Searcharxiv⌕ Search

arXiv subjects

Brigita Rozic

Publications and source records attributed to Brigita Rozic.

8 recordsLinked to original sources
arXiv2026

Multiferroic Properties of Electrospun CFO-BCTSn Nanocomposites for Magnetoelectric and Magnetic Field Sensing Applications

Multiferroic CFO-BCTSn composite nanofibers were synthesized using a sol-gel electrospinning method. Electron microscopy revealed well-defined fibers with diameters of 120-150 nm. Structural analyses using X-ray diffraction, Raman spectroscopy, and high-resolution transmission electron microscopy confirmed the coexistence of the spinel CFO phase and the perovskite BCTSn phase without detectable secondary phases. Magnetic hysteresis measurements demonstrated the magnetic behavior of the nanofibers, while piezoresponse force microscopy confirmed their piezoelectric properties. Magnetoelectric coupling was evidenced by differences between the magnetic hysteresis loops of electrically poled and unpoled samples. These lead-free composite nanofibers show potential for nanoscale magnetoelectric devices and magnetic field sensing applications.

cond-mat.mtrl-sci↗
arXiv2026

Ferroelectric KNbO3 nanoplatelets for thermally driven pyrocatalytic hydrogen evolution and dye degradation

Day- and night-induced thermal cycling offers a promising route for harvesting ambient thermal energy to drive sustainable hydrogen production and pollutant degradation. Pyroelectric materials enable this process by converting temperature fluctuations into surface charges capable of promoting catalytic water splitting and advanced oxidation reactions. In this work, we demonstrate efficient pyrocatalytic hydrogen evolution and Rhodamine B (RhB) degradation using orthorhombic ferroelectric Potassium niobate (KNbO$_3$) nanoplatelets (KN-np). Under thermal cycling between 20 and 50 $^\circ$C, KN-np achieved a hydrogen yield of 680 $μ$mol g$^{-1}$ after 30 thermal cycles, corresponding to an average hydrogen production rate of 22.67 $μ$mol g$^{-1}$ per cycle. In addition, KN-np exhibited excellent pyrocatalytic activity toward RhB degradation, reaching 84% removal after only 16 thermal cycles with an apparent kinetic rate constant of 0.11 cycle$^{-1}$. The remarkable catalytic performance is attributed to the strong spontaneous polarization and excellent pyroelectric properties of the KNbO$_3$ nanoplatelets, which promote efficient charge generation and interfacial redox reactions. These findings highlight the potential of KNbO$_3$ nanostructures as efficient pyrocatalysts for clean hydrogen production and environmental remediation.

cond-mat.mtrl-sci↗
arXiv2025

Current Advances in Magnetoelectric Composites with Various Interphase Connectivity Types

Magnetoelectric composites integrate the coupling between magnetic and piezoelectric materials to create new functionalities for potential technological applications. This coupling is typically achieved through the exchange of magnetic, electric, or elastic energy across the interfaces between the different constituent materials. Tailoring the strength of the magnetoelectric effect is primarily accomplished by selecting suitable materials for each constituent and by optimizing geometrical and microstructural designs. Various composite architectures, such as (0-3), (2-2), (1-3) and core-shell connectivities, have been studied to enhance magnetoelectric coupling and other required physical properties in composites. This review examines the latest advancements in magnetoelectric materials, focusing on the impact of different interphase connectivity types on their properties and performance. Before exploring magnetic-electric coupling, a brief overview of the historical background of multiferroic magnetoelectric composites is provided. Fundamental concepts underlying the magnetoelectric effect, piezoelectricity, and the magnetostrictive effect are explained, including their origins and examples of these materials' properties. So far, three types of magnetoelectric composite connectivities have been investigated experimentally: particulate composites (0-3), laminated and thin films (2-2), sticks embedded in matrix, core-shell particles, and coaxial fibers. An outlook on the prospects and scientific challenges in the field of multiferroic magnetoelectric composites is given at the end of this review.

cond-mat.mtrl-sci↗
arXiv2022

Enhanced electrocaloric and energy-storage properties of environment-friendly ferroelectric Ba0.9Sr0.1Ti1-xSnxO3 ceramics

The electrocaloric (EC) effect and energy storage properties of eco-friendly ferroelectric Ba0.9Sr0.1Ti1-xSnxO3 (BSTS-x) ceramics prepared by the conventional solid-state reaction method were studied. Significant energy efficiency exceeding 80% was found in our samples. In particular, BSTS-5 and BSTS-10 samples exhibit 92% and 88% efficiency, respectively, over a wide temperature range around room temperature (RT). Direct EC measurement and an indirect method based on the thermodynamic approach were used to characterize the EC effect, and both yielded consistent results. The largest electrocaloric responsivity of 0.73 K mm/kV was obtained for BSTS-0 at 368 K with an adiabatic temperature change DT(EC) of 0.55 K at a low applied electric field of only 7.4 kV/cm. With increasing Sn-content, the EC response of BSTS-x ceramics decreases, while their diffuseness increases over an extensive temperature range, centered at RT. A significant coefficient of performance (COP > 26) was found for our samples. The obtained results demonstrate the possibility of designing eco-friendly materials with higher EC effect and energy efficiency for potential solid-state refrigeration and energy storage devices.

cond-mat.mtrl-sci↗
arXiv2020

Structural, Dielectric and Ferroelectric Properties of Lead-free BCZT Ceramics Elaborated by Low-temperature Hydrothermal Processing

Lead-free Ba0.85Ca0.15Zr0.10Ti0.90O3 (BCZT) ceramics have demonstrated excellent dielectric, ferroelectric and piezoelectric properties in comparison to lead-based materials. The synthesis of pure and crystalline BCZT nanopowders at low temperatures of 25, 80 and 160 C was reported previously by using a sol-gel method followed by a hydrothermal route. In this study, the structural, dielectric and ferroelectric properties of sintered BCZT ceramics at 1250 °C for 10h were investigated. XRD measurements revealed the presence of a single perovskite phase at room temperature with the coexistence of the orthorhombic and tetragonal symmetries. The increase of grain size and the ceramic density in BCZT ceramics result in an enhancement of the dielectric and ferroelectric properties of BCZT ceramics. More interestingly, the synthesis temperature of BCZT powders with high dielectric and ferroelectric properties could be decreased to a low temperature of 160 °C, which is about 1200 °C lower when compared with solid-state reaction and 840 °C lower when compared with sol-gel methods. The BCZT ceramics elaborated at 160 °C revealed excellent electrical properties. Hence, the use of low-temperature hydrothermal processing can be encouraging for the synthesis of lead-free ceramics with high dielectric and ferroelectric properties.

cond-mat.mtrl-sci↗
arXiv2020

High Energy Storage Efficiency and Large Electrocaloric Effect in Lead-Free BaTi0.89Sn0.11O3 Ceramic

Lead-free BaTi0.89Sn0.11O3 (BTSn) ceramic was elaborated via a solid-state reaction method and its dielectric, ferroelectric, energy storage, electromechanical as well as electrocaloric properties were investigated at 25 kV/cm. Pure perovskite structure was confirmed by X-ray diffraction analysis. The maximum of the dielectric constant was found to be 17390 at 41 °C. The enhanced total energy density, the recovered energy density, and the energy storage efficiency of 92.7 mJ/cm3, 84.4 mJ/cm3, and 91.04%, respectively, were observed at 60 °C, whereas the highest storage efficiency of 95.87 % was obtained at 100 °C. At room temperature, the electromechanical strain and the large-signal piezoelectric coefficient reached a maximum of 0.07 % and 280 pm/V. The large electrocaloric effect of 0.71 K and the electrocaloric responsivity of 0.28. 10-6 K.mm/kV at 49 °C under 25 kV/cm were indirectly calculated via Maxwell relation from the ferroelectric polarization P (T, E) that was determined from the P-E hysteresis loops. By exploiting the Landau-Ginzburg-Devonshire (LGD) phenomenological theory, the electrocaloric response was estimated to be of 0.61 K at 50 °C under 25 kV/cm. We conclude that BTSn lead-free ceramic is a promising candidate for potential applications in high-efficiency energy storage devices and solid-state refrigeration technology.

cond-mat.mtrl-sci↗
arXiv2019

Structural, dielectric and electrocaloric properties of (Ba0.85Ca0.15)(Ti0.9Zr0.1-xSnx)O3 ceramics elaborated by sol-gel method

Ferroelectric ceramics (Ba0.85Ca0.15)(Ti0.9Zr0.1-xSnx)O3 (x=0.00, 0.02, 0.04, 0.06) were prepared by a sol-gel method. Structural investigation revealed the co-existence of tetragonal (P4mm) and orthorhombic (Pmm2) symmetries at room temperature for the undoped ceramic, while only a tetragonal structure (P4mm) was observed for the doped ceramics. Dielectric measurements indicate a dielectric relaxation process at high temperatures which is essentially related to the hopping of oxygen vacancies. Furthermore, a down shifting of the Curie temperature (TC) with increasing Sn4+ doping rate has been revealed. The temperature profiles of the Raman spectra unveiled the existence of polar nanoregions (PNRs) above the Curie temperature in all ceramics. The ferroelectric properties were found to be related to the microstructure. Electrocaloric effect was investigated in this system that revealed an electrocaloric responsivity of 0.225 10-6 K m/V for the composition with x = 0.04 Sn doping, where other remarkable physical properties were also observed.

cond-mat.mtrl-sci↗