arXiv subjects

C. L. Yako

Publications and source records attributed to C. L. Yako.

3 recordsLinked to original sources

arXiv2026

Two Degree-of-Freedom Vibratory Transport in a Grasp

In this paper, we use asymmetric vibrations to demonstrate two degree-of-freedom (DoF) in-hand manipulation of grasped parts. The asymmetric vibrations are achieved through closed-loop position control of a moving surface, which applies a periodic stick-slip waveform to the part to be manipulated. We show analytically how two vibratory waveform parameters, the sticking acceleration and the slipping acceleration, affect average part velocity when moving against gravity. The theoretical trends are then validated using an experimental setup where the squeeze force is controlled and part motion is recorded by a high-resolution encoder. We also develop a 2-DoF vibratory surface capable of translation in one direction and rotation about the surface normal. Using two of these 2-DoF surfaces in a parallel jaw gripper configuration, we bidirectionally translate and rotate a variety of grasped parts, as well as demonstrate that the same waveform trends for translation also persist for in-plane rotation.

cs.RO↗

arXiv2026

Designing Underactuated Graspers with Dynamically Variable Geometry Using Potential Energy Map Based Analysis

This paper introduces an extension to the energy map method for in-hand manipulation. Energy maps are used to predict how a part will evolve in the grasp given a specific actuation input to the gripper. Previous approaches assumed frictionless contacts, but we show analytically that friction can be included in the energy maps when using two-link underactuated fingers by understanding the evolution of the part-finger contact. These friction-based energy maps were used to evaluate the importance of various tendon-pulley gripper parameters across nearly 6 million simulated grasping scenarios. Specifically, a variable palm width is needed to manipulate parts of varying scales, and a variable transmission ratio, or the ratio of the distal to the proximal pulley radii, is needed to draw parts into a cage or to maintain a tip prehension grasp.

cs.RO↗

arXiv2025

Vertical Vibratory Transport of Grasped Parts Using Impacts

In this paper, we use impact-induced acceleration in conjunction with periodic stick-slip to successfully and quickly transport parts vertically against gravity. We show analytically that vertical vibratory transport is more difficult than its horizontal counterpart, and provide guidelines for achieving optimal vertical vibratory transport of a part. Namely, such a system must be capable of quickly realizing high accelerations, as well as supply normal forces at least several times that required for static equilibrium. We also show that for a given maximum acceleration, there is an optimal normal force for transport. To test our analytical guidelines, we built a vibrating surface using flexures and a voice coil actuator that can accelerate a magnetic ram into various materials to generate impacts. The surface was used to transport a part against gravity. Experimentally obtained motion tracking data confirmed the theoretical model. A series of grasping tests with a vibrating-surface equipped parallel jaw gripper confirmed the design guidelines.

cs.RO↗