arXiv subjects

C. Sasmal

Publications and source records attributed to C. Sasmal.

9 recordsLinked to original sources

arXiv2026

Non-monotonic variations in pressure drop and chaos in viscoelastic fluid flows through an ordered microporous medium

Several recent experimental studies have revealed non-monotonic variations in elastic turbulence-induced chaotic flow behaviour and pressure drop during the flow of viscoelastic fluids through a microporous medium. The present numerical study aims to investigate and hypothesise about the physical mechanisms governing these complex flow behaviours in an ordered microporous medium consisting of cylindrical micropillars arranged in a staggered configuration. We propose that birefringent strands of high elastic stress, generated by the stretching and alignment of polymer molecules within the porous structure, play the dominant role in controlling the non-monotonic variations in chaos and pressure drop. At low Weissenberg numbers, these stress strands develop gradually, mainly downstream of the micropillars, whereas beyond a critical Weissenberg number, they begin to fluctuate strongly, leading to chaotic flow dynamics. However, at even higher Weissenberg numbers, the strands become larger and stronger, eventually interconnecting between neighbouring micropillars, causing the flow to reorganise into a nearly steady, ordered state similar to that observed at low Weissenberg numbers. On the other hand, the pressure drop in the system consists of a mean contribution, obtained from statistically stationary flow quantities, and a fluctuating contribution. While the mean component increases monotonically with the Weissenberg number, the fluctuating component varies non-monotonically, leading to a similar trend in the total pressure drop. Moreover, the non-monotonic chaotic behaviour strongly depends on the solid volume fraction of the porous medium, which alters both the critical Weissenberg number for instability onset and the range over which the non-monotonic behaviour persists.

physics.flu-dyn↗

arXiv2024

The influence of non-Newtonian behaviors of blood on the hemodynamics past a bileaflet mechanical heart valve

This study employs extensive three-dimensional direct numerical simulations (DNS) to investigate the influence of blood non-Newtonian behaviors on the hemodynamics around a bileaflet mechanical heart valve under both steady inflow and physiologically realistic pulsatile flow conditions. Under steady inflow conditions, the study reveals that blood rheology impacts velocity and pressure field variations, as well as the values of clinically important surface and time-averaged parameters like wall shear stress (WSS) and pressure recovery. Notably, this influence is most pronounced at low Reynolds numbers, gradually diminishing as the Reynolds number increases. For instance, surface-averaged WSS values obtained with the non-Newtonian shear-thinning power-law model exceed those obtained with the Newtonian model. At $Re = 750$, this difference reaches around 67\%, reducing to less than 1\% at $Re = 5000$. Correspondingly, pressure recovery downstream of the valve leaflets is lower for the shear-thinning blood than the constant viscosity one, with the difference decreasing as the Reynolds number increases. On the other hand, in pulsatile flow conditions, jets formed between the leaflets and the valve housing wall are shorter than steady inflow conditions. Additionally, surface-averaged wall shear stress and blood damage (BD) parameter values are higher (with differences more than 13\% and 47\%, respectively) during the peak stage of the cardiac cycle, especially for blood exhibiting non-Newtonian yield stress characteristics compared to the shear-thinning or constant viscosity characteristics. Therefore, blood non-Newtonian behaviors, including shear-thinning and yield stress behaviors, exert a considerable influence on the hemodynamics around a mechanical heart valve.

physics.flu-dyn↗

arXiv2023

Thermal convection of viscoelastic fluids in concentric rotating cylinders: Elastic turbulence and kinetic energy budget analysis

The introduction of solid polymers into a Newtonian solvent induces significant modifications in the flow behavior and heat transfer characteristics of resulting viscoelastic fluids. This study performs a comprehensive numerical investigation on thermal convection within a system comprising two concentric horizontal cylinders filled with viscoelastic fluids, with the inner cylinder rotating. The analysis encompasses all three modes of thermal convection, namely, forced, free, and mixed convection, over a range of Weissenberg numbers up to 10 and three values of the Richardson number, namely, 0, 0.143, and $\infty$, representing forced, mixed, and free convection modes of heat transfer, respectively. In forced convection, the flow field remains stable, while in free and mixed convection, an increase in the Weissenberg number leads to a transition from steady to unsteady periodic, quasi-periodic, and finally, an aperiodic and chaotic behavior. This transition arises due to the presence of elastic instability and the subsequent appearance of elastic turbulence in viscoelastic fluids with the increasing Weissenberg number. Furthermore, our findings indicate that fluid viscoelasticity has minimal influence on heat transfer rates in the cases of forced and free convection. Conversely, heat transfer rates in mixed convection increase with the Weissenberg number. We conduct a detailed analysis of the viscoelastic kinetic energy budget to elucidate this enhancement in the heat transfer rate for viscoelastic fluids. We show that this improved heat transfer results from kinetic energy transfer from polymer molecules to the flow field, leading to increased chaotic motion within the system and, eventually, higher heat transfer rates.

physics.flu-dyn↗

arXiv2023

Significant influence of fluid viscoelasticity on flow dynamics past an oscillating cylinder

This study presents a numerical investigation of how fluid viscoelasticity influences the flow dynamics past a transversely forced oscillating cylinder in the laminar vortex shedding regime at a fixed Reynolds number of 100. In particular, we examine how fluid viscoelasticity influences the boundary between the lock-in and no lock-in zones and the associated wake topology compared to that seen in a simple Newtonian fluid. All in all, we find that the fluid viscoelasticity facilitates the synchronization of the vortex street with the cylinder motion at lower oscillation frequencies than that required for a Newtonian fluid. Consequently, the boundary of the lock-in region for a viscoelastic fluid differs from the Newtonian one and broadens in the non-dimensional cylinder oscillation amplitude and frequency plane. Furthermore, we propose that excess strain generated due to the stretching of polymer molecules in a viscoelastic fluid results in a marked difference in the wake structure from that seen in a Newtonian fluid. For a Newtonian fluid, only 2S (two single vortices) and P+S (a pair and a single vortex) vortex shedding modes are detected in the primary synchronization region. However, a 2P(two pairs of vortices) vortex mode is detected for a viscoelastic fluid in this region. We also employ the data-driven dynamic mode decomposition (DMD) reduced order modeling technique to extract and analyze underlying coherent flow structures and their associated frequencies to understand the differences in the flow dynamics of Newtonian and viscoelastic fluids past an oscillating cylinder.

physics.flu-dyn↗

arXiv2023

Applications of elastic instability and elastic turbulence: Review, limitations, and future directions

Viscoelastic fluids are a subclass of complex fluids used in widespread applications ranging from biological to large-scale industrial settings. These fluids are often associated with various complex flow phenomena due to the presence of non-linear elastic stresses, originating due to the stretching and relaxation phenomena of microstructure (such as polymer molecules in the case of a viscoelastic polymer solution) in a deformed flow field. One such phenomenon is elastic instability (EI) which emerges due to the interaction between elastic stresses and streamline curvature present in a flow system at small values of the Renolds number (ratio of the inertial to that of the viscous forces) when the Weissenberg number (ratio of the microstructure relaxation time to that of the rate of flow deformation) exceeds a critical value. On further increasing this Weissenberg number to higher values, the unstable flow field caused due to this elastic instability transits to a more chaotic and turbulent-like flow structure called elastic turbulence (ET). Over the last two decades or so, an extensive investigation has been performed on this particular topic in the complex fluids research community. Some excellent articles recently present this ET phenomenon's development, understanding, and progress in the literature. This article focuses on the application perspectives of this phenomenon. In particular, this article aims to provide a comprehensive review of the investigations conducted so far in the literature to demonstrate the potential of these EI and ET phenomena in three main application areas, namely, microfluidic mixing, microscale heat transfer, and chemically enhanced oil recovery (EOR) process. Additionally, a detailed discussion of the limitations and future directions of these EI and ET phenomena from an application point of view is also presented in this article.

physics.flu-dyn↗

arXiv2022

Strong effect of fluid rheology on electrokinetic instability and subsequent mixing phenomena in a microfluidic T-junction

This study presents a detailed investigation of how the rheological behaviour of fluid could influence the electrokinetic instability (EKI) phenomenon in a microfluidic T-junction. The non-Newtonian power-law model with different values of the power-law index (n) is used to obtain fluids of different rheological behaviours. We find that as the fluid rheological behaviour changes from shear-thickening (n > 1) to shear-thinning (n < 1) via the Newtonian (n = 1) one, the EKI phenomenon is significantly influenced under the same conditions. In particular, the intensity of this EKI phenomenon is found to be significantly higher in shear-thinning fluids than in Newtonian and shear-thickening fluids. As a result, the corresponding mixing phenomenon, often achieved using this EKI phenomenon, is also notably enhanced in shear-thinning fluids compared to that achieved in Newtonian and shear-thickening fluids. A detailed analysis of both the flow dynamics and mixing phenomena in terms of streamlines, velocity fluctuations, concentration field, mixing efficiency, etc., is presented and discussed in this study. We also employ the data-driven dynamic mode decomposition (DMD) technique to analyze the flow field in more detail. In particular, the information on the coherent flow structures obtained with different values of the power-law index facilitates the understanding of both the EKI-induced chaotic convection and mixing phenomena in a better way; for instance, why the mixing efficiency is higher in shear-thinning fluids than that in Newtonian and shear-thickening fluids. Moreover, we observe that the spatial expanse and intensity of these coherent structures differ significantly as the power-law index changes, thereby providing valuable insights into certain aspects of the underlying flow dynamics that otherwise are not clearly apparent from other analyses.

physics.flu-dyn↗

arXiv2022

Fluid viscoelasticity suppresses chaotic convection and mixing due to electrokinetic instability

When two fluids of different electrical conductivities are transported side by side in a microfluidic device under the influence of an electric field, an electrokinetic instability (EKI) is often generated after some critical values of the applied electric field strength and conductivity ratio. Many prior experimental and numerical studies show that this phenomenon results in a chaotic flow field inside a microdevice, thereby facilitating the mixing of two fluids if they are Newtonian in behaviour. However, the present numerical study shows that this chaotic convection arising due to the electrokinetic instability can be suppressed if the fluids are viscoelastic instead of Newtonian ones. In particular, we observe that as the Weissenberg number (ratio of the elastic to that of the viscous forces) gradually increases and the polymer viscosity ratio (ratio of the solvent viscosity to that of the zero-shear rate viscosity of the polymeric solution) gradually decreases, the chaotic fluctuation inside a T microfluidic junction decreases within the present range of conditions encompassed in this study. We demonstrate that this suppression of the chaotic motion occurs due to the formation of a strand of high elastic stresses at the interface of the two fluids. We further show that this suppression of the chaotic fluctuation (particularly the span-wise one) inhibits the mixing of two viscoelastic fluids. Therefore, one needs to be cautious when the EKI phenomenon is planned to use to mix such viscoelastic fluids. Our observations are in line with that seen in limited experimental studies conducted for these kinds of viscoelastic fluids.

physics.flu-dyn↗

arXiv2021

Effect of geometric disorder on chaotic viscoelastic porous media flows

The flow of viscoelastic fluids in porous media is encountered in many practical applications, such as in the enhanced oil recovery process or in the groundwater remediation. Once the flow rate exceeds a critical value in such flows, an elastic instability with fluctuating flow field is observed, which ultimately transits to a more chaotic and turbulence-like flow structure as the flow rate further increases. In a recent study, it has been experimentally shown that this chaotic flow behaviour of viscoelastic fluids can be suppressed by increasing the geometric disorder in a model porous media consisting of a microchannel with several micropillars placed in it. However, the present numerical study demonstrates that this is not always true. We show that it depends on the initial arrangement of the micropillars for mimicking the porous media. In particular, we find that for an initial ordered and aligned configuration of the micropillars, the introduction of geometric order actually increases the chaotic flow dynamics as opposed to that seen for an initial ordered and staggered configuration of the micropillars. We suggest that this chaotic flow behaviour actually depends on the number of the stagnation points revealed to the flow field where maximum stretching of the viscoelastic microstructure happens. Our findings and explanation are perfectly in line with that observed and provided in a more recent experimental study.

physics.flu-dyn↗

arXiv2021

Elastic instabilities and bifurcations in flows of wormlike micellar solutions past single and two vertically aligned microcylinders: Effect of blockage and gap ratios

This study presents an extensive numerical investigation on the flow characteristics of wormlike micellar solutions past a single and vertically aligned two microcylinders placed in a microchannel in the creeping flow regime on the two-species Vasquez-Cook-McKinley (VCM) constitutive model, which takes into account both the breakage and reformation dynamics of micelles. For the case of single microcylinder, as the blockage ratio (ratio of the cylinder diameter to that of the channel height) is gradually varied, we find the existence of a flow bifurcation in the system, and also flow transits from steady to unsteady state. For the case of two microcylinders, we observe the presence of three distinct flow states in the system, namely, diverging (D), asymmetric-diverging (AD) and converging (C) states as the intercylinder spacing in between the two cylinders is varied. Similar types of flow states are also observed in the recent experiments dealing with wormlike micellar solutions. However, we show that either this transition from one flow state to another in the case of a single microcylinder or the occurrence of any flow state in the case of two microcylinders, is strongly dependent upon the values of the Weissenberg number and the nonlinear VCM model parameter \xi, which basically indicates how easy or hard to break a micelle. Based on the results and discussion presented herein for the single and two microcylinders, we ultimately provide the explanation for the formation of preferential paths or lanes during the flow of viscoelastic fluids through a porous media, which was seen in many prior experiments in the creeping flow regime.

physics.flu-dyn↗