arXiv subjects

C. Killer

Publications and source records attributed to C. Killer.

6 recordsLinked to original sources

arXiv2025

Impact of magnetic islands on plasma flow and turbulence in W7-X

The effect of magnetic islands on plasma flow and turbulence has been experimentally investigated in the stellarator W7-X. Magnetic configurations with the 5/5 magnetic island positioned at the plasma edge, inside the last closed flux surface, are studied. The main diagnostic used in the present work is a V-band Doppler reflectometer that allows the measurement of the perpendicular plasma flow and density fluctuations with good spatial resolution. A characteristic signature of the 5/5 magnetic island is clearly detected in the perpendicular flow profile. The comparison of the experimental flow and the neoclassically driven $E\times B$ flow indicates that the island contribution to the flow is maximum at the island boundaries and close to zero at the island O-point. Besides, a reduction in the density fluctuation level is found nearby the island O-point. The similarities between these observations and those found in other devices and in gyrokinetic simulations are discussed.

physics.plasm-ph↗

arXiv2024

Gas puff imaging of plasma turbulence in the magnetic island scrape-off layer of W7-X

The turbulence characteristics of the scrape-off-layer (SOL) plasma in the W7-X stellarator are investigated using a gas-puff-imaging (GPI) diagnostic, newly installed and operated during the OP 2.1 campaign. The SOL plasma on W7-X features a set of island divertors for heat and particle exhaust and provides a unique environment for studying SOL turbulence and transport. This paper focuses on the O-point region of the magnetic island divertor SOL in the standard magnetic configuration. Fourier and cross-correlation analyses show that turbulence flows are predominantly in the poloidal direction (i.e., direction tangent to the last closed flux surface) with significantly weaker radial motion. This suggests dominant ExB convection and suppressed filamentary transport compared to those observed in the far scrape-off-layer region of tokamaks, as further supported by high-resolution skewness and kurtosis data that show the absence of intermittent, bursty filamentary events. Additionally, a relationship between the radial profile of the connection length and the sheared poloidal flow structure is reported, suggesting a possible linkage among magnetic topology, turbulence dynamics, and turbulence generation.

physics.plasm-ph↗

arXiv2024

The Realization of a Gas Puff Imaging System on the Wendelstein 7-X Stellarator

A system for studying the spatio-temporal dynamics of fluctuations in the boundary of the W7-X plasma using the Gas-Puff Imaging (GPI) technique has been designed, constructed, installed, and operated. This GPI system addresses a number of challenges specific to long-pulse superconducting devices like W7-X, including the long distance between the plasma and the vacuum vessel wall, the long distance between the plasma and diagnostic ports, the range of last closed flux surface locations for different magnetic configurations in W7-X, and management of heat loads on the system's plasma-facing components. The system features a pair of "converging-diverging" nozzles for partially collimating the gas puffed locally $\approx$135 mm radially outboard of the plasma boundary, a pop-up turning mirror for viewing the gas puff emission from the side (also acting as a shutter for the re-entrant vacuum window), and a high-throughput optical system that collects visible emission resulting from the interaction between the puffed gas and the plasma and directs it along a water-cooled re-entrant tube directly onto the 8 x 16 pixel detector array of the fast camera. The DEGAS 2 neutrals code was used to simulate the H$_\alpha$ (656 nm) and the HeI (587 nm) line emission expected from well-characterized gas-puffs of H$_2$ and He and excited within typical edge plasma profiles in W7-X, thereby predicting line brightnesses used to reduce the risks associated with system sensitivity and placement of the field of view. Operation of GPI on W7-X shows excellent signal to noise ratios (>100) over the field of view for minimally perturbing gas puffs. The GPI system provides detailed measurements of the 2-dimensional (radial and poloidal) dynamics of plasma fluctuations in the W7-X edge, scrape-off layer, and in and around the magnetic islands that make up the island divertor configuration employed on W7-X.

physics.plasm-ph↗

arXiv2022

On the interaction between the island divertor heat fluxes, the scrape-off layer radial electric field and the edge turbulence in Wendelstein 7-X plasmas

The formation of the radial electric field, $E_{\rm r}$ in the SOL has been experimentally studied for attached divertor conditions in stellarator W7-X. The main objective of this study is to test the validity in a complex 3D island divertor of simple models, typically developed in tokamaks, relating $E_{\rm r}$ to the sheath potential drop gradient at the target. Additionally, we investigate the effect of the edge $E_{\rm r}$ shear on the reduction of density fluctuation amplitude, a well-established phenomenon according to the existing bibliography. The main diagnostic for measurements in the SOL is a V-band Doppler reflectometer that can provide the measurement of the $E_{\rm r}$ and density fluctuations with good spatial resolution. Three-dimensional measurements of divertor parameters has been carried out using infrared cameras, with $\lambda_{\rm q}$ resulting a suitable proxy for the model-relevant $\lambda_{\rm T}$. In the investigated attached regimes, it is shown for the first time that the formation of the $E_{\rm r}$ in the SOL depends on parameters at the divertor, following a $E_{\rm r} \propto T_{\rm e} /\lambda_q$ qualitatively similar to that found in a tokamak. Then, from the analyzed plasmas, the observed $E_{\rm r}$ shear at the edge is linked to a moderate local reduction of the amplitude of density fluctuations.

physics.plasm-ph↗

arXiv2020

WeTrace -- A Privacy-preserving Mobile COVID-19 Tracing Approach and Application

For the protection of people and society against harm and health threats -- especially for the COVID-19 pandemic -- a variety of different disciplines needs to be involved. The data collection of very basic and health-related data of individuals in today's highly mobile society does help to plan, protect, and identify next steps health authorities and governments can, shall, or need to plan for or even implement. Thus, every individual, every human, and every inhabitant of the world is the key player -- very different to many past crises'. And since the individual is involved -- all individuals -- his/her (a) health and (b) privacy shall be considered in a very carefully crafted balance, not overruling one aspect with another one or even prioritizing certain aspects. Privacy remains the key. Thus, the solution of the current pandemic's data collection can be based on a fully privacy-preserving application, which can be used by individuals on their mobile devices, such as smartphones, while maintaining at the same time their privacy. Additionally, respective data collected in such a fully distributed setting does help to confine the pandemic and can be achieved in a democratic and very open, but still and especially privacy-protecting world. Therefore, the WeTrace approach and application as described in this paper utilizes the Bluetooth Low Energy (BTE) communication channel, many modern mobile devices offer, where asymmetric cryptography is being applied to allows for the decyphering of a message for that destination it had been intended for. Since literally every other potential participant only listens to random data, even a brute force attack will not succeed. WeTrace and its Open Source implementation is the only known approach so far, which ensures that any receiver of a message knows that this is for him/her, but does not know who the original sender was.

cs.CR↗

arXiv2019

Validating the ASCOT modelling of NBI fast ions in Wendelstein 7-X stellarator

The first fast ion experiments in Wendelstein 7-X were performed in 2018. They are one of the first steps in demonstrating the optimised fast ion confinement of the stellarator. The fast ions were produced with a neutral beam injection (NBI) system and detected with infrared cameras (IR), a fast ion loss detector (FILD), fast ion charge exchange spectroscopy (FIDA), and post-mortem analysis of plasma facing components. The fast ion distribution function in the plasma and at the wall is being modelled with the ASCOT suite of codes. They calculate the ionisation of the injected neutrals and the consecutive slowing down process of the fast ions. The primary output of the code is the multidimensional fast ion distribution function within the plasma and the distribution of particle hit locations and velocities on the wall. Synthetic measurements based on ASCOT output are compared to experimental results to assess the validity of the modelling. This contribution presents an overview of the various fast ion measurements in 2018 and the current modelling status. The validation and data-analysis is on-going, but the wall load IR modelling already yield results that match with the experiments.

physics.plasm-ph↗