arXiv subjects

Bruce A. Davidson

Publications and source records attributed to Bruce A. Davidson.

12 recordsLinked to original sources

arXiv2026

Direct Fabrication of a Superconducting Two-Dimensional Electron Gas on KTaO3(111) via Mg-Induced Surface Reduction

Two-dimensional electron gases (2DEGs) at the surfaces of KTaO3 have become an exciting platform for exploring strong spin-orbit coupling, Rashba physics, and low-carrier-density superconductivity. Yet, a large fraction of reported KTaO3-based 2DEGs has been realized through chemically complex overlayers that both generate carriers and can obscure the native electronic structure, making spectroscopic access to the underlying 2DEG challenging. Here, we demonstrate a simple and direct method to generate a superconducting 2DEG on KTaO3(111) using Mg-induced surface reduction in molecular-beam epitaxy (MBE). Mg has an extremely low sticking coefficient at elevated temperatures, enabling the formation of an ultrathin (less than 1-2 monolayers) MgO layer that is transparent to soft x-ray photoemission spectroscopy (XPS) and angle-resolved photoemission spectroscopy (ARPES). This allows direct measurement of the surface chemistry and low-energy electronic structure of the pristine reduced surface without the need for a several-nanometer-thick capping layer. XPS shows clear reduction of Ta5+ to lower oxidation states, while ARPES reveals a parabolic Ta 5d conduction band with an approximately 150 meV bandwidth and additional subband features arising from quantum confinement. Transport measurements confirm a superconducting transition below 0.7 K. Together, these results demonstrate a chemically straightforward and controllable pathway for fabricating spectroscopically accessible superconducting 2DEGs on KTaO3(111), and provide a powerful new platform for investigating the mechanisms underlying orientation-dependent superconductivity in KTaO3-based oxide interfaces.

cond-mat.supr-con↗

arXiv2025

Percolative Pathway to Stripe Order in KTaO3-Based Superconductivity

The sensitivity of low dimensional superconductors to fluctuations gives rise to emergent behaviors beyond the conventional Bardeen Cooper Schrieffer framework. Anisotropy is one such manifestation, often linked to spatially modulated electronic states and unconventional pairing mechanisms. Pronounced in plane anisotropy recently reported at KTaO3 based oxide interfaces points to the emergence of a stripe order in superconducting phase, yet its microscopic origin and formation pathway remain unresolved. Here, we show that controlled interfacial disorder in MgO/KTaO3(111) heterostructures drives a percolative evolution from localized Cooper-pair islands to superconducting puddles and eventually to stripes. The extracted stripe width matches the spin precession length, suggesting a self organized modulation governed by spin orbit coupling and lattice-symmetry breaking. These findings identify disorder as both a tuning parameter and a diagnostic probe for emergent superconductivity in two dimensional quantum materials.

cond-mat.supr-con↗

arXiv2025

Magnetic Ni-N-Ni Centers in N-substituted NiO

To explore how anion substitution modifies the existing magnetism in strongly correlated oxides, we investigate local electronic states and magnetic ordering in nickel oxide (NiO) induced by substituting oxygen (O) with nitrogen (N). Each N introduces an additional N 2p hole and modifies the magnetic moment of a neighboring nickel (Ni) cation site, as the exchange interaction between this hole and the Ni eg electrons exceeds the Ni-O-Ni superexchange interaction. This leads to the formation of Ni-N-Ni centers consisting of five spins, without perturbing the antiferromagnetic NiO lattice. These centers are studied using density functional theory and confirmed through high-resolution spectroscopy on N-substituted NiO thin films grown by molecular beam epitaxy. This type of magnetic design may enable future advances in quantum technologies based on strongly correlated materials, such as quantum sensors and spin-based qubits.

cond-mat.str-el↗

arXiv2023

Critical Role of Disorder for Superconductivity in the Series of Epitaxial Ti(O,N) Films

Realizing experimental control of superconductivity is of paramount importance to advancing both basic research and technological applications. Disorder, generally existing in most superconductors, intricately interacts with Cooper pairs and also impacts the performance of quantum devices. In this paper, we report the study of a series of Ti(O,N) crystalline films prepared via molecular beam epitaxy (MBE). We discover that substituting nitrogen (N) for oxygen (O) in TiO, namely TiO(N), considerably increases the normal-state conductivity and the superconducting transition temperature Tc. The Tc of TiO(N) falling between those of TiO (about 0.5 K) and TiN (about 6 K) is contrary to their comparable Tc predicted by the Migdal Eliasberg theory. It is found that their resistivity vs temperature obeys the Mooij rule, known as the characteristic of metallic glasses. Density functional theory (DFT) calculations demonstrate that strong disorder severely scatters the Bloch electron waves at nonzero momenta, which consequently weakens electron-phonon coupling in TiO(N).

cond-mat.supr-con↗

arXiv2022

Strain-induced magnetization control in an oxide multiferroic heterostructure

Controlling magnetism by using electric fields is a goal of research towards novel spintronic devices and future nano-electronics. For this reason, multiferroic heterostructures attract much interest. Here we provide experimental evidence, and supporting DFT analysis, of a transition in La0.65Sr0.35MnO3 (LSMO) thin film to a stable ferromagnetic phase, that is induced by the structural and strain properties of the ferroelectric BaTiO3 (BTO) substrate, which can be modified by applying external electric fields. X-ray Magnetic Circular Dichroism (XMCD) measurements on Mn L edges with a synchrotron radiation show, in fact two magnetic transitions as a function of temperature that correspond to structural changes of the BTO substrate. We also show that ferromagnetism, absent in the pristine condition at room temperature, can be established by electrically switching the BTO ferroelectric domains in the out-of-plane direction. The present results confirm that electrically induced strain can be exploited to control magnetism in multiferroic oxide heterostructures.

cond-mat.mtrl-sci↗

arXiv2020

Controlling the electrical and magnetic ground states by doping in the complete phase diagram of titanate Eu1-xLaxTiO3 thin films

EuTiO3, a band insulator, and LaTiO3, a Mott insulator, are both antiferromagnetic with transition temperatures ~ 5.5 K and ~ 160 K, respectively. Here, we report the synthesis of Eu1-xLaxTiO3 thin films with x = 0 to 1 by oxide molecular beam epitaxy. The films in the full range have high crystalline quality and show no phase segregation, allowing us carry out transport measurements to study their electrical and magnetic properties. From x = 0.03 to 0.95, Eu1-xLaxTiO3 films show conduction by electrons as charge carriers, with differences in carrier densities and mobilities, contrary to the insulating nature of pure EuTiO3 and LaTiO3. Following a rich phase diagram, the magnetic ground states of the films vary with increasing La-doping level, changing Eu1-xLaxTiO3 from an antiferromagnetic insulator to an antiferromagnetic metal, a ferromagnetic metal, a paramagnetic metal, and back to an antiferromagnetic insulator. These emergent properties reflect the evolutions of the band structure, mainly at the Ti t2g bands near the Fermi level, when Eu2+ are gradually replaced by La3+. This work sheds light on this method for designing the electrical and magnetic properties in strongly-correlated oxides and completes the phase diagram of the titanate Eu1-xLaxTiO3.

cond-mat.str-el↗

arXiv2019

Epitaxial Growth of Perovskite SrBiO$_3$ Film on SrTiO$_3$ by Oxide Molecular Beam Epitaxy

Hole-doped perovskite bismuthates such as Ba$_{1-x}$K$_x$BiO$_3$ and Sr$_{1-x}$K$_x$BiO$_3$ are well-known bismuth-based oxide high-transition-temperature superconductors. Reported thin bismuthate films show relatively low quality, likely due to their large lattice mismatch with the substrate and a low sticking coefficient of Bi at high temperatures. Here, we report the successful epitaxial thin film growth of the parent compound strontium bismuthate SrBiO$_3$ on SrO-terminated SrTiO$_3$ (001) substrates by molecular beam epitaxy. Two different growth methods, high-temperature co-deposition or recrystallization cycles of low-temperature deposition plus high-temperature annealing, are developed to improve the epitaxial growth. SrBiO$_3$ has a pseudocubic lattice constant $\sim$4.25 Å, an $\sim$8.8\% lattice mismatch on SrTiO$_3$ substrate, leading to a large strain in the first few unit cells. Films thicker than 6 unit cells prepared by both methods are fully relaxed to bulk lattice constant and have similar quality. Compared to high-temperature co-deposition, the recrystallization method can produce higher quality 1-6 unit cell films that are coherently or partially strained. Photoemission experiments reveal the bonding and antibonding states close to the Fermi level due to Bi and O hybridization, in good agreement with density functional theory calculations. This work provides general guidance to the synthesis of high-quality perovskite bismuthate films.

cond-mat.supr-con↗

arXiv2016

Constructing oxide interfaces and heterostructures by atomic layer-by-layer laser molecular beam epitaxy

Advancements in nanoscale engineering of oxide interfaces and heterostructures have led to discoveries of emergent phenomena and new artificial materials. Combining the strengths of reactive molecular-beam epitaxy and pulsed-laser deposition, we show here, with examples of Sr1+xTi1-xO3+delta, Ruddlesden-Popper phase Lan+1NinO3n+1 (n = 4), and LaAl1+yO3(1+0.5y)/SrTiO3 interfaces, that atomic layer-by-layer laser molecular-beam epitaxy (ALL-Laser MBE) significantly advances the state of the art in constructing oxide materials with atomic layer precision and control over stoichiometry. With ALL-Laser MBE we have produced conducting LaAlO3/SrTiO3 interfaces at high oxygen pressures that show no evidence of oxygen vacancies, a capability not accessible by existing techniques. The carrier density of the interfacial two-dimensional electron gas thus obtained agrees quantitatively with the electronic reconstruction mechanism.

cond-mat.mes-hall↗

arXiv2016

Surface- and strain-tuning of the optical dielectric function in epitaxially grown CaMnO3

We report a strong thickness dependence of the complex frequency-dependent optical dielectric function in epitaxial CaMnO3(001) thin films on SrTiO3(001), LaAlO3(001), and SrLaAlO4(001) substrates. A doubling of the peak value of the imaginary part of the dielectric function and spectral shifts of 0.5 eV for a given magnitude of absorption are observed. On the basis of the experimental data and first-principles density functional theory calculations of the dielectric function, its evolution with thickness from 4 to 63 nm has several regimes. In the thinnest, strain-coherent films, the response is characterized by a significant contribution from the free surface that dominates strain effects. However, at intermediate and larger thicknesses approaching the bulk-like film, strain coherence and partial strain relaxation persist and in influence the dielectric function.

cond-mat.mtrl-sci↗

arXiv2011

Local Tunneling Magnetoresistance probed by Low-Temperature Scanning Laser Microscopy

Tunneling magnetoresistance (TMR) in a vertical manganite junction was investigated by low-temperature scanning laser microscopy (LTSLM) allowing to determine the local relative magnetization M orientation of the two electrodes as a function of magnitude and orientation of the external magnetic field H. Sweeping the field amplitude at fixed orientation revealed magnetic domain nucleation and propagation in the junction electrodes. For the high-resistance state an almost single-domain antiparallel magnetization configuration was achieved, while in the low-resistance state the junction remained in a multidomain state. Calculated resistance $R_\mathrm{calc}(H)$ based on the local M configuration obtained by LTSLM is in quantitative agreement with R(H) measured by magnetotransport.

cond-mat.mtrl-sci↗

arXiv2011

Improved tunneling magnetoresistance at low temperature in manganite junctions grown by molecular beam epitaxy

We report resistance versus magnetic field measurements for a La0.65Sr0.35MnO3/SrTiO3/La0.65Sr0.35MnO3 tunnel junction grown by molecular-beam epitaxy, that show a large field window of extremely high tunneling magnetoresistance (TMR) at low temperature. Scanning the in-plane applied field orientation through 360^/circ, the TMR shows 4-fold symmetry, i.e. biaxial anisotropy, aligned with the crystalline axes but not the junction geometrical long axis. The TMR reaches ~ 1900% at 4K, corresponding to an interfacial spin polarization of > 95% assuming identical interfaces. These results show that uniaxial anisotropy is not necessary for large TMR, and lay the groundwork for future improvements in TMR in manganite junctions.

cond-mat.mes-hall↗

arXiv2004

Broken particle-hole symmetry at atomically flat a-axis YBa2Cu3O7-d interfaces

We have studied quasiparticle tunneling into atomically flat a-axis films of YBa2Cu3O7-d and DyBa2Cu3O7-d through epitaxial CaTiO3 barriers. The junction heterostructures were grown by oxide molecular beam epitaxy and were carefully optimized using in-situ monitoring techniques, resulting in unprecedented crystalline perfection of the superconductor/insulator interface. Below Tc, the tunneling conductance shows the evolution of a large unexpected asymmetrical feature near zero bias. This is evidence that superconducting YBCO crystals, atomically truncated along the lobe direction with a titanate layer, have intrinsically broken particle-hole symmetry over macroscopically large areas.

cond-mat.supr-con↗