arXiv subjects

Bo Rao

Publications and source records attributed to Bo Rao.

8 recordsLinked to original sources

arXiv2026

Effect of externally applied resonant magnetic perturbations on resistive tearing modes

Static resonant magnetic perturbations (RMPs) generated by saddle coil current have been applied in J-TEXT tokamak experiments in order to study their effects on tearing mode instabilities. With increasing the RMP amplitude in time during the discharge, the mode stabilization is first observed, but a large locked mode follows if the RMP amplitude is increased to a too large value, indicating that the RMP amplitude is important in determining the plasma response and the tearing mode behavior. By careful adjustment of the RMP amplitude, the (partial) stabilization of the m/n =2/1 tearing mode by RMPs of moderate amplitude has been achieved without causing mode locking (m and n are the poloidal and toroidal mode numbers). To compare with experimental results, nonlinear numerical modeling based on reduced MHD equations has been carried out. With experimental parameters as input, both the mode locking and mode stabilization by RMPs are also obtained from numerical modeling. Further calculations have been carried out to study the plasma parameters affecting the mode stabilization by RMPs, including the plasma rotation frequency, viscosity, Alfv\'en velocity, and the RMPs amplitude. It is found that the suppression of the tearing mode by RMPs of moderate amplitude is possible for a sufficiently high ratio of plasma rotation velocity to the Alfv\'en speed. A larger plasma viscosity enhances the mode stabilization.

physics.plasm-ph↗

arXiv2025

MHD simulation of tilt instability during the dynamic FRC magnetic compression process

The nonlinear evolution of the tilt instability in a field reversed configuration (FRC) during the dynamic magnetic compression process has been investigated using magnetohydrodynamic (MHD) simulations with the NIMROD code [C. R. Sovinec \textit{et al.}, J. Comput. Phys. \textbf{195}, 355 (2004)]. The tilt mode induces significant deformations in the linear growth phase and results in complete confinement loss of the FRC in the nonlinear phase, with no evidence of dynamic nonlinear stabilization. The growth rate of the tilt mode increases with the compression field ramping rate and approaches an asymptotic value. Toroidal flow can reduce both the growth rate and the nonlinear saturation amplitude of the tilt mode. The stabilizing effect of the toroidal rotation is enhanced with higher compression field ramping rates due to the spontaneous toroidal field generation and increased flow shear during compression. Although the tilt mode remains unstable with a toroidal rotation Mach number close to 0.5, the onset of tilt distortion can be delayed, allowing a magnetic compression ratio up to 5.3 before the compressional heating terminates.

physics.plasm-ph↗

arXiv2025

Online Location Planning for AI-Defined Vehicles: Optimizing Joint Tasks of Order Serving and Spatio-Temporal Heterogeneous Model Fine-Tuning

Advances in artificial intelligence (AI) including foundation models (FMs), are increasingly transforming human society, with smart city driving the evolution of urban living.Meanwhile, vehicle crowdsensing (VCS) has emerged as a key enabler, leveraging vehicles' mobility and sensor-equipped capabilities. In particular, ride-hailing vehicles can effectively facilitate flexible data collection and contribute towards urban intelligence, despite resource limitations. Therefore, this work explores a promising scenario, where edge-assisted vehicles perform joint tasks of order serving and the emerging foundation model fine-tuning using various urban data. However, integrating the VCS AI task with the conventional order serving task is challenging, due to their inconsistent spatio-temporal characteristics: (i) The distributions of ride orders and data point-of-interests (PoIs) may not coincide in geography, both following a priori unknown patterns; (ii) they have distinct forms of temporal effects, i.e., prolonged waiting makes orders become instantly invalid while data with increased staleness gradually reduces its utility for model fine-tuning.To overcome these obstacles, we propose an online framework based on multi-agent reinforcement learning (MARL) with careful augmentation. A new quality-of-service (QoS) metric is designed to characterize and balance the utility of the two joint tasks, under the effects of varying data volumes and staleness. We also integrate graph neural networks (GNNs) with MARL to enhance state representations, capturing graph-structured, time-varying dependencies among vehicles and across locations. Extensive experiments on our testbed simulator, utilizing various real-world foundation model fine-tuning tasks and the New York City Taxi ride order dataset, demonstrate the advantage of our proposed method.

cs.LG↗

arXiv2024

Invariant regimes of Spencer scaling law for magnetic compression of rotating FRC plasma

The scaling laws for the magnetic compression of a toroidally rotating field reversed configuration (FRC) have been investigated in this work. The magnetohydrodynamics (MHD) simulations of the magnetic compression on rotating FRCs employing the NIMROD code [C. R. Sovinec \textit{et al.}, J. Comput. Phys. \textbf{195}, 355 (2004)], are compared with the Spencer's one-dimensional (1D) theory [R. L. Spencer \textit{et al.}, Phys. Fluids \textbf{26}, 1564 (1983)] for a wide range of initial flow speeds and profiles. The toroidal flow can influence the scalings directly through the alteration of the compressional work as also evidenced in the 1D adiabatic model, and indirectly by reshaping the initial equilibrium. However, in comparison to the static initial FRC equilibrium cases, the pressure and the radius scalings remain invariant for the magnetic compression ratio $B_{w2}/B_{w1}$ up to 6 in presence of the initial equilibrium flow, suggesting a broader applicable regime of the Spencer scaling law for FRC magnetic compression. The invariant scaling has been proven a natural consequence of the conservation of angular momentum of both fluid and magnetic field during the dynamic compression process.

physics.plasm-ph↗

arXiv2022

Robust approximation of chance constrained optimization with polynomial perturbation

This paper proposes a robust approximation method for solving chance constrained optimization (CCO) of polynomials. Assume the CCO is defined with an individual chance constraint that is affine in the decision variables. We construct a robust approximation by replacing the chance constraint with a robust constraint over an uncertainty set. When the objective function is linear or SOS-convex, the robust approximation can be equivalently transformed into linear conic optimization. Semidefinite relaxation algorithms are proposed to solve these linear conic transformations globally and their convergent properties are studied. We also introduce a heuristic method to find efficient uncertainty sets such that optimizers of the robust approximation are feasible to the original problem. Numerical experiments are given to show the efficiency of our method.

math.OC↗

arXiv2022

MHD Simulations on Magnetic Compression of Field Reversed Configurations

The magnetic compression has long been proposed a promising method for the plasma heating in a field reversed configuration (FRC), however, it remains a challenge to fully understand the physical mechanisms underlying the compression process, due to its highly dynamic nature beyond the one-dimensional (1D) adiabatic theory model [R. L. Spencer et al., Phys. Fluids 26, 1564 (1983)]. In this work, magnetohydrodynamics (MHD) simulations on the magnetic compression of FRCs using the NIMROD code [C. R. Sovinec et al., J. Comput. Phys. 195, 355 (2004)] and their comparisons with the 1D theory have been performed. The effects of the assumptions of the theory on the compression process have been explored, and the detailed profiles of the FRC during compression have been investigated. The pressure evolution agrees with the theoretical prediction under various initial conditions. The axial contraction of the FRC can be affected by the initial density profile and the ramping rate of the compression magnetic field, but the theoretical predictions on the FRC's length in general and the relation $r_s=\sqrt{2}r_o$ in particular hold approximately well during the whole compression process, where $r_s$ is the major radius of FRC separatrix and $r_o$ is that of the magnetic axis. The evolutions of the density and temperature can be affected significantly by the initial equilibrium profile and the ramping rate of the compression magnetic field. During the compression, the major radius of the FRC is another parameter that is susceptible to the ramping rate of the compression field. Basically, for the same magnetic compression ratio, the peak density is higher and the FRC's radius $r_s$ is smaller than the theoretical predictions.

physics.plasm-ph↗

arXiv2022

Quasi-static magnetic compression of field-reversed configuration plasma: Amended scalings and limits from two-dimensional MHD equilibrium

In this work, several key scaling laws of the quasi-static magnetic compression of field reversed configuration (FRC) plasma [Spencer, Tuszewski, and Linford, 1983] are amended from a series of 2D FRC MHD equilibriums numerically obtained using the Grad-Shafranov equation solver NIMEQ. Based on the new scaling for the elongation and the magnetic fields at the separatrix and the wall, the empirically stable limits for the compression ratio, the fusion gain, and the neutron yield are evaluated, which may serve as a more accurate estimate for the upper ceiling of performance from the magnetic compression of FRC plasma as a potential fusion energy as well as neutron source devices.

physics.plasm-ph↗

arXiv2021

MHD analysis on the physical designs of CFETR and HFRC

The China Fusion Engineering Test Reactor (CFETR) and the Huazhong Field Reversed Configuration (HFRC), currently both under intensive physical and engineering designs in China, are the two major projects representative of the low-density steady-state and high-density pulsed pathways to fusion. One of the primary tasks of the physics designs for both CFETR and HFRC is the assessment and analysis of the magnetohydrodynamic (MHD) stability of the proposed design schemes. Comprehensive efforts on the assessment of MHD stability of CFETR and HFRC baseline scenarios have led to preliminary progresses that may further benefit engineering designs.

physics.plasm-ph↗