arXiv subjects

B. Van Compernolle

Publications and source records attributed to B. Van Compernolle.

6 recordsLinked to original sources

arXiv2026

First Experimental Evidence of Helicon Current Drive

Helicon current drive is an attractive solution for driving current to sustain steady state tokamak operation in reactor conditions. Dedicated DIII-D experiments have been conducted with a MW-level helicon system and successfully demonstrated core power deposition and current drive with helicon waves launched via a traveling wave antenna. The profile of the measured electron temperature response to helicon power injection is in good agreement with time-dependent integrated modeling that incorporates ray tracing and the effects of thermal transport simultaneously. When the helicon power is injected continuously to drive co-$I_p$ current, the reconstructed safety factor profile flattens significantly faster and sawteeth are triggered earlier than in comparison shots where the helicon is replaced by a comparable amount of electron cyclotron heating. Calculation of the helicon-driven current profile yields a peaked profile in the core, consistent with the observed power deposition profile and in good agreement with ray tracing predictions. Taken together, these experimental results represent strong evidence for the first definitive observation of auxiliary current drive due to helicon waves on any device.

physics.plasm-ph↗

arXiv2026

Understanding Carbon Sourcing and Transport Originating from the Helicon Antenna Surfaces During High-Power Helicon Discharge in DIII-D Tokamak

The high-power helicon wave system in the DIII-D tokamak introduces new plasma--material interaction (PMI) challenges due to rectified RF sheath potentials forming near antenna structures and surrounding tiles. Using the STRIPE modeling framework-which integrates SOLPS-ITER, COMSOL, RustBCA, and GITR/GITRm-we simulate carbon erosion, re-deposition, and global impurity transport in two H-mode discharges with varying antenna--plasma gaps and RF powers. COMSOL predicts rectified sheath potentials of 1-5 kV, localized near the bottom of the antenna where magnetic field lines intersect at grazing angles. Erosion is dominated by carbon self-sputtering, with RF-accelerated D+ ions contributing up to 1 % of the total erosion flux. GITRm simulations show that in the small-gap case, only ~ 13 % of eroded carbon is re-deposited locally, with 58 % transported into the core. In contrast, the large-gap case exhibits lower total erosion, along with reduced core penetration (~ 35 %) and weaker re-deposition (~ 4 %), consistent with lower collisionality and limited plasma contact. The simulation trends are consistent with experimental observations, which have not shown elevated core impurity levels during helicon operation in the present graphite-wall configuration. However, under certain plasma conditions and magnetic configurations, the helicon antenna may still act as a finite source of net erosion and core-directed impurity transport, potentially influencing the overall core impurity balance. These findings emphasize the need for sheath-aware antenna designs and predictive impurity transport modeling to support future high-power RF systems with high-Z first wall materials in fusion devices.

physics.plasm-ph↗

arXiv2025

First Demonstration of Resonant Pitch-Angle Scattering of Relativistic Electrons by Externally-Launched Helicon Waves

Helicon waves satisfying the normal wave-particle cyclotron resonance are observed to limit the growth and maximum energy of relativistic electrons (REs) in low-density Ohmic DIII-D tokamak plasmas. Following the application of helicon waves, pitch-angle scattering of high-energy REs causes an increase in both synchrotron and electron-cyclotron emissions. The hard x-ray emission, a proxy for the RE population, ceases to grow; and energy-resolved hard x-ray measurements also show a striking decrease in the number of high-energy REs (above the resonance at approximately \SI{8}{MeV}) to below the noise floor. This occurs despite the toroidal electric field remaining high enough to drive exponential RE growth in the absence of helicon waves. These results open new directions for limiting the maximum energy of RE populations in laboratory and fusion plasmas.

physics.plasm-ph↗

arXiv2024

Real-time steerable frequency-stepped Doppler Backscattering (DBS) System for local helicon wave electric field measurements on the DIII-D tokamak

A new frequency-stepped Doppler backscattering (DBS) system has been integrated with a real-time steerable electron cyclotron heating launcher to probe local background turbulence (f<10 MHz) and high-frequency (20-550 MHz) density fluctuations in the DIII-D tokamak. The launcher enables 2D steering (horizontal and vertical) over wide angular ranges to optimize probe location and wavenumber response, with vertical steering adjustable in real time during discharges. The DBS system utilizes a programmable frequency synthesizer with adjustable dwell time, capable of stepping across the E-band frequency range (60-90 GHz) in real time, launching either O or X-mode polarized millimeter waves. This setup facilitates diagnosis of the complex spatial structure of high-power (>200 kW) helicon waves (476 MHz) during current drive experiments. Real-time scans reveal broadband density fluctuations around the helicon frequency, attributed to backscattering of the DBS millimeter wave probe from plasma turbulence modulated by the helicon wave. These fluctuations appear as high-frequency sidebands in the turbulence spectrum, effectively 'tagging' the background turbulence with the helicon wave's electric field. This method allows for monitoring local helicon wave amplitude by comparing high-frequency signal amplitude to background turbulence. Coupled with real-time scanning of measurement location and wavenumber, this allows for rapid helicon wave power distribution determination during steady-state plasma operation, potentially validating predictive models like GENRAY or AORSA for helicon current drive in DIII-D plasmas.

physics.plasm-ph↗

arXiv2023

A novel Doppler backscattering (DBS) system to simultaneously monitor radio frequency plasma fluctuations and low frequency turbulence

A novel quadrature Doppler Backscattering (DBS) system has been developed and optimized for the E-band (60-90GHz) frequency range using either O-mode or X-mode polarization in DIII-D plasmas. In general, DBS measures the amplitude of density fluctuations and their velocity in the lab frame. The system can simultaneously monitor both low-frequency turbulence (f < 10MHz) and radiofrequency plasma density fluctuations over a selectable frequency range (20-500 MHz). Detection of high-frequency fluctuations has been demonstrated for low harmonics of the ion cyclotron frequency (e.g., 2fci~23MHz) and externally driven high-frequency helicon waves (f = 476MHz) using an adjustable frequency down conversion system. Importantly, this extends the application of DBS to a high-frequency spectral domain while maintaining important turbulence and flow measurement capabilities. This unique system has low phase noise, good temporal resolution (sub-millisecond) and excellent wavenumber coverage (k_θ ~ 1-20cm^{-1} and k_r ~ 20-30cm^{-1}). As a demonstration, localized internal DIII-D plasma measurements are presented from turbulence (f <= 5MHz), Alfvenic waves (f~6.5MHz), ion cyclotron waves (f >= 20MHz) as well as fluctuations around 476MHz driven by an external high-power 476 MHz helicon wave antenna. In the future, helicon measurements will be used to validate GENRAY and AORSA modeling tools for prediction of helicon wave propagation, absorption and current drive location for the newly installed helicon current drive system on DIII-D.

physics.plasm-ph↗

arXiv2017

Observations of a Field-Aligned Ion/Ion-Beam Instability in a Magnetized Laboratory Plasma

Collisionless coupling between super Alfvénic ions and an ambient plasma parallel to a background magnetic field is mediated by a set of electromagnetic ion/ion-beam instabilities including the resonant right hand instability (RHI). To study this coupling and its role in parallel shock formation, a new experimental configuration at the University of California, Los Angeles utilizes high-energy and high-repetition-rate lasers to create a super-Alfvénic field-aligned debris plasma within an ambient plasma in the Large Plasma Device (LAPD). We used a time-resolved fluorescence monochromator and an array of Langmuir probes to characterize the laser plasma velocity distribution and density. The debris ions were observed to be sufficiently super-Alfvénic and dense to excite the RHI. Measurements with magnetic flux probes exhibited a right-hand circularly polarized frequency chirp consistent with the excitation of the RHI near the laser target. We compared measurements to 2D hybrid simulations of the experiment.

physics.plasm-ph↗