arXiv subjects

C. Finck

Publications and source records attributed to C. Finck.

62 records · Page 4Linked to original sources

arXiv2023

Search for Lepton-Flavor-Violating $τ$ Decays to a Lepton and an Invisible Boson at Belle II

We search for lepton-flavor-violating $τ^-\to e^-α$ and $τ^-\toμ^-α$ decays, where $α$ is an invisible spin-0 boson. The search uses electron-positron collisions at $10.58$ GeV center-of-mass energy with an integrated luminosity of $62.8$ fb$^{-1}$, produced by the SuperKEKB collider and collected with the Belle II detector. We search for an excess in the lepton-energy spectrum of the known $τ^-\to e^-\barν_e ν_τ$ and $τ^-\to μ^-\barν_μν_τ$ decays. We report 95\% confidence-level upper limits on the branching-fraction ratio ${\mathcal B}(τ^-\to e^- α) / {\mathcal B}(τ^- \to e^- \barν_e ν_τ)$ in the range $(1.1-9.7) \times 10^{-3}$ and on ${\mathcal B}(τ^-\to μ^- α) / {\mathcal B}(τ^- \to μ^- \barν_μν_τ)$ in the range $(0.7-12.2) \times 10^{-3}$ for $α$ masses between 0 and 1.6 GeV/c$^2$. These results provide the most stringent bounds on invisible boson production from $τ$ decays.

hep-ex↗

arXiv2023

Novel method for the identification of the production flavor of neutral charmed mesons

We propose a new algorithm for the identification of the production flavor of neutral $D$ mesons in the Belle II experiment. The algorithm exploits the correlation between the flavor of a reconstructed neutral $D$ meson (signal $D$ meson) and the electric charges of particles reconstructed in the rest of the $e^+e^-\to c \bar{c}$ event. These include those originating from the decay of the other charm hadron produced in the event, as well as those possibly produced in association with the signal $D$ meson. We develop the algorithm using simulation and calibrate it in data using decay modes that identify the flavor of the decaying neutral $D$ meson. We use a data sample of $e^+e^-$ collisions, corresponding to $362\,\mathrm{fb}^{-1}$ of integrated luminosity, collected by Belle II at center-of-mass energies near the $Υ(4S)$ mass. The effective tagging efficiency in data is $(47.91 \pm 0.07 \mathrm{(stat)} \pm 0.51 \mathrm{(syst)})\%$, independent of the neutral-$D$-meson decay mode. This charm flavor tagger will approximately double the effective sample size of many $CP$-violation and charm-mixing measurements that so far have exclusively relied on neutral $D$ mesons originating from $D^{*\pm}$ decays. While developed for Belle II, the basic principles underlying the charm flavor tagger can be used in other experiments, including those at hadron colliders.

hep-ex↗

arXiv2022

Measurement of the cluster position resolution of the Belle II Silicon Vertex Detector

The Silicon Vertex Detector (SVD), with its four double-sided silicon strip sensor layers, is one of the two vertex sub-detectors of Belle II operating at SuperKEKB collider (KEK, Japan). Since 2019 and the start of the data taking, the SVD has demonstrated a reliable and highly efficient operation, even running in an environment with harsh beam backgrounds that are induced by the world's highest instantaneous luminosity. In order to provide the best quality track reconstruction with an efficient pattern recognition and track fit, and to correctly propagate the uncertainty on the hit's position to the track parameters, it is crucial to precisely estimate the resolution of the cluster position measurement. Several methods for estimating the position resolution directly from the data will be discussed.

physics.ins-det↗

arXiv2022

The Silicon Vertex Detector of the Belle II Experiment

In 2019 the Belle II experiment started data taking at the asymmetric SuperKEKB collider (KEK, Japan) operating at the Y(4S) resonance. Belle II will search for new physics beyond the Standard Model by collecting an integrated luminosity of 50~ab$^{-1}$. The silicon vertex detector (SVD), consisting of four layers of double-sided silicon strip sensors, is one of the two vertex sub-detectors. The SVD extrapolates the tracks to the inner pixel detector (PXD) with enough precision to correctly identify hits in the PXD belonging to the track. In addition the SVD has standalone tracking capability and utilizes ionization to enhance particle identification in the low momentum region. The SVD is operating reliably and with high efficiency, despite exposure to the harsh beam background of the highest peak-luminosity collider ever built. High signal-to-noise ratio and hit efficiency have been measured, as well as the spatial resolution; all these quantities show excellent stability over time. Data-simulation agreement on cluster properties has recently been improved through a careful tuning of the simulation. The precise hit-time resolution can be exploited to reject out-of-time hits induced by beam background, which will make the SVD more robust against higher levels of background. During the first three years of running, radiation damage effects on strip noise, sensor currents and depletion voltage have been observed, as well as some coupling capacitor failure due to intense radiation bursts. None of these effects cause significant degradation in the detector performance.

physics.ins-det↗

arXiv2022

CMOS pixel sensors optimized for large ionizing dynamic

Monolithic active pixel sensors (MAPS) are now well established as a technology for tracking charged particles, especially when low material budget is desirable. For such applications, sensors focus on spatial resolution and pixels with digital output or modest charge measurement ability are well suited. Within the European Union STRONG-2020 project, which focuses on experiments using hadrons, the TIIMM (Tracking and Ions Identifications with Minimal Material budget) joint research activity intends to expand granular MAPS capacity to energy-loss (ΔE) measurement for ion species identification. The TIIMM prototypes are developed in the Tower Jazz 180 nm CMOS image sensor (CIS) process. The Time-Over-Threshold (ToT) method is applied to the sensor for the energy-loss measurement. The main design details and the preliminary test results from laboratory measurements of the initial TIIMM prototype are presented in this work.

physics.ins-det↗

arXiv2014

Zero degree measurements of 12C fragmentation at 95 MeV/nucleon on thin targets

During therapeutic treatments using ions such as carbon, nuclear interactions between the incident ions and nuclei present in organic tissues may occur, leading to the attenuation of the incident beam intensity and to the production of secondary light charged particles. As the biological dose deposited in the tumor and the surrounding healthy tissues depends on the beam composition, an accurate knowledge of the fragmentation processes is thus essential. In particular, the nuclear interaction models have to be validated using experimental double differential cross sections which are still very scarce. An experiment was realized in 2011 at GANIL to obtain these cross sections for a 95 MeV/nucleon carbon beam on different thin targets for angles raging from 4 to 43° . In order to complete these data, a new experiment was performed on September 2013 at GANIL to measure the fragmentation cross section at zero degree for a 95 MeV/nucleon carbon beam on thin targets. In this work, the experimental setup will be described, the analysis method detailed and the results presented.

nucl-ex↗

arXiv2013

Transverse-energy distributions at midrapidity in $p$$+$$p$, $d$$+$Au, and Au$+$Au collisions at $\sqrt{s_{_{NN}}}=62.4$--200~GeV and implications for particle-production models

Measurements of the midrapidity transverse energy distribution, $d\Et/dη$, are presented for $p$$+$$p$, $d$$+$Au, and Au$+$Au collisions at $\sqrt{s_{_{NN}}}=200$ GeV and additionally for Au$+$Au collisions at $\sqrt{s_{_{NN}}}=62.4$ and 130 GeV. The $d\Et/dη$ distributions are first compared with the number of nucleon participants $N_{\rm part}$, number of binary collisions $N_{\rm coll}$, and number of constituent-quark participants $N_{qp}$ calculated from a Glauber model based on the nuclear geometry. For Au$+$Au, $\mean{d\Et/dη}/N_{\rm part}$ increases with $N_{\rm part}$, while $\mean{d\Et/dη}/N_{qp}$ is approximately constant for all three energies. This indicates that the two component ansatz, $dE_{T}/dη\propto (1-x) N_{\rm part}/2 + x N_{\rm coll}$, which has been used to represent $E_T$ distributions, is simply a proxy for $N_{qp}$, and that the $N_{\rm coll}$ term does not represent a hard-scattering component in $E_T$ distributions. The $dE_{T}/dη$ distributions of Au$+$Au and $d$$+$Au are then calculated from the measured $p$$+$$p$ $E_T$ distribution using two models that both reproduce the Au$+$Au data. However, while the number-of-constituent-quark-participant model agrees well with the $d$$+$Au data, the additive-quark model does not.

nucl-ex↗

arXiv1996

Microscopic Study of Superdeformed Rotational Bands in 151Tb

Structure of eight superdeformed bands in the nucleus 151Tb is analyzed using the results of the Hartree-Fock and Woods-Saxon cranking approaches. It is demonstrated that far going similarities between the two approaches exist and predictions related to the structure of rotational bands calculated within the two models are nearly parallel. An interpretation scenario for the structure of the superdeformed bands is presented and predictions related to the exit spins are made. Small but systematic discrepancies between experiment and theory, analyzed in terms of the dynamical moments, J(2), are shown to exist. The pairing correlations taken into account by using the particle-number-projection technique are shown to increase the disagreement. Sources of these systematic discrepancies are discussed -- they are most likely related to the yet not optimal parametrization of the nuclear interactions used.

nucl-th↗