arXiv subjects

C. S. Menoni

Publications and source records attributed to C. S. Menoni.

3 recordsLinked to original sources

arXiv2026

Intrinsic Defects in Amorphous Optical Coatings of TiO$_2$-doped GeO$_2$ for Gravitational-wave Detectors

The increased laser power of future gravitational-wave detectors will require mirror coatings with optical absorption below 0.1 ppm per mirror. TiO$_2$-doped GeO$_2$, currently the best high-index material for reducing room-temperature coating thermal noise, still exhibits ppm-level absorption even after extrinsic contamination is minimized. Using ab-initio simulations and absorption measurements, we identify oxygen-deficient Ti-rich environments as the origin of this residual absorption. We find that ordinary structural disorder in the amorphous network can localize electronic states but does not produce defects capable of absorbing 1064-nm light. In contrast, oxygen vacancies in compact Ti-rich environments create localized Ti$^{3+}$--Ti$^{3+}$-like polaron-pair or mixed Ti-polaron states states with transitions near 1064 nm. Photothermal measurements show increased absorption after dry/inert annealing, supporting the formation of these reduction-sensitive defects. These results show that the residual absorption is not an intrinsic limitation of TiO$_2$-doped GeO$_2$, but a process-dependent defect that may be mitigated through control of oxygen stoichiometry during deposition and annealing.

cond-mat.mtrl-sci↗

arXiv2026

Atomic Structure of Amorphous Optical Coatings of TiO$_2$-doped GeO$_2$ by Grazing-Incidence Total X-ray Scattering Measurements

Reducing coating thermal noise in future gravitational-wave detectors requires identifying the atomic motifs that control mechanical loss in amorphous optical coatings. We combine grazing-incidence X-ray pair distribution function measurements with atomic-structure modeling to study amorphous TiO$_2$-doped GeO$_2$ films over Ti cation concentrations from $\sim$11 % to $\sim$48 %, before and after annealing. The structural analysis reveals systematic composition- and annealing-dependent changes in short- and intermediate-range order. Increasing Ti content raises the average Ti coordination and promotes edge- and face-sharing polyhedral connections, while Ge remains predominantly fourfold coordinated. Annealing reduces these compact shared-polyhedron motifs and sharpens the first sharp diffraction peak, indicating a more relaxed intermediate-range network. Among the structural descriptors examined, the clearest correlation with the annealing-induced reduction in mechanical loss is the decrease in edge- and face-sharing polyhedra. These results connect composition, annealing, atomic structure, and mechanical dissipation in TiO$_2$-doped GeO$_2$, providing microscopic guidance for optimizing low-noise mirror coatings.

cond-mat.mtrl-sci↗

arXiv2021

Exploration of co-sputtered Ta$_2$O$_5$-ZrO$_2$ thin films for gravitational-wave detectors

We report on the development and extensive characterization of co-sputtered tantala-zirconia thin films, with the goal to decrease coating Brownian noise in present and future gravitational-wave detectors. We tested a variety of sputtering processes of different energies and deposition rates, and we considered the effect of different values of cation ratio $η=$ Zr/(Zr+Ta) and of post-deposition heat treatment temperature $T_a$ on the optical and mechanical properties of the films. Co-sputtered zirconia proved to be an efficient way to frustrate crystallization in tantala thin films, allowing for a substantial increase of the maximum annealing temperature and hence for a decrease of coating mechanical loss. The lowest average coating loss was observed for an ion-beam sputtered sample with $η= 0.485 \pm 0.004$ annealed at 800 $^{\circ}$C, yielding $\overlineφ = 1.8 \times 10^{-4}$. All coating samples showed cracks after annealing. Although in principle our measurements are sensitive to such defects, we found no evidence that our results were affected. The issue could be solved, at least for ion-beam sputtered coatings, by decreasing heating and cooling rates down to 7 $^{\circ}$C/h. While we observed as little optical absorption as in the coatings of current gravitational-wave interferometers (0.5 parts per million), further development will be needed to decrease light scattering and avoid the formation of defects upon annealing.

physics.ins-det↗