arXiv subjects

Antti Kuronen

Publications and source records attributed to Antti Kuronen.

6 recordsLinked to original sources

arXiv2024

Spontaneous damage annealing reactions as a possible source of low energy excess in semiconductor detectors

In semiconductor detectors designed for capturing dark matter particles or neutrinos, when the detection threshold is constantly improved to increasingly low energies, an "excess" signal of apparent energy release events below a few hundred eV is observed in several different kinds of detectors. This becomes a big obstacle to the observation of actual dark matter signals, hindering the detectors' sensitivity for rare events in this energy range. Using atomistic simulations with a classical thermostat and a quantum thermal bath, we show that this kind of signal is consistent with energy release from long-term annealing events of complex defects that can be formed by any kind of nuclear recoil radiation events. Such energy releases are shown to have a very similar exponential dependence on energy release magnitudes as that observed in experiments. By detailed analysis of the annealing events, we show that crossing very low energy barriers can trigger larger energy releases in an avalanche-like effect. This explains why large energy release events can occur even down to cryogenic temperatures, where the significant migration of point defects in silicon is hardly ever possible.

cond-mat.mtrl-sci↗

arXiv2024

Large-scale atomistic study of plasticity in amorphous gallium oxide with a machine-learning potential

Compared to the widely investigated crystalline polymorphs of gallium oxide (Ga2O3), knowledge about its amorphous state is still limited. With the help of a machine-learning interatomic potential, we conducted large-scale atomistic simulations to investigate the glass transition and mechanical behavior of amorphous Ga2O3 (a-Ga2O3). During the quenching simulations, amorphization of gallium oxide melt is observed at ultrahigh cooling rates, including a distinct glass transition. The final densities at room temperature have up to 4% variance compared to experiments. The glass transition temperature is evaluated to range from 1234 K to 1348 K at different cooling rates. Structural analysis of the amorphous structure shows evident similarities in structural properties between a-Ga2O3 and amorphous alumina (a-Al2O3), such as radial distribution function, coordination distribution, and bond angle distribution. An amorphous gallium oxide structure that contains approximately one million atoms is prepared for the tension simulation. A highly plastic behavior is observed at room temperature in the tension simulations, comparable to amorphous alumina. With quantitative characterization methods, we show that a-Ga2O3 can possibly has a higher nucleation rate of localized plastic strain events compared to a-Al2O3, which can increase the material's resistance to shear banding formation during deformation.

cond-mat.mtrl-sci↗

arXiv2022

Energy loss in low energy nuclear recoils in dark matter detector materials

Recent progress in phonon-mediated detectors with eV-scale nuclear recoil energy sensitivity requires an understanding of the effect of the crystalline defects on the energy spectrum expected from dark matter or neutrino coherent scattering. We have performed molecular dynamics simulations to determine the amount of energy stored in the lattice defects as a function of the recoil direction and energy. This energy can not be observed in the phonon measurement, thus affecting the observed energy spectrum compared to the underlying true recoil energy spectrum. We describe this effect for multiple commonly used detector materials and demonstrate how the predicted energy spectrum from dark matter scattering is modified.

hep-ph↗

arXiv2021

Interatomic Fe-Cr potential for modeling kinetics on Fe surfaces

To enable accurate molecular dynamics simulations of iron-chromium alloys with surfaces, we develop, based on density-functional-theory (DFT) calculations, a new interatomic Fe-Cr potential in the Tersoff formalism. Contrary to previous potential models, which have been designed for bulk Fe-Cr, we extend our potential fitting database to include not only conventional bulk properties but also surface-segregation energies of Cr in bcc Fe. In terms of reproducing our DFT results for the bulk properties, the new potential is found to be superior to the previously developed Tersoff potential and competitive with the concentration-dependent and two-band embedded-atom-method potentials. For Cr segregation toward the surface of an Fe-Cr alloy, only the new potential agrees with our DFT calculations in predicting preferential segregation of Cr to the topmost surface layer, instead of the second layer preferred by the other potentials. We expect this rectification to foster future research, e.g., on the mechanisms of corrosion resistance of stainless steels at the atomic level.

cond-mat.mtrl-sci↗

arXiv2018

Nucleation and dynamics of dislocations in mismatched heterostructures

In this paper we have investigated, through computer simulations, dislocation nucleation and dislocation dynamics in a heterostructure system with the lattice-mismatch interface, i.e. a system with internal strain. In particular, we have studied the dependence of the nucleation thresholds on the basic parameters of the crystals, such as the amount of mismatch and the system temperature. These studies have been carried out by using the simulation code with a graphical user interface developed at our laboratory. This on-line simulation system produces a real time interactive visualization of the 3-D Molecular Dynamics model. Furthermore, it detects the presence of dislocations and tracks them by an algorithm based on potential energy mapping.

cond-mat.mtrl-sci↗

arXiv2016

Interatomic Fe-H potential for irradiation and embrittlement simulations

The behavior of hydrogen in iron and iron alloys is of interest in many fields of physics and materials science. To enable large-scale molecular dynamics simulations of systems with Fe-H interactions, we develop, based on density-functional theory calculations, an interatomic Fe-H potential in the Tersoff-Brenner formalism. The obtained analytical potential is suitable for simulations of H in bulk Fe as well as for modeling small FeH molecules, and it can be directly combined with our previously constructed potential for the stainless steel Fe-Cr-C system. This will allow simulations of, e.g., hydrocarbon molecule chemistry on steel surfaces. In the current work, we apply the potential to simulating hydrogen-induced embrittlement in monocrystalline bulk Fe and in an Fe bicrystal with a grain boundary. In both cases, hydrogen is found to soften the material.

cond-mat.mtrl-sci↗