioned along the channel in order of increasing velocity. Up to moderate flow rates, the life and fate of the bubble are reproducible and can be categorised by a small number of characteristic behaviours that occur in simply-connected regions of the parameter plane. Increasing the flow rate leads to less reproducible time evolutions with increasing sensitivity to initial conditions and perturbations in the channel. Time-dependent numerical simulations that allow for break up and coalescence are found to reproduce most of the dynamical behaviour observed experimentally including enhanced sensitivity at high flow rate. An unusual feature of this system is that the set of steady and periodic solutions can change during temporal evolution because both the number of bubbles and their size distribution evolve due to break up and coalescence events. Calculation of stable and unstable solutions in the single- and two-bubble cases reveals that the transient dynamics are orchestrated by weakly-unstable solutions of the system termed edge states that can appear and disappear as the number of bubbles changes.

physics.flu-dyn↗