arXiv subjects

C. Yang

Publications and source records attributed to C. Yang.

At least 91 records · Page 5Linked to original sources

arXiv2012

Cryogenic Optomechanics with a Si3N4 Membrane and Classical Laser Noise

We demonstrate a cryogenic optomechanical system comprising a flexible Si3N4 membrane placed at the center of a free-space optical cavity in a 400 mK cryogenic environment. We observe a mechanical quality factor Q > 4 x 10^6 for the 261-kHz fundamental drum-head mode of the membrane, and a cavity resonance halfwidth of 60 kHz. The optomechanical system therefore operates in the resolved sideband limit. We monitor the membrane's thermal motion using a heterodyne optical circuit capable of simultaneously measuring both of the mechanical sidebands, and find that the observed optical spring and damping quantitatively agree with theory. The mechanical sidebands exhibit a Fano lineshape, and to explain this we develop a theory describing heterodyne measurements in the presence of correlated classical laser noise. Finally, we discuss the use of a passive filter cavity to remove classical laser noise, and consider the future requirements for laser cooling this relatively large and low-frequency mechanical element to very near its quantum mechanical ground state.

physics.optics↗

arXiv2012

Distributed Dynamic Inter-Cell Interference Management for Femtocell Networks Using Over-the-Air Single-Tone Signaling

Femtocell networks are promising for not only improving the coverage but also increasing the capacity of current cellular networks. The interference-limited reality in femtocell networks makes interference management (IM) the key to maintaining the quality of service and fairness in femtocell networks. Over-the-air signaling is one of the most effective means for fast distributed dynamic IM. However, the design of this type of signal is challenging. In this paper, we address the challenges and propose an effective solution, referred to as single-tone signaling (STS). The proposed STS scheme possesses many highly desirable properties, such as no dedicated resource requirement (no system overhead), no near-far effect, no inter-signal interference, and immunity to synchronization error. In addition, the proposed STS signal provides a means for high quality wideband channel estimation for the use of coordinated techniques, such as coordinated beamforming. Based on the proposed STS, two distributed dynamic IM schemes, ON/OFF power control and SLNR (signal-to-leakage-plus-noise-ratio)-based transmitter beam coordination, are proposed. Simulation results show significant performance improvement as a result of the use of STS-based IM schemes.

cs.IT↗

arXiv2011

Coded Single-Tone Signaling and Its Application to Resource Coordination and Interference Management in Femtocell Networks

Resource coordination and interference management is the key to achieving the benefits of femtocell networks. Over-the-air signaling is one of the most effective means for distributed dynamic resource coordination and interference management. However, the design of this type of signal is challenging. In this paper, we address the challenges and propose an effective solution, referred to as coded single-tone signaling (STS). The proposed coded STS scheme possesses certain highly desirable properties, such as no dedicated resource requirement (no overhead), no near-and-far effect, no inter-signal interference (no multi-user interference), low peak-to-average power ratio (deep coverage). In addition, the proposed coded STS can fully exploit frequency diversity and provides a means for high quality wideband channel estimation. The coded STS design is demonstrated through a concrete numerical example. Performance of the proposed coded STS and its effect on cochannel traffic channels are evaluated through simulations.

cs.IT↗

arXiv2011

Iterative Algorithms for Ptychographic Phase Retrieval

Ptychography promises diffraction limited resolution without the need for high resolution lenses. To achieve high resolution one has to solve the phase problem for many partially overlapping frames. Here we review some of the existing methods for solving ptychographic phase retrieval problem from a numerical analysis point of view, and propose alternative methods based on numerical optimization.

physics.optics↗

arXiv2010

Compressive auto-indexing in femtosecond nanocrystallography

Ultrafast nanocrystallography has the potential to revolutionize biology by enabling structural elucidation of proteins for which it is possible to grow crystals with 10 or fewer unit cells on the side. The success of nanocrystallography depends on robust orientation-determination procedures that allow us to average diffraction data from multiple nanocrystals to produce a three dimensional (3D) diffraction data volume with a high signal-to-noise ratio. Such a 3D diffraction volume can then be phased using standard crystallographic techniques. "Indexing" algorithms used in crystallography enable orientation determination of diffraction data from a single crystal when a relatively large number of reflections are recorded. Here we show that it is possible to obtain the exact lattice geometry from a smaller number of measurements than standard approaches using a basis pursuit solver.

physics.optics↗

arXiv2010

Compressive Phase Contrast Tomography

When x-rays penetrate soft matter, their phase changes more rapidly than their amplitude. In- terference effects visible with high brightness sources creates higher contrast, edge enhanced images. When the object is piecewise smooth (made of big blocks of a few components), such higher con- trast datasets have a sparse solution. We apply basis pursuit solvers to improve SNR, remove ring artifacts, reduce the number of views and radiation dose from phase contrast datasets collected at the Hard X-Ray Micro Tomography Beamline at the Advanced Light Source. We report a GPU code for the most computationally intensive task, the gridding and inverse gridding algorithm (non uniform sampled Fourier transform).

physics.optics↗

arXiv2010

MIMO Precoding Using Rotating Codebooks

Next generation wireless communications rely on multiple input multiple output (MIMO) techniques to achieve high data rates. Feedback of channel information can be used in MIMO precoding to fully activate the strongest channel modes and improve MIMO performance. Unfortunately, the bandwidth of the control channel via which the feedback is conveyed is severely limited. An important issue is how to improve the MIMO precoding performance with minimal feedback. In this letter, we present a method that uses a rotating codebook technique to effectively improve the precoding performance without the need of increasing feedback overhead. The basic idea of the rotating codebook precoding is to expend the effective precoding codebook size via rotating multiple codebooks so that the number of feedback bits remains unchanged. Simulation results are presented to show the performance gain of the proposed rotating codebook precoding over the conventional precoding.

cs.IT↗

arXiv2010

Drain current modulation in a nanoscale field-effect-transistor channel by single dopant implantation

We demonstrate single dopant implantation into the channel of a silicon nanoscale metal-oxide-semiconductor field-effect-transistor. This is achieved by monitoring the drain current modulation during ion irradiation. Deterministic doping is crucial for overcoming dopant number variability in present nanoscale devices and for exploiting single atom degrees of freedom. The two main ion stopping processes that induce drain current modulation are examined. We employ 500~keV He ions, in which electronic stopping is dominant, leading to discrete increases in drain current and 14~keV P dopants for which nuclear stopping is dominant leading to discrete decreases in drain current.

cond-mat.mtrl-sci↗

arXiv2010

Observability of radiation pressure shot noise in optomechanical systems

We present a theoretical study of an experiment designed to detect radiation pressure shot noise in an optomechanical system. Our model consists of a coherently driven optical cavity mode that is coupled to a mechanical oscillator. We examine the cross-correlation between two quadratures of the output field from the cavity. We determine under which circumstances radiation pressure shot noise can be detected by a measurement of this cross-correlation. This is done in the general case of nonzero detuning between the frequency of the drive and the cavity resonance frequency. We study the qualitative features of the different contributions to the cross-correlator and provide quantitative figures of merit for the relative importance of the radiation pressure shot noise contribution to other contributions. We also propose a modified setup of this experiment relevant to the "membrane-in-the-middle" geometry, which potentially can avoid the problems of static bistability and classical noise in the drive.

cond-mat.mes-hall↗

arXiv2009

Hamiltonian light-front field theory in a basis function approach

Hamiltonian light-front quantum field theory constitutes a framework for the non-perturbative solution of invariant masses and correlated parton amplitudes of self-bound systems. By choosing the light-front gauge and adopting a basis function representation, we obtain a large, sparse, Hamiltonian matrix for mass eigenstates of gauge theories that is solvable by adapting the ab initio no-core methods of nuclear many-body theory. Full covariance is recovered in the continuum limit, the infinite matrix limit. There is considerable freedom in the choice of the orthonormal and complete set of basis functions with convenience and convergence rates providing key considerations. Here, we use a two-dimensional harmonic oscillator basis for transverse modes that corresponds with eigensolutions of the soft-wall AdS/QCD model obtained from light-front holography. We outline our approach and present illustrative features of some non-interacting systems in a cavity. We illustrate the first steps towards solving QED by obtaining the mass eigenstates of an electron in a cavity in small basis spaces and discuss the computational challenges.

nucl-th↗

arXiv2009

Hamiltonian light-front field theory within an AdS/QCD basis

Non-perturbative Hamiltonian light-front quantum field theory presents opportunities and challenges that bridge particle physics and nuclear physics. Fundamental theories, such as Quantum Chromodynmamics (QCD) and Quantum Electrodynamics (QED) offer the promise of great predictive power spanning phenomena on all scales from the microscopic to cosmic scales, but new tools that do not rely exclusively on perturbation theory are required to make connection from one scale to the next. We outline recent theoretical and computational progress to build these bridges and provide illustrative results for nuclear structure and quantum field theory. As our framework we choose light-front gauge and a basis function representation with two-dimensional harmonic oscillator basis for transverse modes that corresponds with eigensolutions of the soft-wall AdS/QCD model obtained from light-front holography.

nucl-th↗

arXiv2009

Probe and Control of the Reservoir Density of States in Single-Electron Devices

We present a systematic study of quasi-one-dimensional density of states (DOS) in electron accumulation layers near a Si-SiO2 interface. In the experiments we have employed two conceptually different objects to probe DOS, namely, a phosphorus donor and a quantum dot, both operating in the single-electron tunneling regime. We demonstrate how the peaks in DOS can be moved in the transport window independently of the other device properties, and in agreement with the theoretical analysis. This method introduces a fast and convenient way of identifying excited states in these emerging nanostructures.

cond-mat.mes-hall↗

arXiv2008

Recent progress in Hamiltonian light-front QCD

nucl-th↗

arXiv2008

A constitutive model for unsaturated cemented soils under cyclic loading

On the basis of plastic bounding surface model, the damage theory for structured soils and unsaturated soil mechanics, an elastoplastic model for unsaturated loessic soils under cyclic loading has been elaborated. Firstly, the description of bond degradation in a damage framework is given, linking the damage of soil's structure to the accumulated strain. The Barcelona Basic Model (BBM) was considered for the suction effects. The elastoplastic model is then integrated into a bounding surface plasticity framework in order to model strain accumulation along cyclic loading, even under small stress levels. The validation of the proposed model is conducted by comparing its predictions with the experimental results from multi-level cyclic triaxial tests performed on a natural loess sampled beside the Northern French railway for high speed train and about 140 km far from Paris. The comparisons show the capabilities of the model to describe the behaviour of unsaturated cemented soils under cyclic loading.

physics.class-ph↗

arXiv2008

Experimental Interpretation of Interfacial Separation and Squeezing Pressure

The logarithmic relation between interfacial separation and squeezing pressure between randomly rough surfaces, has been predicted by both theory and experiment. However, the experimental slope between interfacial separation and logarithmic squeezing pressure, is slightly bigger than that predicted by theory. Here we present a detailed explanation on the slope difference between theory and experiment.

cond-mat.soft↗

arXiv2008

Contact mechanics with adhesion: Interfacial separation and contact area

We study the adhesive contact between elastic solids with randomly rough, self affine fractal surfaces. We present molecular dynamics (MD) simulation results for the interfacial stress distribution and the wall-wall separation. We compare the MD results for the relative contact area and the average interfacial separation, with the prediction of the contact mechanics theory of Persson. We find good agreement between theory and the simulation results. We apply the theory to the system studied by Benz et al. involving polymer in contact with polymer, but in this case the adhesion gives only a small modification of the interfacial separation as a function of the squeezing pressure.

cond-mat.soft↗

arXiv2008

Dispersive optomechanics: a membrane inside a cavity

We present the results of theoretical and experimental studies of dispersively coupled (or "membrane in the middle") optomechanical systems. We calculate the linear optical properties of a high finesse cavity containing a thin dielectric membrane. We focus on the cavity's transmission, reflection, and finesse as a function of the membrane's position along the cavity axis and as a function of its optical loss. We compare these calculations with measurements and find excellent agreement in cavities with empty-cavity finesses in the range 10^4 to 10^5. The imaginary part of the membrane's index of refraction is found to be approximately 10^(-4). We calculate the laser cooling performance of this system, with a particular focus on the less-intuitive regime in which photons "tunnel" through the membrane on a time scale comparable to the membrane's period of oscillation. Lastly, we present calculations of quantum non-demolition measurements of the membrane's phonon number in the low signal-to-noise regime where the phonon lifetime is comparable to the QND readout time.

quant-ph↗

arXiv2008

Nanodroplets on rough hydrophilic and hydrophobic surfaces

We present results of Molecular Dynamics (MD) calculations on the behavior of liquid nanodroplets on rough hydrophobic and hydrophilic solid surfaces. On hydrophobic surfaces, the contact angle for nanodroplets depends strongly on the root mean square roughness amplitude, but it is nearly independent of the fractal dimension of the surface. Since increasing the fractal dimension increases the short-wavelength roughness, while the long-wavelength roughness is almost unchanged, we conclude that for hydrophobic interactions the short-wavelength (atomistic) roughness is not very important. We show that the nanodroplet is in a Cassie-like state. For rough hydrophobic surfaces, there is no contact angle hysteresis due to strong thermal fluctuations, which occur at the liquid-solid interface on the nanoscale. On hydrophilic surfaces, however, there is strong contact angle hysteresis due to higher energy barrier. These findings may be very important for the development of artificially biomimetic superhydrophobic surfaces.

cond-mat.soft↗