arXiv subjects

B. J. J. Slagmolen

Publications and source records attributed to B. J. J. Slagmolen.

9 recordsLinked to original sources

arXiv2026

LIGO A$^\sharp$: Detector Design and Science Prospects Beyond A+

We present the LIGO A$^\sharp$ detector concept, an upgrade for the LIGO observatories based on room-temperature interferometers beyond the fifth observing run (O5). Building on the A+ sensitivity, A$^\sharp$ targets broadband sensitivity improvements through heavier test masses, improved suspensions and seismic isolation, increased arm-cavity power, enhanced frequency-dependent squeezing, reduced coating thermal noise considering two scenarios, and improved control of mechanical motion and optical modes. We describe the principal design choices, projected noise performance, and corresponding astrophysical prospects. LIGO A$^\sharp$ substantially increases compact-binary detection rates, strengthens population inference, and improves both early-warning times and localization for binary neutron star mergers. The improved sensitivity enables more detailed studies of compact-binary coalescences, including higher-order multipoles, intermediate-mass black holes, remnant black hole ringdown, and the neutron star equation of state. It also broadens the discovery potential for new gravitational-wave sources such as continuous waves and bursts, should enable detection of the stochastic background from compact binary mergers if it remains undetected after O5, and strengthens the role of gravitational-wave detectors as probes of fundamental physics. We discuss key technical challenges and the role of A$^\sharp$ as both a major scientific upgrade for the 2030s and a technology pathfinder for next-generation gravitational-wave observatories, such as Cosmic Explorer.

astro-ph.IM↗

arXiv2025

Loss-tolerant detection of squeezed states in the 2 um region

Squeezed states of light enable quantum-enhanced measurements but are limited by optical loss, particularly at 2 um where photodiode efficiency is low. We report the first loss-tolerant, audio-band squeezed light detection at 1984 nm by using a phase-sensitive amplifier to amplify the squeezed vacuum prior to detection. This technique increases the effective detection efficiency from 74% to 95% and increases the observed squeezing from 4 dB to 8 dB, the highest level of squeezing observed at this wavelength. Additionally, the shot-to-dark-noise clearance increases, extending the effective measurement bandwidth toward lower frequencies. This approach is largely wavelength-independent, extending high-fidelity quantum measurements to future gravitational-wave detectors and related quantum technologies.

quant-ph↗

arXiv2024

Low-vibration cryogenic test facility for next generation of ground-based gravitational-wave observatories

We present the design and commissioning of a cryogenic low-vibration test facility that measures displacement noise from a gram-scale silicon cantilever at the level of 10$^{-16}\, \mathrm{m/\sqrt{Hz}}$ at 1kHz. A volume of $\sim$36 litres is enclosed by radiation shields cooling an optical test cavity that is suspended from a multi-stage pendulum chain providing isolation from acoustic and environmental noise. This 3kg test cavity housing a crystalline silicon cantilever is radiatively cooled to 123K in 41 hours and held at that temperature over many months with a relative temperature stability of $\pm$1mK. The facility is capable of interferometrically measuring temperature-dependent broadband displacement noise between 50Hz and 10kHz where current and future ground-based gravitational wave observatories are most sensitive. With suitable cantilever design, the cryogenic facility we describe here will allow for the measurement of broadband thermal noise in crystalline silicon at 123K. This will guide the design of suspensions in planned future cryogenic ground-based gravitational-wave detectors such as LIGO Voyager and the Einstein Telescope. This facility is also suitable for the testing of new mirror coatings at cryogenic temperatures.

physics.ins-det↗

arXiv2024

Amplified Squeezed States: Analyzing Loss and Phase Noise

Phase-sensitive amplification of squeezed states is a technique to mitigate high detection loss, e.g. at 2-micrometre wavelengths. Our analytical model of amplified squeezed states expands on the effect of phase noise and derives two practical parameters: the effective measurable squeezing and the effective detection efficiency. A case study including realistic parameters demonstrates the benefit of phase-sensitive amplification. We identified the phase noise in the optical parametric amplifier (OPA) minimally affects the squeezing level, enabling increased gain of the OPA. This scheme is compatible with proposed gravitational-wave detectors and consistent with applications in quantum systems that are degraded by output coupling loss in optical waveguides.

quant-ph↗

arXiv2021

LIGOs Quantum Response to Squeezed States

Gravitational Wave interferometers achieve their profound sensitivity by combining a Michelson interferometer with optical cavities, suspended masses, and now, squeezed quantum states of light. These states modify the measurement process of the LIGO, VIRGO and GEO600 interferometers to reduce the quantum noise that masks astrophysical signals; thus, improvements to squeezing are essential to further expand our gravitational view of the universe. Further reducing quantum noise will require both lowering decoherence from losses as well more sophisticated manipulations to counter the quantum back-action from radiation pressure. Both tasks require fully understanding the physical interactions between squeezed light and the many components of km-scale interferometers. To this end, data from both LIGO observatories in observing run three are expressed using frequency-dependent metrics to analyze each detector's quantum response to squeezed states. The response metrics are derived and used to concisely describe physical mechanisms behind squeezing's simultaneous interaction with transverse-mode selective optical cavities and the quantum radiation pressure noise of suspended mirrors. These metrics and related analysis are broadly applicable for cavity-enhanced optomechanics experiments that incorporate external squeezing, and -- for the first time -- give physical descriptions of every feature so far observed in the quantum noise of the LIGO detectors.

physics.ins-det↗

arXiv2020

Quantum correlations between the light and kilogram-mass mirrors of LIGO

Measurement of minuscule forces and displacements with ever greater precision encounters a limit imposed by a pillar of quantum mechanics: the Heisenberg uncertainty principle. A limit to the precision with which the position of an object can be measured continuously is known as the standard quantum limit (SQL). When light is used as the probe, the SQL arises from the balance between the uncertainties of photon radiation pressure imposed on the object and of the photon number in the photoelectric detection. The only possibility surpassing the SQL is via correlations within the position/momentum uncertainty of the object and the photon number/phase uncertainty of the light it reflects. Here, we experimentally prove the theoretical prediction that this type of quantum correlation is naturally produced in the Laser Interferometer Gravitational-wave Observatory (LIGO). Our measurements show that the quantum mechanical uncertainties in the phases of the 200 kW laser beams and in the positions of the 40 kg mirrors of the Advanced LIGO detectors yield a joint quantum uncertainty a factor of 1.4 (3dB) below the SQL. We anticipate that quantum correlations will not only improve gravitational wave (GW) observatories but all types of measurements in future.

quant-ph↗

arXiv2018

Early Earthquake Detection with a Dual Torsion-Beam Gravimeter

Ground mass is redistributed during an earthquake causing the local gravitational potential to change. These gravitational fluctuations travel at the speed of light meaning they will arrive at a remote location significantly earlier than the fastest seismic waves. If these gravitational signals are measured by a gravimeter then early warning can be provided for an imminent earthquake. Earlier detection of earthquakes could be used to protect crucial infrastructure and save lives. The Torsion Pendulum Dual Oscillator (TorPeDO) is a gravity gradient sensor that has been constructed at the Australian National University. In this article we investigate the feasibility of measuring prompt gravitational transients from earthquakes with the TorPeDO. We simulated the response of the sensor to these signals and inserted these responses into scaled TorPeDO strain data to test their detection using a matched filter search. This simulation allows us to estimate the signal-to-noise ratio and detection time of the sensor to these transient signals, along with the influence of different detection thresholds on range and detection time. This article also proposes a method of earthquake localisation using TorPeDO sensors without the need for accurate signal timing. A real-time estimate of earthquake magnitude can be produced by combining this calculated location with TorPeDO strain data. We find that a TorPeDO system operating at design sensitivity would measure a moment magnitude 7.1 earthquake, 200~km away, reaching a signal-to-noise ratio of 5 at 15.7~s after the event starts. This will provide roughly 50.96~s of warning before the arrival of the first S waves.

physics.ins-det↗

arXiv2018

Implications of dedicated seismometer measurements on Newtonian-noise cancellation for Advanced LIGO

Newtonian gravitational noise from seismic fields will become a limiting noise source at low frequency for second-generation, gravitational-wave detectors. It is planned to use seismic sensors surrounding the detectors' test masses to coherently subtract Newtonian noise using Wiener filters derived from the correlations between the sensors and detector data. In this work, we use data from a seismometer array deployed at the corner station of the LIGO Hanford detector combined with a tiltmeter for a detailed characterization of the seismic field and to predict achievable Newtonian-noise subtraction levels. As was shown previously, cancellation of the tiltmeter signal using seismometer data serves as the best available proxy of Newtonian-noise cancellation. According to our results, a relatively small number of seismometers is likely sufficient to perform the noise cancellation due to an almost ideal two-point spatial correlation of seismic surface displacement at the corner station, or alternatively, a tiltmeter deployed under each of the two test masses of the corner station at Hanford will be able to efficiently cancel Newtonian noise. Furthermore, we show that the ground tilt to differential arm-length coupling observed during LIGO's second science run is consistent with gravitational coupling.

astro-ph.IM↗

arXiv2006

Compensation of Strong Thermal Lensing in High Optical Power Cavities

In an experiment to simulate the conditions in high optical power advanced gravitational wave detectors such as Advanced LIGO, we show that strong thermal lenses form in accordance with predictions and that they can be compensated using an intra-cavity compensation plate heated on its cylindrical surface. We show that high finesse ~1400 can be achieved in cavities with internal compensation plates, and that the cavity mode structure can be maintained by thermal compensation. It is also shown that the measurements allow a direct measurement of substrate optical absorption in the test mass and the compensation plate.

gr-qc↗