arXiv subjects

Bernd Bruegmann

Publications and source records attributed to Bernd Bruegmann.

At least 73 records · Page 4Linked to original sources

arXiv2006

Calibration of Moving Puncture Simulations

We present single and binary black hole simulations that follow the moving puncture paradigm of simulating black-hole spacetimes without excision, and use moving boxes mesh refinement. Focussing on binary black hole configurations where the simulations cover roughly two orbits, we address five major issues determining the quality of our results: numerical discretization error, finite extraction radius of the radiation signal, physical appropriateness of initial data, gauge choice and computational performance. We also compare results we have obtained with the BAM code described here with the independent LEAN code.

gr-qc↗

arXiv2005

Dynamical evolution of quasi-circular binary black hole data

We study the fully nonlinear dynamical evolution of binary black hole data, whose orbital parameters are specified via the effective potential method for determining quasi-circular orbits. The cases studied range from the Cook-Baumgarte innermost stable circular orbit (ISCO) to significantly beyond that separation. In all cases we find the black holes to coalesce (as determined by the appearance of a common apparent horizon) in less than half an orbital period. The results of the numerical simulations indicate that the initial holes are not actually in quasi-circular orbits, but that they are in fact nearly plunging together. The dynamics of the final horizon are studied to determine physical parameters of the final black hole, such as its spin, mass, and oscillation frequency, revealing information about the inspiral process. We show that considerable resolution is required to extract accurate physical information from the final black hole formed in the merger process, and that the quasi-normal modes of the final hole are strongly excited in the merger process. For the ISCO case, by comparing physical measurements of the final black hole formed to the initial data, we estimate that less than 3% of the total energy is radiated in the merger process.

gr-qc↗

arXiv2004

Testing excision techniques for dynamical 3D black hole evolutions

We perform both distorted black hole evolutions and binary black hole head on collisions and compare the results of using a full grid to results obtained by excising the black hole interiors. In both cases the evolutions are found to run essentially indefinitely, and produce the same, convergent waveforms. Further, since both the distorted black holes and the head-on collision of puncture initial data can be carried out without excision, they provide an excellent dynamical test-bed for excision codes. This provides a strong numerical demonstration of the validity of the excision idea, namely the event horizon can be made to "protect" the spacetime from the excision boundary and allow an accurate exterior evolution.

gr-qc↗

arXiv2004

A single-domain spectral method for black hole puncture data

We calculate puncture initial data corresponding to both single and binary black hole solutions of the constraint equations by means of a pseudo-spectral method applied in a single spatial domain. Introducing appropriate coordinates, these methods exhibit rapid convergence of the conformal factor and lead to highly accurate solutions. As an application we investigate small mass ratios of binary black holes and compare these with the corresponding test mass limit that we obtain through a semi-analytical limiting procedure. In particular, we compare the binding energy of puncture data in this limit with that of a test particle in the Schwarzschild spacetime and find that it deviates by 50% from the Schwarzschild result at the innermost stable circular orbit of Schwarzschild, if the ADM mass at each puncture is used to define the local black hole masses.

gr-qc↗

arXiv2004

Late Time Analysis for Maximal Slicing of Reissner-Nordström Puncture Evolutions

We perform an analytic late time analysis for maximal slicing of the Reissner-Nordström black hole spacetime. In particular, we discuss the collapse of the lapse in terms of its late time behavior at the throat and at the event horizon for the even and the puncture lapse. In the latter case we also determine the value of the lapse at the puncture. Furthermore, in the limit of late times slice stretching effects are studied as they arise for maximal slicing of puncture evolutions. We perform numerical experiments for a Schwarzschild black hole with puncture lapse and find agreement with the analytical results.

gr-qc↗

arXiv2004

Numerical simulation of orbiting black holes

We present numerical simulations of binary black hole systems which for the first time last for about one orbital period for close but still separate black holes as indicated by the absence of a common apparent horizon. An important part of the method is the construction of comoving coordinates, in which both the angular and radial motion is minimized through a dynamically adjusted shift condition. We use fixed mesh refinement for computational efficiency.

gr-qc↗

arXiv2004

Maximal Slicing for Puncture Evolutions of Schwarzschild and Reissner-Nordström Black Holes

We prove by explicit construction that there exists a maximal slicing of the Schwarzschild spacetime such that the lapse has zero gradient at the puncture. This boundary condition has been observed to hold in numerical evolutions, but in the past it was not clear whether the numerically obtained maximal slices exist analytically. We show that our analytical result agrees with numerical simulation. Given the analytical form for the lapse, we can derive that at late times the value of the lapse at the event horizon approaches the value ${3/16}\sqrt{3} \approx 0.3248$, justifying the numerical estimate of 0.3 that has been used for black hole excision in numerical simulations. We present our results for the non-extremal Reissner-Nordström metric, generalizing previous constructions of maximal slices.

gr-qc↗

arXiv2003

Numerical stability of the AA evolution system compared to the ADM and BSSN systems

We explore the numerical stability properties of an evolution system suggested by Alekseenko and Arnold. We examine its behavior on a set of standardized testbeds, and we evolve a single black hole with different gauges. Based on a comparison with two other evolution systems with well-known properties, we discuss some of the strengths and limitations of such simple tests in predicting numerical stability in general.

gr-qc↗

arXiv2003

Quasi-equilibrium binary black hole sequences for puncture data derived from helical Killing vector conditions

We construct a sequence of binary black hole puncture data derived under the assumptions (i) that the ADM mass of each puncture as measured in the asymptotically flat space at the puncture stays constant along the sequence, and (ii) that the orbits along the sequence are quasi-circular in the sense that several necessary conditions for the existence of a helical Killing vector are satisfied. These conditions are equality of ADM and Komar mass at infinity and equality of the ADM and a rescaled Komar mass at each puncture. In this paper we explicitly give results for the case of an equal mass black hole binary without spin, but our approach can also be applied in the general case. We find that up to numerical accuracy the apparent horizon mass also remains constant along the sequence and that the prediction for the innermost stable circular orbit is similar to what has been found with the effective potential method.

gr-qc↗

arXiv2003

Gauge conditions for binary black hole puncture data based on an approximate helical Killing vector

We show that puncture data for quasicircular binary black hole orbits allow a special gauge choice that realizes some of the necessary conditions for the existence of an approximate helical Killing vector field. Introducing free parameters for the lapse at the punctures we can satisfy the condition that the Komar and ADM mass agree at spatial infinity. Several other conditions for an approximate Killing vector are then automatically satisfied, and the 3-metric evolves on a timescale smaller than the orbital timescale. The time derivative of the extrinsic curvature however remains significant. Nevertheless, quasicircular puncture data are not as far from possessing a helical Killing vector as one might have expected.

gr-qc↗

arXiv2002

Gauge conditions for long-term numerical black hole evolutions without excision

Numerical relativity has faced the problem that standard 3+1 simulations of black hole spacetimes without singularity excision and with singularity avoiding lapse and vanishing shift fail after an evolution time of around 30-40M due to the so-called slice stretching. We discuss lapse and shift conditions for the non-excision case that effectively cure slice stretching and allow run times of 1000M and more.

gr-qc↗

arXiv2002

Black Hole Excision for Dynamic Black Holes

We extend previous work on 3D black hole excision to the case of distorted black holes, with a variety of dynamic gauge conditions that are able to respond naturally to the spacetime dynamics. We show that the combination of excision and gauge conditions we use is able to drive highly distorted, rotating black holes to an almost static state at late times, with well behaved metric functions, without the need for any special initial conditions or analytically prescribed gauge functions. Further, we show for the first time that one can extract accurate waveforms from these simulations, with the full machinery of excision and dynamic gauge conditions. The evolutions can be carried out for long times, far exceeding the longevity and accuracy of even better resolved 2D codes. While traditional 2D codes show errors in quantities such as apparent horizon mass of over 100% by t = 100M, and crash by t = 150M, with our new techniques the same systems can be evolved for hundreds of M's in full 3D with errors of only a few percent.

gr-qc↗

arXiv2001

Simple excision of a black hole in 3+1 numerical relativity

We describe a simple implementation of black hole excision in 3+1 numerical relativity. We apply this technique to a Schwarzschild black hole with octant symmetry in Eddington-Finkelstein coordinates and show how one can obtain accurate, long-term stable numerical evolutions.

gr-qc↗

arXiv2001

The 3D Grazing Collision of Two Black Holes

We present results for two colliding black holes (BHs), with angular momentum, spin, and unequal mass. For the first time gravitational waveforms are computed for a grazing collision from a full 3D numerical evolution. The collision can be followed through the merger to form a single BH, and through part of the ringdown period of the final BH. The apparent horizon is tracked and studied, and physical parameters, such as the mass of the final BH, are computed. The total energy radiated in gravitational waves is shown to be consistent with the total mass of the spacetime and the final BH mass. The implication of these simulations for gravitational wave astronomy is discussed.

gr-qc↗

arXiv2000

Towards an understanding of the stability properties of the 3+1 evolution equations in general relativity

We study the stability properties of the standard ADM formulation of the 3+1 evolution equations of general relativity through linear perturbations of flat spacetime. We focus attention on modes with zero speed of propagation and conjecture that they are responsible for instabilities encountered in numerical evolutions of the ADM formulation. These zero speed modes are of two kinds: pure gauge modes and constraint violating modes. We show how the decoupling of the gauge by a conformal rescaling can eliminate the problem with the gauge modes. The zero speed constraint violating modes can be dealt with by using the momentum constraints to give them a finite speed of propagation. This analysis sheds some light on the question of why some recent reformulations of the 3+1 evolution equations have better stability properties than the standard ADM formulation.

gr-qc↗

arXiv2000

Towards a Stable Numerical Evolution of Strongly Gravitating Systems in General Relativity: The Conformal Treatments

We study the stability of three-dimensional numerical evolutions of the Einstein equations, comparing the standard ADM formulation to variations on a family of formulations that separate out the conformal and traceless parts of the system. We develop an implementation of the conformal-traceless (CT) approach that has improved stability properties in evolving weak and strong gravitational fields, and for both vacuum and spacetimes with active coupling to matter sources. Cases studied include weak and strong gravitational wave packets, black holes, boson stars and neutron stars. We show under what conditions the CT approach gives better results in 3D numerical evolutions compared to the ADM formulation. In particular, we show that our implementation of the CT approach gives more long term stable evolutions than ADM in all the cases studied, but is less accurate in the short term for the range of resolutions used in our 3D simulations.

gr-qc↗

arXiv1999

Numerical Relativity in 3+1 Dimensions

Numerical relativity is finally approaching a state where the evolution of rather general (3+1)-dimensional data sets can be computed in order to solve the Einstein equations. After a general introduction, three topics of current interest are briefly reviewed: binary black hole mergers, the evolution of strong gravitational waves, and shift conditions for neutron star binaries.

gr-qc↗

arXiv1999

Gravitational Collapse of Gravitational Waves in 3D Numerical Relativity

We demonstrate that evolutions of three-dimensional, strongly non-linear gravitational waves can be followed in numerical relativity, hence allowing many interesting studies of both fundamental and observational consequences. We study the evolution of time-symmetric, axisymmetric {\it and} non-axisymmetric Brill waves, including waves so strong that they collapse to form black holes under their own self-gravity. The critical amplitude for black hole formation is determined. The gravitational waves emitted in the black hole formation process are compared to those emitted in the head-on collision of two Misner black holes.

gr-qc↗