Benjamin H. Williams | Searcharxiv

arXiv2015

Surface acoustic wave devices on bulk ZnO at low temperature

Surface acoustic wave (SAW) devices based on thin films of ZnO are a well established technology. However, SAW devices on bulk ZnO crystals are not practical at room temperature due to the significant damping caused by finite electrical conductivity of the crystal. Here, by operating at low temperatures, we demonstrate effective SAW devices on the (0001) surface of bulk ZnO crystals, including a delay line operating at SAW wavelengths of λ = 4 and 6 μm and a one-port resonator at a wavelength of λ = 1.6 μm. We find that the SAW velocity is temperature dependent, reaching $v \simeq 2.68$ km/s at 10mK. Our resonator reaches a maximum quality factor of $Q_i \simeq 1.5\times 10^5$, demonstrating that bulk ZnO is highly viable for low temperature SAW applications. The performance of the devices is strongly correlated with the bulk conductivity, which quenches SAW transmission above about 200 K.

cond-mat.mtrl-sci↗

arXiv2015

Soft chemical control of superconductivity in lithium iron selenide hydroxides Li1-xFex(OH)Fe1-ySe

Hydrothermal synthesis is described of layered lithium iron selenide hydroxides Li1-xFex(OH)Fe1-ySe (x ~ 0.2; 0.02 < y < 0.15) with a wide range of iron site vacancy concentrations in the iron selenide layers. This iron vacancy concentration is revealed as the only significant compositional variable and as the key parameter controlling the crystal structure and the electronic properties. Single crystal X-ray diffraction, neutron powder diffraction and X-ray absorption spectroscopy measurements are used to demonstrate that superconductivity at temperatures as high as 40 K is observed in the hydrothermally synthesised samples when the iron vacancy concentration is low (y < 0.05) and when the iron oxidation state is reduced slightly below +2, while samples with a higher vacancy concentration and a correspondingly higher iron oxidation state are not superconducting. The importance of combining a low iron oxidation state with a low vacancy concentration in the iron selenide layers is emphasised by the demonstration that reductive post-synthetic lithiation of the samples turns on superconductivity with critical temperatures exceeding 40 K by displacing iron atoms from the Li1-xFex(OH) reservoir layer to fill vacancies in the selenide layer

cond-mat.supr-con↗