arXiv subjects

Can Emre Koksal

Publications and source records attributed to Can Emre Koksal.

9 recordsLinked to original sources

arXiv2026

A Theory of Probabilistic Power Provisioning for Data Centers with Distributed Energy Storage

The growing power demands and variability of AI workloads make electrical power delivery a critical constraint in data-center operation. Distributed energy storage can reduce the power capacity required to support stochastic loads, but its benefits depend fundamentally on the statistics and time scales of demand. This paper develops a probabilistic framework that jointly characterizes provisioned power, energy-storage capacity, and the probability of overdraw. We show that storage-assisted provisioning separates into two operating regimes. In the Small Battery Region, overdraw is dominated by short-lived demand excursions and storage provides nearly linear reductions in the required power margin. In the Large Battery Region, overdraw results from sustained demand fluctuations over longer spans of time, and the required margin exhibits diminishing returns with storage. For this regime we introduce effective power, an analogue of effective bandwidth that captures the temporal statistics of the demand and gives an asymptotically tight characterization of the required power. We further quantify how temporal correlation and spatial aggregation affect storage requirements and statistical multiplexing gains, and extend the analysis to loads with multiple demand time scales. Finally, we evaluate the framework using power-demand traces from three production data centers spanning HPC, GPU-training, and cloud-service workloads. Despite their heterogeneous, cyclo-stationary and multi-modal behavior, the measured workloads exhibit the predicted regimes, and a simple four-parameter two-state model captures the dynamics governing their storage-power tradeoffs. The resulting framework provides both a probabilistic foundation and practical dimensioning principles for storage-assisted power provisioning in next-generation AI data centers.

cs.IT↗

arXiv2023

Continuous Beam Alignment for Mobile MIMO

Millimeter-wave transceivers use large antenna arrays to form narrow high-directional beams and overcome severe attenuation. Narrow beams require large signaling overhead to be aligned if no prior information about beam directions is available. Moreover, beams drift with time due to user mobility and may need to be realigned. Beam tracking is commonly used to keep the beams tightly coupled and eliminate the overhead associated with realignment. Hence, with periodic measurements, beams are adjusted before they lose alignment. We propose a model where the receiver adjusts beam direction "continuously" over each physical-layer sample according to a carefully calculated estimate of the continuous variation of the beams. In our approach, the change of direction is updated using the rate variation prediction of beam angles via three different solutions. Our approach incurs no additional overhead in pilots, yet, the performance of beam tracking is improved significantly. Numerical results reveal an SNR enhancement associated with reducing the MSE of the beam directions. In addition, our approach reduces the pilot overhead by 60% and up to 87% while achieving a similar total tracking duration as the state-of-the-art.

eess.SP↗

arXiv2023

Road State Inference via Channel State Information

A wide variety of sensor technologies are recently being adopted for traffic monitoring applications. Since most of these technologies rely on wired infrastructure, the installation and maintenance costs limit the deployment of the traffic monitoring systems. In this paper, we introduce a traffic monitoring approach that exploits physical layer samples in vehicular communications processed by machine learning techniques. We verify the feasibility of our approach with extensive simulations and real-world experiments. First, we simulate wireless channels under realistic traffic conditions using a ray-tracing simulator and a traffic simulator. Next, we conduct experiments in a real-world environment and collect messages transmitted from a roadside unit (RSU). The results show that we are able to predict different levels of service with an accuracy above 80% both on the simulation and experimental data. Further, the proposed approach is capable of estimating the number of vehicles with a low mean absolute error on both data. Our approach is suitable to be deployed alongside the current monitoring systems. It doesn't require additional investment in infrastructure since it relies on existing vehicular networks.

cs.NI↗

arXiv2017

Finite Horizon Energy-Efficient Scheduling with Energy Harvesting Transmitters over Fading Channels

In this paper, energy-efficient transmission schemes achieving maximal throughput over a finite time interval are studied in a problem setting including energy harvests, data arrivals and channel variation. The goal is to express the offline optimal policy in a way that facilitates a good online solution. We express any throughput maximizing energy efficient offline schedule (EE-TM-OFF) explicitly in terms of water levels. This allows per-slot real-time evaluation of transmit power and rate decisions, using estimates of the associated offline water levels. To compute the online power level, we construct a stochastic dynamic program that incorporates the offline optimal solution as a stochastic process. We introduce the "Immediate Fill" metric which provides a lower bound on the efficiency of any online policy with respect to the corresponding optimal offline solution. The online algorithms obtained this way exhibit performance close to the offline optimal, not only in the long run but also in short problem horizons, deeming them suitable for practical implementations.

cs.IT↗

arXiv2016

Low-Delay Distributed Source Coding for Time-Varying Sources with Unknown Statistics

We consider a system in which two nodes take correlated measurements of a random source with time-varying and unknown statistics. The observations of the source at the first node are to be losslessly replicated with a given probability of outage at the second node, which receives data from the first node over a constant-rate errorless channel. We develop a system and associated strategies for joint distributed source coding (encoding and decoding) and transmission control in order to achieve low end-to-end delay. Slepian-Wolf coding in its traditional form cannot be applied in our scenario, since the encoder requires the joint statistics of the observations and the associated decoding delay is very high. We analytically evaluate the performance of our strategies and show that the delay achieved by them are order optimal, as the conditional entropy of the source approaches to the channel rate. We also evaluate the performance of our algorithms based on real-world experiments using two cameras recording videos of a scene at different angles. Having realized our schemes, we demonstrated that, even with a very low-complexity quantizer, a compression ratio of approximately 50% is achievable for lossless replication at the decoder, at an average delay of a few seconds.

cs.IT↗

arXiv2016

Checks and Balances: A Low-complexity High-gain Uplink Power Controller for CoMP

Coordinated Multipoint (CoMP) promised substantial throughput gain for next-generation cellular systems. However, realizing this gain is costly in terms of pilots and backhaul bandwidth, and may require substantial modifications in physicallayer hardware. Targeting efficient throughput gain, we develop a novel coordinated power control scheme for uplink cellular networks called Checks and Balances (C&B), which checks the received signal strength of one user and its generated interference to neighboring base stations, and balances the two. C&B has some highly attractive advantages: C&B (i) can be implemented easily in software, (ii) does not require to upgrade non-CoMP physicallayer hardware, (iii) allows for fully distributed implementation for each user equipment (UE), and (iv) does not need extra pilots or backhaul communications. We evaluate the throughput performance of C&B on an uplink LTE system-level simulation platform, which is carefully calibrated with Huawei. Our simulation results show that C&B achieves much better throughput performance, compared to several widely-used power control schemes.

eess.SY↗

arXiv2012

Basic Performance Limits and Tradeoffs in Energy Harvesting Sensor Nodes with Finite Data and Energy Storage

As many sensor network applications require deployment in remote and hard-to-reach areas, it is critical to ensure that such networks are capable of operating unattended for long durations. Consequently, the concept of using nodes with energy replenishment capabilities has been gaining popularity. However, new techniques and protocols must be developed to maximize the performance of sensor networks with energy replenishment. Here, we analyze limits of the performance of sensor nodes with limited energy, being replenished at a variable rate. We provide a simple localized energy management scheme that achieves a performance close to that with an unlimited energy source, and at the same time keeps the probability of complete battery discharge low. Based on the insights developed, we address the problem of energy management for energy-replenishing nodes with finite battery and finite data buffer capacities. To this end, we give an energy management scheme that achieves the optimal utility asymptotically while keeping both the battery discharge and data loss probabilities low.

cs.NI↗

arXiv2012

On the Design of Large Scale Wireless Systems (with detailed proofs)

In this paper, we consider the downlink of large OFDMA-based networks and study their performance bounds as a function of the number of - transmitters $B$, users $K$, and resource-blocks $N$. Here, a resource block is a collection of subcarriers such that all such collections, that are disjoint have associated independently fading channels. In particular, we analyze the expected achievable sum-rate as a function of above variables and derive novel upper and lower bounds for a general spatial geometry of transmitters, a truncated path-loss model, and a variety of fading models. We establish the associated scaling laws for dense and extended networks, and propose design guidelines for the regulators to guarantee various QoS constraints and, at the same time, maximize revenue for the service providers. Thereafter, we develop a distributed resource allocation scheme that achieves the same sum-rate scaling as that of the proposed upper bound for a wide range of $K, B, N$. Based on it, we compare low-powered peer-to-peer networks to high-powered single-transmitter networks and give an additional design principle. Finally, we also show how our results can be extended to the scenario where each of the $B$ transmitters have $M (>1)$ co-located antennas.

cs.IT↗

arXiv2010

Energy Optimal Transmission Scheduling in Wireless Sensor Networks

One of the main issues in the design of sensor networks is energy efficient communication of time-critical data. Energy wastage can be caused by failed packet transmission attempts at each node due to channel dynamics and interference. Therefore transmission control techniques that are unaware of the channel dynamics can lead to suboptimal channel use patterns. In this paper we propose a transmission controller that utilizes different "grades" of channel side information to schedule packet transmissions in an optimal way, while meeting a deadline constraint for all packets waiting in the transmission queue. The wireless channel is modeled as a finite-state Markov channel. We are specifically interested in the case where the transmitter has low-grade channel side information that can be obtained based solely on the ACK/NAK sequence for the previous transmissions. Our scheduler is readily implementable and it is based on the dynamic programming solution to the finite-horizon transmission control problem. We also calculate the information theoretic capacity of the finite state Markov channel with feedback containing different grades of channel side information including that, obtained through the ACK/NAK sequence. We illustrate that our scheduler achieves a given throughput at a power level that is fairly close to the fundamental limit achievable over the channel.

cs.NI↗