arXiv subjects

Bernard Cousin

Publications and source records attributed to Bernard Cousin.

15 recordsLinked to original sources

arXiv2015

Energy-Aware Forwarding Strategy for Metro Ethernet Networks

Energy optimization has become a crucial issue in the realm of ICT. This paper addresses the problem of energy consumption in a Metro Ethernet network. Ethernet technology deployments have been increasing tremendously because of their simplicity and low cost. However, much research remains to be conducted to address energy efficiency in Ethernet networks. In this paper, we propose a novel Energy Aware Forwarding Strategy for Metro Ethernet networks based on a modification of the Internet Energy Aware Routing (EAR) algorithm. Our contribution identifies the set of links to turn off and maintain links with minimum energy impact on the active state. Our proposed algorithm could be a superior choice for use in networks with low saturation, as it involves a tradeoff between maintaining good network performance and minimizing the active links in the network. Performance evaluation shows that, at medium load traffic, energy savings of 60% can be achieved. At high loads, energy savings of 40% can be achieved without affecting the network performance.

cs.NI↗

arXiv2015

A multipath energy-conserving routing protocol for wireless ad hoc networks lifetime improvement

Ad hoc networks are wireless mobile networks that can operate without infrastructure and without centralized network management. Traditional techniques of routing are not well adapted. Indeed, their lack of reactivity with respect to the variability of network changes makes them difficult to use. Moreover, conserving energy is a critical concern in the design of routing protocols for ad hoc networks, because most mobile nodes operate with limited battery capacity, and the energy depletion of a node affects not only the node itself but also the overall network lifetime. In all proposed single-path routing schemes a new path-discovery process is required once a path failure is detected, and this process causes delay and wastage of node resources. A multipath routing scheme is an alternative to maximize the network lifetime. In this paper, we propose an energy-efficient multipath routing protocol, called AOMR-LM (Ad hoc On-demand Multipath Routing with Lifetime Maximization), which preserves the residual energy of nodes and balances the consumed energy to increase the network lifetime. To achieve this goal, we used the residual energy of nodes for calculating the node energy level. The multipath selection mechanism uses this energy level to classify the paths. Two parameters are analyzed: the energy threshold beta and the coefficient alpha. These parameters are required to classify the nodes and to ensure the preservation of node energy. Our protocol improves the performance of mobile ad hoc networks by prolonging the lifetime of the network. This novel protocol has been compared with other protocols: AOMDV and ZD-AOMDV. The protocol performance has been evaluated in terms of network lifetime, energy consumption, and end-to-end delay.

cs.NI↗

arXiv2014

Best Operator Policy in a Heterogeneous Wireless Network

In this paper, we perform a business analysis of our hybrid decision algorithm for the selection of the access in a multi-operator networks environment. We investigate the ability of the operator to express his strategy and influence the access selection for his client. In this purpose, we study two important coefficients of the previously proposed cost function, Wu and Wop, and show that the value of these coefficients is not arbitrary. Simulation results show that the value of the ratio Wu/Wop enables a selection decision respecting operator's strategy and it affects the achieved global profit for all cooperating operators.

cs.NI↗

arXiv2014

Hybrid Decision Algorithm for Access Selection in Multi-operator Networks

In this paper, we propose a hybrid decision algorithm for the selection of the access in multi-operator networks environment, where competing operators share their radio access networks to meet traffic and data rate demands. The proposed algorithm guarantees the user satisfaction and a global gain for all cooperating operators. Simulation results prove the efficiency of the proposed scheme and show that the cooperation between operators achieves benefits to both users and operators; user acceptance as well as the operator resource utilization and the operator revenue increase.

cs.NI↗

arXiv2010

Light-Hierarchy: The Optimal Structure for Multicast Routing in WDM Mesh Networks

Based on the false assumption that multicast incapable (MI) nodes could not be traversed twice on the same wavelength, the light-tree structure was always thought to be optimal for multicast routing in sparse splitting Wavelength Division Multiplexing (WDM) networks. In fact, for establishing a multicast session, an MI node could be crosswise visited more than once to switch a light signal towards several destinations with only one wavelength through different input and output pairs. This is called Cross Pair Switching (CPS). Thus, a new multicast routing structure light-hierarchy is proposed for all-optical multicast routing, which permits the cycles introduced by the CPS capability of MI nodes. We proved that the optimal structure for minimizing the cost of multicast routing is a set of light-hierarchies rather than the light-trees in sparse splitting WDM networks. Integer linear programming (ILP) formulations are developed to search the optimal light-hierarchies. Numerical results verified that the light-hierarchy structure could save more cost than the light-tree structure.

cs.NI↗

arXiv2010

Avoidance of multicast incapable branching nodes for multicast routing in WDM networks

In this articlewestudy themulticast routing problem in all-opticalWDMnetworks under the spare light splitting constraint. To implement a multicast session, several light-trees may have to be used due to the limited fanouts of network nodes. Although many multicast routing algorithms have been proposed in order to reduce the total number of wavelength channels used (total cost) for a multicast session, the maximum number of wavelengths required in one fiber link (link stress) and the end-to-end delay are two parameters which are not always taken into consideration. It is known that the shortest path tree (SPT) results in the optimal end-to-end delay, but it can not be employed directly for multicast routing in sparse light splitting WDM networks. Hence, we propose a novel wavelength routing algorithm which tries to avoid the multicast incapable branching nodes (MIBs, branching nodes without splitting capability) in the shortest-path-based multicast tree to diminish the link stress. Good parts of the shortest-path-tree are retained by the algorithm to reduce the end-to-end delay. The algorithm consists of tree steps: (1) aDijkstraPro algorithmwith priority assignment and node adoption is introduced to produce a SPT with up to 38% fewer MIB nodes in the NSF topology and 46% fewerMIB nodes in the USA Longhaul topology, (2) critical articulation and deepest branch heuristics are used to process the MIB nodes, (3) a distance-based light-tree reconnection algorithm is proposed to create the multicast light-trees. Extensive simulations demonstrate the algorithm's efficiency in terms of link stress and end-to-end delay.

cs.NI↗

arXiv2010

Hypo-Steiner heuristic for multicast routing in all-optical WDM mesh networks

In sparse light splitting all-optical WDM networks, the more destinations a light-tree can accommodate, the fewer light-trees andwavelengths amulticast session will require. In this article, a Hypo-Steiner light-tree algorithm (HSLT) is proposed to construct a HSLT light-tree to include as many destinations as possible. The upper bound cost of the light-trees built by HSLT is given as N(N -1)/2, where N is the number of nodes in the network. The analytical model proves that, under the same condition, more destinations could be held in a HSLT than a Member-Only (Zhang et al., J. Lightware Technol, 18(12), 1917-1927 2000.) light-tree. Extensive simulations not only validate the proof but also show that the proposed heuristic outperforms the existing multicast routing algorithms by a large margin in terms of link stress, throughput, and efficiency ofwavelength usage.

cs.NI↗

arXiv2010

Is Light-Tree Structure Optimal for Multicast Routing in Sparse Light Splitting WDM Networks?

To minimize the number of wavelengths required by a multicast session in sparse light splitting wavelength division multiplexing (WDM) networks, a light-hierarchy structure, which occupies the same wavelength on all links, is proposed to span as many destinations as possible. Different from a light-tree, a light-hierarchy accepts cycles, which are used to traverse crosswise a 4-degree (or above) multicast incapable (MI) node twice (or above) and switch two light signals on the same wavelengths to two destinations in the same multicast session. In this paper, firstly, a graph renewal and distance priority light-tree algorithm (GRDP-LT) is introduced to improve the quality of light-trees built for a multicast request. Then, it is extended to compute light-hierarchies. Obtained numerical results demonstrate the GRDP-LT light-trees can achieve a much lower links stress, better wavelength channel cost, and smaller average end-to-end delay as well as diameter than the currently most efficient algorithm. Furthermore, compared to light-trees, the performance in terms of link stress and network throughput is greatly improved again by employing the light-hierarchy, while consuming the same amount of wavelength channel cost.

cs.NI↗

arXiv2010

Optical Multicast Routing Under Light Splitter Constraints

During the past few years, we have observed the emergence of new applications that use multicast transmission. For a multicast routing algorithm to be applicable in optical networks, it must route data only to group members, optimize and maintain loop-free routes, and concentrate the routes on a subset of network links. For an all-optical switch to play the role of a branching router, it must be equipped with a light splitter. Light splitters are expensive equipments and therefore it will be very expensive to implement splitters on all optical switches. Optical light splitters are only implemented on some optical switches. That limited availability of light splitters raises a new problem when we want to implement multicast protocols in optical network (because usual multicast protocols make the assumption that all nodes have branching capabilities). Another issue is the knowledge of the locations of light splitters in the optical network. Nodes in the network should be able to identify the locations of light splitters scattered in the optical network so it can construct multicast trees. These problems must be resolved by implementing a multicast routing protocol that must take into consideration that not all nodes can be branching node. As a result, a new signaling process must be implemented so that light paths can be created, spanning from source to the group members.

cs.NI↗

arXiv2010

Performance Evaluation of the Labelled OBS Architecture

A comparison of three different Optical Burst Switching (OBS) architectures is made, in terms of performance criteria, control and hardware complexity, fairness, resource utilization, and burst loss probability. Regarding burst losses, we distinguish the losses due to burst contentions from those due to contentions of Burst Control Packets (BCP). The simulation results show that as a counterpart of an its additional hardware complexity, the labelled OBS (L-OBS) is an efficient OBS architecture compared to a Conventional OBS (C-OBS) as well as in comparison with Offset Time-Emulated OBS (E-OBS).

cs.NI↗

arXiv2009

Distance priority based multicast routing in WDM networks considering sparse light splitting

As we know, the member-only algorithm in provides the best links stress and wavelength usage for the construction of multicast light-trees in WDM networks with sparse splitting. However, the diameter of tree is too big and the average delay is also too large, which are intolerant for QoS required multimedia applications. In this paper, a distance priority based algorithm is proposed to build light-trees for multicast routing, where the Candidate Destinations and the Candidate Connectors are introduced. Simulations show the proposed algorithm is able to greatly reduce the diameter and average delay of the multicast tree (up to 51% and 50% respectively), while keep the same or get a slightly better link stress as well as the wavelength usage than the famous Member-Only algorithm.

cs.NI↗

arXiv2007

Survivable MPLS Over Optical Transport Networks: Cost and Resource Usage Analysis

In this paper we study different options for the survivability implementation in MPLS over Optical Transport Networks (OTN) in terms of network resource usage and configuration cost. We investigate two approaches to the survivability deployment: single layer and multilayer survivability and present various methods for spare capacity allocation (SCA) to reroute disrupted traffic. The comparative analysis shows the influence of the offered traffic granularity and the physical network structure on the survivability cost: for high bandwidth LSPs, close to the optical channel capacity, the multilayer survivability outperforms the single layer one, whereas for low bandwidth LSPs the single layer survivability is more cost-efficient. On the other hand, sparse networks of low connectivity parameter use more wavelengths for optical path routing and increase the configuration cost, as compared with dense networks. We demonstrate that by mapping efficiently the spare capacity of the MPLS layer onto the resources of the optical layer one can achieve up to 22% savings in the total configuration cost and up to 37% in the optical layer cost. Further savings (up to 9 %) in the wavelength use can be obtained with the integrated approach to network configuration over the sequential one, however, at the increase in the optimization problem complexity. These results are based on a cost model with different cost variations, and were obtained for networks targeted to a nationwide coverage.

cs.NI↗

arXiv2007

Heuristic Solution to Protect Communications in WDM Networks using P-cycles

Optical WDM mesh networks are able to transport huge amount of information. The use of such technology however poses the problem of protection against failures such as fibre cuts. One of the principal methods for link protection used in optical WDM networks is pre-configured protection cycle (p-cycle). The major problem of this method of protection resides in finding the optimal set of p-cycles which protect the network for a given distribution of working capacity. Existing heuristics generate a large set of p-cycle candidates which are entirely independent of the network state, and from then the good sub-set of p-cycles which will protect the network is selected. In this paper, we propose a new algorithm of generation of p-cycles based on the incremental aggregation of the shortest cycles. Our generation of p-cycles depends on the state of the network. This enables us to choose an efficient set of p-cycles which will protect the network. The set of p-cycles that we generate is the final set which will protect the network, in other words our heuristic does not go through the additional step of p-cycle selection

cs.NI↗

arXiv2007

Optimized Design of Survivable MPLS over Optical Transport Networks. Optical Switching and Networking

In this paper we study different options for the survivability implementation in MPLS over Optical Transport Networks in terms of network resource usage and configuration cost. We investigate two approaches to the survivability deployment: single layer and multilayer survivability and present various methods for spare capacity allocation (SCA) to reroute disrupted traffic. The comparative analysis shows the influence of the traffic granularity on the survivability cost: for high bandwidth LSPs, close to the optical channel capacity, the multilayer survivability outperforms the single layer one, whereas for low bandwidth LSPs the single layer survivability is more cost-efficient. For the multilayer survivability we demonstrate that by mapping efficiently the spare capacity of the MPLS layer onto the resources of the optical layer one can achieve up to 22% savings in the total configuration cost and up to 37% in the optical layer cost. Further savings (up to 9 %) in the wavelength use can be obtained with the integrated approach to network configuration over the sequential one, however, at the increase in the optimization problem complexity. These results are based on a cost model with actual technology pricing and were obtained for networks targeted to a nationwide coverage.

cs.NI↗

arXiv2007

Dependable k-coverage algorithms for sensor networks

Redundant sensing capabilities are often required in sensor network applications due to various reasons, e.g. robustness, fault tolerance, or increased accuracy. At the same time high sensor redundancy offers the possibility of increasing network lifetime by scheduling sleep intervals for some sensors and still providing continuous service with help of the remaining active sensors. In this paper centralized and distributed algorithms are proposed to solve the k-coverage sensing problem and maximize network lifetime. When physically possible, the proposed robust Controlled Greedy Sleep Algorithm provides guaranteed service independently of node and communication errors in the network. The performance of the algorithm is illustrated and compared to results of a random solution by simulation examples.

cs.NI↗