arXiv subjects

B. Holzer

Publications and source records attributed to B. Holzer.

6 recordsLinked to original sources

arXiv2025

The Large Hadron electron Collider as a bridge project for CERN

The LHeC is the project for delivering electron-nucleon collisions at CERN using the HL-LHC beams. An Energy Recovery Linac in racetrack configuration will provide 50 GeV electrons to achieve centre-of-mass energies around 1 TeV/nucleon and instantaneous luminosities around $10^{34}$ cm$^{-2}$s$^{-1}$. The LHeC program elaborated in the CDR of 2021 included a phase with concurrent operation of electron-hadron and hadron-hadron collisions, followed by a standalone phase of electron-hadron collisions only. In view of the current HL-LHC schedule, in this paper we have examined the possibilities of a program after the regular HL-LHC program with only electron-proton operation. In this operation mode, the LHeC would serve as an impactful bridge project between major colliders at CERN. The standalone physics program comprises electroweak, Higgs, top-quark, BSM and strong-interaction physics. In addition, it empowers the physics analyses at the HL-LHC by retrofitting measurements and searches with significantly more precise knowledge of the proton structure and $\alpha_s$. The accelerator technology deployed in the Energy Recovery Linac for the LHeC is a major stepping-stone for the performance, cost reduction and training for future colliders. The capital investments in the LHeC electron accelerator can be reused in a cost-efficient way as the injector for the FCC-ee. Finally, data from the LHeC are essential to enable the physics potential of any new high-energy hadron collider. The operational plan of 6 years easily fits in the period between two major colliders at CERN. Similar to the LHeC empowering the HL-LHC physics program, the FCC-eh would be an impactful addition to the FCC physics program.

hep-ex↗

arXiv2017

Machine Layout and Performance

Chapter 2 in High-Luminosity Large Hadron Collider (HL-LHC) : Preliminary Design Report. The Large Hadron Collider (LHC) is one of the largest scientific instruments ever built. Since opening up a new energy frontier for exploration in 2010, it has gathered a global user community of about 7,000 scientists working in fundamental particle physics and the physics of hadronic matter at extreme temperature and density. To sustain and extend its discovery potential, the LHC will need a major upgrade in the 2020s. This will increase its luminosity (rate of collisions) by a factor of five beyond the original design value and the integrated luminosity (total collisions created) by a factor ten. The LHC is already a highly complex and exquisitely optimised machine so this upgrade must be carefully conceived and will require about ten years to implement. The new configuration, known as High Luminosity LHC (HL-LHC), will rely on a number of key innovations that push accelerator technology beyond its present limits. Among these are cutting-edge 11-12 tesla superconducting magnets, compact superconducting cavities for beam rotation with ultra-precise phase control, new technology and physical processes for beam collimation and 300 metre-long high-power superconducting links with negligible energy dissipation. The present document describes the technologies and components that will be used to realise the project and is intended to serve as the basis for the detailed engineering design of HL-LHC.

physics.acc-ph↗

arXiv2016

Design of beam optics for the Future Circular Collider e+e- -collider rings

A beam optics scheme has been designed for the Future Circular Collider-e+e- (FCC-ee). The main characteristics of the design are: beam energy 45 to 175 GeV, 100 km circumference with two interaction points (IPs) per ring, horizontal crossing angle of 30 mrad at the IP and the crab-waist scheme [1] with local chromaticity correction. The crab-waist scheme is implemented within the local chromaticity correction system without additional sextupoles, by reducing the strength of one of the two sextupoles for vertical chromatic correction at each side of the IP. So-called "tapering" of the magnets is applied, which scales all fields of the magnets according to the local beam energy to compensate for the effect of synchrotron radiation (SR) loss along the ring. An asymmetric layout near the interaction region reduces the critical energy of SR photons on the incoming side of the IP to values below 100 keV, while matching the geometry to the beam line of the FCC proton collider (FCC-hh) [2] as closely as possible. Sufficient transverse/longitudinal dynamic aperture (DA) has been obtained, including major dynamical effects, to assure an adequate beam lifetime in the presence of beamstrahlung and top-up injection. In particular, a momentum acceptance larger than +/-2% has been obtained, which is better than the momentum acceptance of typical collider rings by about a factor of 2. The effects of the detector solenoids including their compensation elements are taken into account as well as synchrotron radiation in all magnets. The optics presented in this paper is a step toward a full conceptual design for the collider. A number of issues have been identified for further study.

physics.acc-ph↗

arXiv2016

The FCC-ee Interaction Region Magnet Design

The design of the region close to the interaction point of the FCC-ee experiments is especially challenging. The beams collide at an angle (+-15 mrad) in the high-field region of the detector solenoid. Moreover, the very low vertical beta_y* of the machine necessitates that the final focusing quadrupoles have a distance from the IP (L*) of around 2 m and therefore are inside the main detector solenoid. The beams should be screened from the effect of the detector magnetic field, and the emittance blow-up due to vertical dispersion in the interaction region should be minimized, while leaving enough space for detector components. Crosstalk between the two final focus quadrupoles, only about 6 cm apart at the tip, should also be minimized.

physics.acc-ph↗

arXiv2016

First Evaluation of Dynamic Aperture at Injection for FCC-hh

In the Hadron machine option, proposed in the context of the Future Circular Colliders (FCC) study, the dipole field quality is expected to play an important role, as in the LHC. A preliminary evaluation of the field quality of dipoles, based on the Nb$_{3}$Sn technology, has been provided by the magnet group. The effect of these field imperfections on the dynamic aperture, using the present lattice design, is presented and first tolerances on the b$_3$ and b$_5$ multipole components are evaluated.

physics.acc-ph↗

arXiv2015

The FCC-ee study: Progress and challenges

The FCC (Future Circular Collider) study represents a vision for the next large project in high energy physics, comprising an 80-100 km tunnel that can house a future 100 TeV hadron collider. The study also includes a high luminosity e+e- collider operating in the centre-of-mass energy range of 90-350 GeV as a possible intermediate step, the FCC-ee. The FCC-ee aims at definitive electro-weak precision measurements of the Z, W, H and top particles, and search for rare phenomena. Although FCC-ee is based on known technology, the goal performance in luminosity and energy calibration make it quite challenging. During 2014 the study went through an exploration phase. The study has now entered its second year and the aim is to produce a conceptual design report during the next three to four years. We here report on progress since the last IPAC conference.

physics.acc-ph↗