arXiv subjects

Bayu Dharmaputra

Publications and source records attributed to Bayu Dharmaputra.

5 recordsLinked to original sources

arXiv2026

Acoustic Black Hole Damper for Thermoacoustic Instability Control in a Hydrogen Combustor

Thermoacoustic instabilities remain a major challenge in the operation and development of modern gas turbine combustors for power generation and propulsion. In laboratory environments, such instabilities can also hinder the accurate characterization of key thermoacoustic properties of the flames. Many modern combustors therefore employ wall-mounted acoustic dampers, such as Helmholtz or quarter-wave resonators; however, these devices are typically effective only over narrow frequency ranges. In this study, the application of perforated acoustic black holes (ABHs) as broadband passive dampers for thermoacoustic instability mitigation is investigated. Several ABH designs are additively manufactured and experimentally characterized through scattering matrix measurements. A reduced-order model based on the transfer matrix method is developed and is shown to be in good agreement with the experimental results. Using this validated model, a damper design is optimized to maximize acoustic dissipation over the frequency range 500-2000 Hz. The optimized perforated ABH damper is installed in the plenum section of the combustor test rig, and its thermoacoustic performance is evaluated over a range of equivalence ratios and outlet boundary conditions. Across all operating conditions considered, the ABH damper leads to a substantial reduction of the amplitude of the acoustic pressure oscillations. These results demonstrate the potential of perforated ABH-based dampers as a robust and broadband passive solution for mitigating thermoacoustic instabilities in hydrogen-fueled combustors.

physics.flu-dyn↗

arXiv2024

Flame Transfer Function Measurement of a Hydrogen-Blended Sequential Combustor

The flame transfer function (FTF) relates acoustic perturbations and the coherent heat release rate response. This frequency-dependent function governs the thermoacoustic stability of a combustor. The FTF measurement is therefore of great interest for predicting the stability of the a practical combustor connected to the engine's compressor and turbine. In this study, the flame transfer function of the sequential flame of an atmospheric constant pressure sequential combustor (CPSC) is experimentally measured. The thermal power of both the first- and second-stage flames is kept constant and their ratio is fixed at 1:1. The effects of hydrogen blending in the first and second stage fuel mixture on the sequential FTF are analyzed. The FTF of the sequential flame is fitted with a distributed time delay (DTD) model with two pulses. The trends of the model parameters obtained are consistent with the chemiluminescence OH* of the sequential flame.

physics.flu-dyn↗

arXiv2024

BOATS: Bayesian Optimization for Active Control of ThermoacousticS

This investigation presents novel adaptive control algorithms specifically designed to address and mitigate thermoacoustic instabilities. Two control strategies are available to alleviate this issue: active and passive. Active control strategies have a wider flexibility than passive control strategies because they can adapt to the operating conditions of the gas turbine. However, optimizing the control parameters remains a challenge, especially if additional constraints have to be fulfilled, such as e.g. pollutant emission levels. To address this issue, we propose three adaptive control strategies based on Bayesian optimization. The first and foundational algorithm is the safeOpt algorithm, and the two adaptations that have been made are stageOpt and shrinkAlgo. The Gaussian Process Regressor (GPR) is employed to approximate both the objective and constraint functions, with continuous updates occurring during iterations. The algorithms also enable the transfer of knowledge obtained from one operating point to another, thereby reducing the number of iterations needed to reach the optimal point. We demonstrate the effectiveness of the algorithms both numerically and through two distinct experimental validations. In the numerical demonstration, we employ a low-order thermoacoustic network model to simulate a single-stage combustor setup equipped with loudspeaker actuation and a gain-delay ($n-\tau$) controller for active stabilization. The first experimental demonstration has the same structure as the numerical case. For the second experimental validation, we apply the framework to a sequential combustor configuration utilizing nanosecond repetitively pulsed discharges (NRPD) as the control actuator. This demonstrates the framework's adaptability to various control actuation methods in turbulent combustors where control parameter optimization is required.

math.OC↗

arXiv2023

Thermoacoustic Stabilization of a Sequential Combustor with Ultra-low-power Nanosecond Repetitively Pulsed Discharges

This study demonstrates the stabilization of a sequential combustor with Nanosecond Repetitively Pulsed Discharges (NRPD). A constant pressure sequential combustor offers key advantages compared to a conventional combustor, in particular, a higher fuel flexibility and a wider operational range. However, thermoacoustic instabilities remain a barrier to further widen the operational range of these combustors. Passive control strategies to suppress these instabilities, such as Helmholtz dampers, have been used in some industrial systems thanks to their simplicity in terms of implementation. Active control strategies are however not found in practical combustors, mainly due to the lack of robust actuators able to operate in harsh conditions with sufficient control authority. In this study, we demonstrate that thermoacoustic instabilities can be suppressed by using a non-equilibrium plasma produced with NRPD in a lab-scale atmospheric sequential combustor operated at 73.4 kW of thermal power. We employ continuous NRPD forcing to influence the combustion process in the sequential combustor. The two governing parameters are the pulse repetition frequency (PRF) and the plasma generator voltage. We examine the effect of both parameters on the acoustic amplitude, the NO emissions, and the flame centre of mass. We observe that for some operating conditions, with plasma power of 1.1 W, which is about 1.5$\times$ $10^{-3}$ percent of the thermal power of the flames, the combustor can be thermoacoustically stabilized. This finding motivates further research on the optimization of the plasma parameters as a function of the thermoacoustic properties of the combustor where it is applied. This study is a pioneering effort in controlling the thermoacoustic stability of turbulent flames with plasma discharges at such low power compared to the thermal power of the sequential combustor.

physics.flu-dyn↗

arXiv2023

Numerical study of nitrogen oxides chemistry during plasma assisted combustion in a sequential combustor

Plasma Assisted Combustion (PAC) is a promising technology to enhance the combustion of lean mixtures prone to instabilities and flame blow-off. Although many PAC experiments demonstrated combustion enhancement, several studies report an increase in NOx emissions. The aim of this study is to determine the kinetic pathways leading to NOx formation in the second stage of a sequential combustor assisted by Nanosecond Repetitively Pulsed Discharges (NRPDs). For this purpose, Large Eddy Simulation (LES) associated with an accurate description of the combustion/NOx chemistry and a phenomenological model of the plasma kinetics is used. Detailed kinetics 0-Dimensional reactors complement the study. First, the LES setup is validated by comparison with experiments. Then, the NOx chemistry is analyzed. For the conditions of operation studied, it is shown that the production of atomic nitrogen in the plasma by direct electron impact on nitrogen molecules increases the formation of NO. Then, the NO molecules are transported through the turbulent flame without being strongly affected. This study illustrates the need to limit the diatomic nitrogen dissociation process in order to mitigate harmful emissions. More generally, the very good agreement with experimental measurements demonstrates the capability of LES combined with accurate models to predict the NRPD effects on both turbulent combustion and NOx emissions.

physics.flu-dyn↗